Question about 1995 GMC Sierra

Open Question

Where do I find the flasher control module on a 2002 GMC Envoy?

I need to replace the flasher control module on my 2002 GMC Envoy as the right trailer brake light no longer works; however, the right trailer turn signal work fine.

I was told it is under the dash on the driver side.

Posted by on

  • kc8uqp May 11, 2010

    does the 4 way flasher work both sides if it does it most likely is the turn switch under steering wheel flashers will not fail on one side

×

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 50 Answers

SOURCE: gmc sierra turn flasher location

The flasher on this vehicle looks nothing like the flasher's of yesteryear. It will be located behind the drivers side knee bolster(under the steering wheel). It will be a small black box that is about 3 inches wide, 2 inches deep, and 1 inch thick. It may be somewhat difficult to locate because on some of the GM trucks they actually hide it behind the guage cluster bezel but to the left of the guages. Let me know if I can help you any further.

Posted on Aug 21, 2008

emissionwiz
  • 75817 Answers

SOURCE: 1997 sonoma turn signal flasher

it is inside, under dash, on left side is a plastic sound protector, mine had 3 screws holding it up, drop this down and straight in you will see a 1" round thing - this is the flasher, pull it out and replace with new one (there are two flat prongs that plug in). It appears this is a well guarded secret!

Posted on Aug 26, 2008

  • 9 Answers

SOURCE: 2002 gmc envoy slt 4x4

Had the same concern. Had to take mine to the dealership and have them replace the system. Be careful when you change between the drives. Vehicle MUST be in park, of course started, and you can change the drive. WAIT until the light completely stops blinking before placing into gear or trying to change to another setting. When you change the setting, a gear arm raises or lowers, and resets. Listen and you can hear it. Often when the vehicle has sat for a while, or if the battery has been disconnected, you will hear it resetting. If this does not work, you have to take it into the shop to have the gear sensor repalced.

Posted on Dec 01, 2008

farroutideas
  • 78 Answers

SOURCE: wiring diagram or fuse box diagram-2007 GMC Envoy Denali

Hi there;

Here is the wiring diagram for the trailer wiring for your truck.
22593cd.jpg
Hope this helps
Farrout!

Posted on Mar 18, 2009

  • 104 Answers

SOURCE: Need firing order diagram for 2002 gmc envoy

one, five, three, six, two, four

The plastic intake should have this sequence molded into it somewhere, and even the corresponding cylinder numbers in front of their respective holes. Have fun, and thanks for posting on Fixya.com

Posted on Mar 20, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2004 ENVOY WHERE IS MODULE RESISTOR


2002 - 2009 GM BLOWER MOTOR RESISTOR - YouTube

? 4:17
https://www.youtube.com/watch?v=WWi-_-kY-dM
Sep 5, 2012 - Uploaded by davesgarage512
I have a 2003 GMC Envoy and my issue is when I shut the blower off it still ... Can this issue also be remedied ...

2004 GMC ENVOY Blower Motor Control Module / Resistor



Nov 28, 2015 | 2004 GMC Envoy SLT

1 Answer

How do i get to my hazard switch in my 02 gmc envoy ..a vid would be really hepfull


Are you sure that is what you need to replace ? Do the turn signals work ? May be the turn signal hazard flasher module is bad ! How To Install Turn Signal Wiper Cruise Control Switch 2002 09 GMC Envoy...

Mar 23, 2015 | 2002 GMC Envoy

1 Answer

2002 GMC Envoy shuts off when air or heat turned on


The automatic idle control module is bad.

May 02, 2014 | 2002 GMC Envoy

1 Answer

2003 Yukon XL Denali Trailer Light Problems


Lighting control module ? ?????? Hazard / flasher module ! Now ( there''s not even an electrical signal where the fuse plugs into the interior fuse panel.) What FUSE ??????

Stop Lamps
The STOP LP 25 A fuse in the underhood fuse block supplies battery positive voltage to the normally open stop lamp switch. When the driver presses the brake pedal, the switch contacts close and battery positive voltage is supplied to both the STOP 15 A fuse and the CHMSL 10 A fuse in the I/P fuse block, and to the turn signal/hazard module. The turn signal/hazard module then supplies voltage to both of the trailer rear turn/stop lamp supply voltage circuits. The voltage from the CHMSL 10 A fuse is to the center high mounted stop lamp (CHMSL) and the trailer jumper harness. The voltage from the STOP 15 A fuse is to the stop lamps, throttle actuator control (TAC) module, and the cruise control.
Backup Lamps
The backup lamp request signal is sent from the powertrain control module (PCM) to the body control module (BCM) on the Class 2 message system. This signal is based on the park neutral position (PNP) switch signal. The BCM supplies voltage on the backup lamp supply voltage circuit to the backup lamps and to the automatic day/night mirror. Voltage for the courtesy lamp supply voltage circuit and backup lamp supply voltage circuit is from the TBC B fuse in the instrument panel fuse block directly through the BCM to these circuits. A short to ground on either of these circuits will open the fuse. The backup lamps are grounded at G401.
For trailer wiring, a separate backup lamp circuit is connected through the underhood fuse block from the TRLR B/U 10 A fuse to the trailer wiring harness.
Turn Signal/Hazard Lamps
The IGN E 10 A fuse in the underhood fuse block supplies battery positive voltage to the turn signal/hazard switch assembly. The FLASH 25 A fuse in the I/P fuse block supplies battery positive voltage to the turn signal/flasher module and ground is supplied at G200. When the turn signal switch is placed in either the left or right position, a voltage signal is completed from the turn signal switch to the turn sign/flasher module. When the hazard flasher switch is activated, a ground signal is completed from the turn signal/hazard switch to the turn sign/flasher module. The turn sign/flasher module then sends an on-off voltage signal through the LT TRLR, RT TRLR, LT TURN or RT TURN 10 A fuses in the I/P fuse block to the appropriate turn signal or to all 4 fuses for hazard operation. The instrument panel cluster (IPC) indicators receive voltage from the LT TURN and RT TURN fuses as well as the DDM/PDM for the mirror turn signals. The DDM/PDM has no function or control of the mirror turn signals other that a pass through connection for the circuits. The audio chime is also activated when the turn signals are on. When the hazard switch is pressed, all turn signal lamps will flash including both IPC turn indicators. The front turn signals are grounded at G100. The rear turn signals are grounded at G401. The Mirror turn signals are grounded by the DDM/PDM.

