Question about 1996 Jeep Grand Cherokee

1 Answer

Where the alarm is located - 1996 Jeep Grand Cherokee

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    New Friend:

    An expert that has 1 follower.

  • Expert
  • 180 Answers

Should be under dash close to steering colum

Posted on Jul 19, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How can I shut or disconnect my security alarm on my 94 Nissan maxima the doors lock and alarm goes off the drivers side door key don't always work to shut alarm off


You'd have to find a wiring schematic for your car and locate the wires for the alarm. Either unclip them or cut them. Usually are located in the wiring harness under the dash, above the pedals.

Nov 22, 2013 | Cars & Trucks

2 Answers

Location of tail gate alarm on 2004 Chrysler Pacifica


you may have a bad switch which is located on the latch asm

Sep 03, 2012 | 2004 Chrysler Pacifica

1 Answer

Discovery 1 alarm location


Alarm components are in many different locations
The ECU is in the passenger footwell.
I can fax the page from the factory workshop manual that shows locations
of all components if you wish.

Dec 26, 2011 | Land Rover Discovery Cars & Trucks

2 Answers

I replaced the ignition switch in my 1995 ford ranger now the alarm won't stop


95 Ford Ranger Auto Alarm Wiring Diagram.

You need to re-check your ignition wiring. Here is the wiring for the alarm.

Battery Constant 12v+ Positive Wire (+): Yellow
Battery Constant 12v+ Positive Wire Location: Ignition Switch Harness

Starter Positive Wire (+): Red/Light Blue
Starter Positive Wire Location: Ignition Switch Harness

Ignition Positive Wire (+): Light Green/Purple
Ignition Positive Wire Location: Ignition Switch Harness

Second Ignition Positive Wire (+): Black/Light Green
Second Ignition Positive Wire Location: Ignition Switch Harness

Accessory Positive Wire (+): Gray/Yellow
Accessory Positive Wire Location: Ignition Switch Harness

Parking Light Positive Wire (+): White/Black Or Brown
Parking Light Positive Wire Location: At Headlight Switch Or Low In Drivers Kick Panel

Power Door Lock Negative Wire (-): Pink/Yellow (Type B)
Power Door Lock Negative Wire Location: In Either Kick Panel

Power Door Unlock Negative Wire (-): Pink/Light Green (Type B)
Power Door Unlock Negative Wire Location: In Either Kick Panel

Door Trigger Positive Wire (+): Black/Light Blue
Door Trigger Positive Wire Location: In Drivers Kick Panel

Domelight Supervision Wire: Use Door Trigger (Requires Relay)
Domelight Supervision Wire Location: N/A

Horn Negative Wire (-): Yellow/Light Green
Horn Negative Wire Location: At Steering Column Harness

Tachometer Wire Negative Wire (-): Any Wire With A Tan Stripe Or A Yellow Stripe
Tachometer Wire Negative Wire Location: At Ignition Coil

Brake Light Positive Wire (+): Light Green
Brake Light Positive Wire Location: At Switch Above Brake Pedal

Factory Alarm Disarm Wire (-): Dark Green/Purple
Factory Alarm Disarm Wire Location: Low In Drivers Kick Panel

Factory Anti-Theft System: N/A
Factory Anti-Theft System Location: N/A

Nov 16, 2011 | 1995 Ford Ranger Supercab

1 Answer

Disconnect the alarm


You can just remove the Fuse located under the steering in the car. There is a fuse box on the left. You can check if its there. If the Car Alarm is not an OEM alarm then the fuse is located near the sensor box of the Car alarm. Hope this helps.. Thank you.

Jan 29, 2011 | 2005 Toyota Corolla

2 Answers

I have a 93 lexus sc 400. The car alarm will go off randomly once or twice a month. The only way to turn the car alarm off is to disconnect the battery terminals. Any ideas on deactivating the alarm all...


find the alarm box to adjust the sensitivity 9 times out of 10 time the alarm box is located on the opposite side of the engine away from the battery. but if it's a factory alarm you can call the dealer for the location better yet check the owner manual for the location.

Dec 06, 2010 | Lexus SC 400 Cars & Trucks

2 Answers

Alarm system bypass


CANNOT BE DONE,if it could,the car thieves would have posted it on you tube by now.....(they like humliating manufacturers)

Oct 12, 2010 | 1996 Dodge Caravan

3 Answers

I need to disable my alarm on a 1997 bmw 528i.


