Locating the breather hose on a 2007 bonda accord

Wiring, schematic, electrical diagrams, torq setting, error/fault codes, full assembly/dissembly, service instructions and a lot moreetc are basic contents of these online books they here on this website https://big-manuals.com/products/chevrolet-chevy-uplander-complete-workshop-service-repair-manual-2005-2006-2007-2008
Must check it out

it may just go up to a non-return valve and be attached to the fire wall or it may go to the air filter housing to breath into the air filter

it seems that the battery is dying (dead). have the battery checked, then the alternator.

The filler breather seems to be leaking. This is a pipe that comes from the top of the tank to the fuel filler hose very near to the tank cap. Also check the filler hose neck itself.

If you are going thru water alot the higher the better. If you think you have water in you transfercase then change the fluid. When you have the plugs out of the Tcase, blow thru the breather hose to make sure its clear.

something not right here and without my greasy oily hands on it its difficult to say ,could be worn piston rings ,engine breather too much oil ,or a secondhand turbo thats worse than the one you took off ,check the engine breather first and the filter in it isnt blocked or missing

think its just the rubber seal on the motor in teh deposit bottle

Looking at the car from the front, the dip stick for the transaxle is down very low at the left hand side of the engine, close to being under the battery. It is normally yellow. Follow the large water hose that runs down next to your battery. The yellow dip stick handle is right along side of that hose (to the right of it) down low. It will either pull out or unscrew.
Hope this helps you.

The MAP sensor is on the breather hose next to the breather box,The speed sensors are pictured below.Please take time to rate this a fixya.

most of cars or trucks have the intake sensor on the big breather hose after the air filter, and it is a two wire conector, i recomend you to buy the new sensor and look for something similar but if you can't find it, some intake sensor come as an assembly with the mass air flow sensor located also at same hose.