Do you know how to do automotive electrical circuit testing with a test light or volt meter ? How to read an use a wiring diagram to pin point testing points . ( connectors , fuse locations etc... ) How to use a power flow chart ? Here is a site for just such info .

http://www.bbbind.com/free_tsb.html Enter vehicle info . year , make , model an engine size . System click lighting , subsystem exterior lighting . Second diagram shows trailer wiring .
Electric Testing Techniques You Need to Know

Mastering Voltage Drop Testing with Pete Meier and Jerry Truglia

CHEVROLET 2007 SILVERADO TRAILER LIGHT TROUBLESHOOTING


Apr 07, 2017 | 2003 GMC Yukon Denali

1 Answer

2003 Denali has no right trailer turn signal


LEDs overload the original flasher relay.. replace it

if no better
run a new wire for the right trailer turn signal
and check the earths



index-5lx0cwnik0mveyhdlt2zffgo-4-0.jpg

Mar 31, 2017 | 2003 GMC Yukon Denali

1 Answer

Where is 2002 gmc envoy airbag module located???


There is a module that controls the air bags called the SDM Sensing and Diagnostic Module, but the air bags themselves are called modules. If they are referring to the SDM...

zjlimited_794.gif

(1) Lower Console
(2) Inflatable Restraint Sensing and Diagnostic Module (SDM)


Hope this helps (remember to rating this free answer and leave a testimonial comment). Thank you for using Fixya.

Oct 13, 2011 | 2002 GMC Envoy

1 Answer

2002 envoy code co550


you need to replace the tccm and get it programmed.


2-04-21-006E: Inoperative 4WD/AWD Lamps, Inoperative 4WD/AWD System, DTC C0550 Set No Communication with TCCM (Reprogram Transfer Case Control Module) - (Jul 20, 2006)
999999995.gif Subject: Inoperative 4WD/AWD Lamps, Inoperative 4WD/AWD System, DTC C0550 Set, No Communication with TCCM (Reprogram Transfer Case Control Module) Models: 2004 Buick Rainier 2002-2004 Chevrolet TrailBlazer, TrailBlazer EXT 2003-2004 Chevrolet Avalanche, Silverado, Suburban, Tahoe 2002-2004 GMC Envoy, Envoy XL 2003-2004 GMC Sierra, Yukon, Yukon XL 2004 GMC Envoy XUV 2002-2004 Oldsmobile Bravada with Electronic Shift or Active Transfer Case (RPOs NP1, NP4 or NP8)

This bulletin is being revised to add Subject information and change the labor operation. This bulletin cancels and supersedes Bulletin Number 03-04-21-006. Please discard Corporate Bulletin Numbers 02-04-21-006D and 03-04-21-006 (Section 04 -- Driveline/Axle).
ConditionSome customers may comment that the 4WD/AWD indicator lights on the selector switch do not work, or the 4WD/AWD system may be inoperative and/or the service 4WD light is illuminated. The condition is typically intermittent and always occurs at key-up. Upon investigation, the technician may find DTC C0550 set.
CauseThe Transfer Case Control Module (TCCM) has not received the wake-up call during key-up and has remained in the "sleep mode".
When the TCCM is in the "sleep mode", it will not communicate with the class II bus or the Tech 2®.
Correction
  1. Try to communicate with the TCCM. If no communication, go to step 2. If communication is possible, go to step 5.
  2. Remove the underhood (ATCM or TREC) TCCM fuse.
  3. Wait 30 seconds.
  4. Reinstall the fuse. The module should "wake up" and communicate with the Tech 2®.
  5. Check for codes in the TCCM. If a C0550 is found current or in history with or without other codes, replace the module and go to step 6.
  6. Reprogram the TCCM with the latest TIS software using normal SPS procedures.
  7. Verify operation and that no codes are present.
Important: For the 2002 model year, the TCCM must be replaced and reprogrammed.
Warranty Information

Jul 29, 2011 | 2002 GMC Envoy

1 Answer

I am needing to install a turn signal flasher in a 2004 GMC Envoy and cannot locate where to install the piece. Help is greatly appreciated!


The Turn Signal/Hazard Flasher Module is located under the dash to the left of the steering column. It is a rectangular device plugged into a harness connector.

Jul 20, 2011 | 2004 GMC Envoy

1 Answer

I have 2002 envoy with service 4wd light on a code co550 ecu/ccu malfunction .where do i go


Replace the transfer case module.this module will need to be programmed by a gm dealer.Co550 is a internal fault code.bulletin from gm for this.

Dec 02, 2010 | 2002 GMC Envoy

1 Answer

Blower motor stays running ,can't shut it off ,on my 2003 envoy 4,2,it's has dual climate controls , with blower controls on the steering wheel as well as on the dash.please help with the location of the...


you need to check / replace the blower speed resistor module that should take care of the problem it is located lower evaporator case right hand side very bottom by the blower motor.

Nov 04, 2009 | 2002 GMC Envoy

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

116 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Freddy

Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...