Now im not sure since the manual says your model has the same alarm system as the 328i and on the 328i you can remove the module to disable by doing the following. you can unplug the control module. It is located under the glove box. Climb under the dash on the passenger side and remove a few screws on the trim panel under the glove box. Theres a black control module with a green connector. There should be a lock tab on the connector. press the lock tab and pull out the connector. The alarm should now be disabled. But if it has the special transponder key this may not work.
But if the only reason you want to disable it is because of the motion sensor setting of the alarm for no reason there is a solution for this. To disable the motion sensor, hit the lock button to arm, then hit lock button again within four seconds to disable motion sensor. Red light on rearview mirror should flash four times, then pause, then start flashing on regular intervals. this is most likely the reason if your having the issue where the alarm goes off every 20 minutes.
If you want to completely remove it below is a wiring diagram taken from the manual for you alarm system.
this is from the manual its the alarm wiring diagram.
Battery Constant 12v Positive Wire ( ): Red/White or RedBattery Constant 12v Positive Wire Location: Ignition Switch Harness
Starter Positive Wire ( ): Black/Yellow or Black
Starter Positive Wire Location: Ignition Switch Harness
Ignition Positive Wire ( ): Green
Ignition Positive Wire Location: Ignition Switch Harness
Second Ignition Positive Wire ( ): Purple/White or Purple
Second Ignition Positive Wire Location: Ignition Switch Harness
Parking Light Positive Wire ( ): Gray/Purple and Gray/Yellow. Use Both Wires. This vehicle has a dual parking light system that will require 2 extra relays.
Parking Light Positive Wire Location: At Headlight Switch
Power Door Lock Positive Wire ( ): White/Red
Power Door Lock Positive Wire Location: At Factory Alarm Plug. The alarm plug is a black 12 pin plug located just behind the glove box.
Power Door Unlock Positive Wire ( ): Blue/Red
Power Door Unlock Positive Wire Location: At Factory Alarm Plug. The alarm plug is a black 12 pin plug located just behind the glove box.
Door Trigger Negative Wire (-): Brown/Gray
Door Trigger Negative Wire Location: At Factory Alarm Plug. The alarm plug is a black 12 pin plug located just behind the glove box.
Domelight Supervision Wire: Turns On With Unlock
Domelight Supervision Wire Location: N/A
Horn Negative Wire (-): Brown/Red or Brown/Yellow
Horn Negative Wire Location: At Steering Column Harness
Tachometer Wire Negative Wire (-): Black
Tachometer Wire Negative Wire Location: At Instrument Cluster
Brake Light Positive Wire ( ): Blue/Red or Green/Red
Brake Light Positive Wire Location: At Switch Above Brake Pedal
Factory Alarm Disarm Wire (-): Disarms With Factory Remote Only. Factory Alarm Disarm Wire Location: N/A
Factory Anti-Theft System: Transponder Anti-Theft System, Requires Bypass And Extra Ignition Key. The 1997 model year vehicle may require a bypass module and an extra ignition key, if vehicle is equipped with a special key from BMW.
Factory Anti-Theft System Location: Transponder At Ignition Switch Tumbler
if you require further assistance please let me know and i will help assist you from there. Thanks, Midwest-Tek

Aug 27, 2010 | 1997 BMW 328

1 Answer

I have a 1999 Volkswagen jetta and i am trying to hook up an air horn to my alarm system and do not know the location of easy access wires to the horn of the alarm would you be able to help me find the...


The horn for the alarm is located beside the wiper motor assembly. You'll need to remove the wiper arm assy so you can remove the cowl panel and access the electric horn.

Nov 10, 2009 | 1999 Volkswagen Jetta

2 Answers

2002 Dodge Stratus fuse box diagram. Need to change fuse for the alarm system


If this is factory installed alarm the fuse most likely is in the fuse box under teh hood and market on the lid. It should be located next to the battery. If this is an after market alarm that was installed you will need to locate the alarm speaker and trace the lines back toward the battery and locate the fuse on the wires.

Aug 27, 2009 | 2002 Dodge Stratus

Not finding what you are looking for?
1996 Jeep Grand Cherokee Logo

Related Topics:

78 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

75744 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8123 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...