Question about 1995 Toyota Corolla

1 Answer

No starer action

Key turns all power on , yet no starter action. open wire maybe ?

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.


    An expert that got 20 achievements.


    An expert that got 10 achievements.

  • Toyota Master
  • 76,630 Answers

Defective starter? locked out security system

Posted on Jul 19, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

2012 Mazda 5 won't start - starer and battery seem OK, the starter cycles, lights etc. work. Gas tank is full, car worked fine yesterday.

When you turn the key to start, what happens ? Does the engine turn over and not start ? Or does it not do anything ?

When you say that the starter seems ok, have you tested it ? Did you jump starter/solenoid and see if the engine turns over ? Are you getting power to the starter when turning the key to the start position ?

Nov 26, 2016 | 2012 Mazda MX-5 Miata

1 Answer

93 Ford F150 diagram from battery to relay to seliniod to starer

There is a common issue with this year and I have run into it maybe 100 times, The ignition starter switch (located near the bottom top of the steering column) is defective, the switch halves come apart and this causes a no start. Hook a test light up to the fender solenoid, when the key is held in start position the little wire (solenoid signal wire) should light a 12 volt test light, if not you are not getting any power from the ignition starter switch. The switch is very cheap and easy to replace.

Jun 21, 2016 | Ford Cars & Trucks

2 Answers

Has new battery wont turnover, wont do anything when u turn the key dash lights up normal

may be that a wire from the starter motor has come off. ignition relay could be weak, or maybe even your starer motor is fried

Feb 26, 2011 | 2002 Oldsmobile Aurora

1 Answer

The car sat for 2 months the battery died install a new one i get power but wont turn over its a 2003 mini cooper s could the starer freeze up

A starter freeze-up would probably give forth much smoke from the wiring and the starter motor itself. You need a test light or meter to check for power at the starer solenoid. Check from ground (engine block) to the terminal that connects to the positive battery cable (should light). If nothing, check the battery terminals for corrosion (use a special battery cleaning brush from your auto parts store --cheap) and check the cables near the terminals for excess wire corrosion. Recheck for power at the solenoid again--it should now give light (meter read 12.6 volts). Try the starter again--if only hear a 'click', test at the starter motor terminal for power when the key is turned. If you get light, then the starter motor is defective (likely a bad brush or spring) and should be removed for repair or replacement. If you got no power at the starter terminal, then replace the solenoid. Hope this helps!

Oct 08, 2010 | 2003 Mini Cooper

1 Answer

Motor swamp on a 1991 firebird when you turn key starter will not row over and fuel and ecm will not get current, check fusible links, the clutch switch works ok , the anti theft relay is ok, cant figure...

You likely put the starter engagement wire on the wrong post[purple wire to the small post of the solenoid switch on the starer motor].The ecu will not get current until it sees engine rpm so you need to get it to crank first then recheck for power.

May 31, 2010 | 1991 Pontiac Firebird

1 Answer

We replaced the starer and there is a problem with a ground in the front next to the firewall that is a ground strap and is on a post when i put the wires on the battery the cars silanoid comes on with out...

sounds like your hooking your starter up wrong.
put the main battery wire on the solenoid side for the battery and the igniton wire on the s for starter no the field. once the igniton is turn on 12 volts to the small
igniton wire on the solenoid causes a magnetic fields and connets the starter lead to the battery hot or positive animating the starter.

Feb 10, 2010 | 1995 Jaguar XJ6

1 Answer

Now i replace the ignition cylinder but i steel kent starer on my chevrolet 1987 s10 pickup

check power on large yellow wire from ignition swith while turning key to start possition,this is the wire that powers the solenoid to starter.also may try tapping on starter with hammer while someone is trying to start.If starts while performing tap method you will need a starter. If no power to yellow wire at ign switch while starting will need electrical part of ignition.

Jun 16, 2009 | 1987 Chevrolet S-10 Pickup

1 Answer

Turn key noting,new batt,new stater,sill same

I presume all the bells and whistles come on but no starter action. Lets go to the Power Distribution Center under the hood. Look at the big fuses. Find fuse "G" that should be the starter relay fuse (40 amp) That supplies power to the relay. If that's ok then we go to the Starter Relay. Remove it and you will find 5 female spade connectors. We want the two that are together. One comes from the fuse you just checked, that should have power. The other goes to the starter solenoid. Jump those two (make sure the trans is in park) That should crank over the starter. If that doesn't work either the circuit down to the starter is open or the Power distribution center has internal open circuit. If everything worked up to this point, try swapping relays (AC Clutch maybe)
That should solve your issue. If by some freak chance that doesn't the remaining possibilities lie with the controls of that relay. Trans Controller, Engine Controller, Trans selector switch, ignition switch and wiring in between.
Let me know how this goes for you.

Apr 04, 2009 | 1999 Dodge Intrepid

2 Answers

Won't start when engine is warmed

the problem is likely the starter when they get old heat can cause them to malfunction.

Dec 13, 2008 | 2002 Chevrolet Silverado

Not finding what you are looking for?
1995 Toyota Corolla Logo

Related Topics:

96 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts


Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8514 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides