I lost the key to my 99 blazerso I popped ignition with sledgehammer I try to start with the scooter it starts for a few seconds and turns off how do I disable the security featureMY ORIGINAL KEY DID
Try 310 minutes cycles tried spraying starting fluid in the air cleaner cut the wire on top of the ignition the yellow one MY ORIGINAL KEY DIDNNOT HAVE CHIP ON IT
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
you damaged the ignition switch and it will not recognize key you have to replace the tumbler and ignition switch the key acts like an electronic switch in most modern vehicles put key in and its recolonized and will turn and start vehicle ---damage to key or tumbler sets off anti theft and you have no start ---in future dont try to hot wire or pop ignition when keys are lost (thats all hollywood) go to dealer with vin and proof of ownership and they can cut you a new key
Your ignition switch is going bad. The strange noise is the starter remaining engaged and locked to the flywheel. Your best bet is to have the starter tested at your local auto parts store, to deduce that it is not, in fact, your starter.
Do you notice anything unusual with the dash lights when you turn the key on. All the warning lights should illuminate. If they do not but then come on as you start to rotate the key into the start position than you probably have a bad ignition switch.
If you turn the key to the start position and hold it there (only do this for a few seconds) will the car stay running until you let go of the key? Another clue that the ignition switch may be bad.
if you turn the key to the start position and the vehicle starts slowly let the key rotate back to the run position until the starter disengages. If the vehicle continues to run let go of the key. If the vehicle stalls than the ignition switch is definitely bad.
This is a problem with the ignition switch, it thinks the key is still in the ignition, the internal switch may be stuck , start by spraying a little silicone into key hole then put key in and start car then remove key, do this a few times and spray a few times but just a little spray. hope this helps.
Yes it sounds like a security system problem. Does the new column have pass key? You are leaving the key on until the security light stops flashing? The light is flashing for 10 minutes?
6-turn key to on (not start) then off, twice this is rewrite mode,have all remotes to reprogram it will clear any lost remotes.
7-remove key from ignition,the door locks should cycle twice.if not start over.it may take a few tries.
8-press lock/unlock together and hold for a second
9-release,and press lock on remote,the door locks will cycle
confirming program.continue to do other remotes you have,steps 8 and
9.if only one in possession,you are done. To end mode open door or insert key into ignition.
You'll need to follow the steps with no more than a 1-2 second delay between each step.. hope it works
6-turn key to on (not start) then off, twice this is rewrite mode,have all remotes to reprogram it will clear any lost remotes.
7-remove key from ignition,the door locks should cycle twice.if not start over.it may take a few tries.
8-press lock/unlock together and hold for a second
9-release,and press lock on remote,the door locks will cycle
confirming program.continue to do other remotes you have,steps 8 and
9.if only one in possession,you are done. To end mode open door or insert key into ignition.
You'll need to follow the steps with no more than a 1-2 second delay between each step.. hope it works
×