Ignition switch repairs

no way to bypass,but can get a brake code from dealer to temp start and drive vehicle

Honda Pilot 2005 won't start dead starter - YouTube

? 2:48
https://www.youtube.com/watch?v=tH2rEYLbQrY
Sep 15, 2011 - Uploaded by Alexey Gavrilov
Honda Pilot 2005 won't start dead starter ... How To Replace a Starter 2006 Honda Odyssey -EricTheCarGuy ...

Today my Pilot won't start! - Honda Pilot - Honda Pilot Forums

www.piloteers.org > ... > General > Problems

Mar 13, 2011 - A half-hour later, I got in to move it back, and the Pilot would not start. All the .... Most original batterys from 2005 need to be replaced by now. Starting Problem 2005 EX
Feb 24, 2011
Cold Weather (0 deg F) 06 Pilot won't start after jump - Honda ...
Jan 17, 2009
Engine won't start - clicking sounds and guage flutter - Honda ...
Dec 23, 2007
Starting Problems
Mar 24, 2006
More results from www.piloteers.org

Thread: '05 EXL won't start - HondaSUV.com Forums

1- turn off the engine. 2- press and hold the select/Reset button on the instrument panel, then turn on the ignition switch ON (II) 3- Hold the button for approximately ten seconds until the indicator resets or go to Honda pilot 2003 owner's manual see page 69.

Reset oil service light Honda Pilot. From years: 2003, 2004, 2005, 2006, 2007, 2008, 2009, 2010, 2011, 2012.
How do you reset oil service light Honda Pilot. From years: 2003, 2004, 2005.

1. Turn off the engine. Press and hold the SELECT/RESET button in the instrument panel and turn the ignition switch to run (one position before starting).
2. Hold the button for at least 10 seconds, until the indicator resets.
3. Turn the ignition off and then start the engine to verify the indicator has been reset.

How to reset oil service light Honda Pilot. From years: 2006, 2007, 2008, 2009, 2010, 2011, 2012.
Resetting the Engine Oil Life Display if maintenance service is done by someone other than your dealer, reset the maintenance minder as
follows:

1. Turn the ignition switch to the ON (II) position.
2. Press the select/reset knob repeatedly until the engine oil life is displayed.
3. Press the select/reset knob for about 10 seconds. The engine oil life and the maintenance item code(s) will blink.
4. Press the select/reset knob for another 5 seconds. The maintenance item code(s) will disappear, and the engine oil life will reset to 100.

All information is taken from the Honda Pilot owners manual.

When you have made this connection,probably there has been a short circuit,without seeing it so due to that,fuses have blown,check the fuses box ,you will see it one by one to be sure you don't miss one.

If you car has the immobilizer system, the following might help.

The Immobilizer System protects your car from theft. A properly coded ignition key must be used in the ignition switch for the engine to start. If an improperly-coded key (or other device) is used, the engine’s fuel system is disabled.
When you turn the ignition switch to ON (II), the Immobilizer System indicator should come on for a few seconds, then go out. If the indicator starts to blink, it means the system does not recognize the coding of the key.
Turn the ignition switch to LOCK (0), remove the key, reinsert it, and turn the switch to ON (II) again.

Hope this is helpful to you.

That's your immobilizer system light:
The Immobilizer System protects your car from theft. A properly coded master or valet key must be used in the ignition switch for the engine to start.
If an improperly coded key (or other device) is used, the engine’s fuel system is disabled.
When you turn the ignition switch to ON (II), the Immobilizer System indicator should come on for a few seconds, then go out. If the indicator starts to blink, it means the system does not recognize the coding of the key. Turn the ignition switch to LOCK (0), remove the key, reinsert it, and turn the switch to ON (II) again.
The system may not recognize your key’s coding if another immobilizer key or other metal object is near the ignition switch when you insert the key. To make sure the system recognizes the key code:
Do not keep other immobilizer keys on the same key ring.
Use a plastic or leather key fob, not metal.
Keep other keys away from your vehicle’s key and the ignition switch while trying to start the engine.
Do not attempt to alter this system or add other devices to it. Electrical problems could result that may make your car undriveable.
This indicator will also blink several times when you turn the ignition switch from ON (II) to ACCESSORY (I) or LOCK (0).
If the system repeatedly does not recognize the coding of your key, contact your Honda dealer.
If you have lost your key and you cannot start the engine, contact your Honda dealer.
Hope this lets you understand the light, and what should be happening.

Your car uses a transonder key, a key with a small chip embedded inside. The transponder is matched to the immobilizer unit in your car. When the key is inserted into the ignition, the immobilizer searches for that transponder, if it's not near the ignition, the car will just keep turning over and not start. Your only real options are to replace the steering lock or buy a transponder bypass unit, which I do not recommend. Just do a google search.

should work as many times as you use it

It must be taken to the dealer and you can have up to 7 starts befor the immobi will shut down.