Question about 1998 Lincoln Town Car

1 Answer

I have the 1998 workshop manuals, Vol I and II, as

I have the 1998 Ford Town Car workshop manuals, Vol I and II, as well as the electronic vacuum and troubleshooting manual. I cannot find a section regarding the electronic power window gang switch found on the drivers side front door. This switch bank controls the four power windows on the doors. I cannot find information on this component in the Volume II, Group 4 electrical section, nor anywhere else. I have a problem with what I think is a switch connection for the drivers express window. Where might directions on removal/repair of this switch bank be found in the manuals?

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 359 Answers

There should be a trouble tree in the interior electrical section, Ford recommends testingwith a known good switch

Posted on Jul 19, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Iut just bought a ford au 1999 with a remote but tonight I cannot open the car door..


if genuine au remote.. check the fob battery

could be a faulty door lock actuator or module fault

you will find the free AU falcon repair manual handy
Ford Falcon AU 1998 2002 Workshop Manuals Factory Service Manuals

Nov 24, 2016 | Ford Cars & Trucks

1 Answer

1998 Lincoln town car bank1 bank 2 runing lean


Could have an intake manifold vacuum leak , weak fuel pump or fuel filter clogged , mass air flow sensor dirty or bad . There are videos on youtube checking lean conditions .

Oct 19, 2016 | 1998 Lincoln Town Car

1 Answer

Trying to locate temp switch on 98 ford contour


2.0L or 2.5L V6???

SECTION 303-14A: Electronic Engine Controls - 2.0L Engine 1998 Contour/Mystique Workshop Manual
DESCRIPTION AND OPERATION snorkelbobby_16.gif
#4 is coolant ECT - engine coolant temp sensor.


snorkelbobby_17.gif

Dec 19, 2010 | 1998 Ford Contour

1 Answer

Locate lcm module 98 lincolin wont stay on


LCM is usually under dash above driver's feet.

They are $400. Gino on ebay fixes them a lot cheaper. Just search for lighting control module and you will find him.

SECTION 419-10: Multi-Function Electronic Control Modules 1998 Town Car Workshop Manual
REMOVAL AND INSTALLATION Module -Lighting Control (LCM) Removal
  1. swg~us~en~file=ani_caut.gif~gen~ref.gif CAUTION: Prior to removal of module, it is necessary to upload module configuration information to New Generation STAR (NGS) Tester. This information needs to be downloaded into the new module once installed.
    swg~us~en~file=ani_caut.gif~gen~ref.gif CAUTION: Electronic modules are sensitive to electrical charges. If exposed to these charges, damage may result.
    Disconnect the battery ground cable.
  1. Remove the LH instrument panel lower insulator.
    1. Remove the pin-type retainers.
    1. Disconnect the courtesy lamp.
    1. Remove the LH instrument panel insulator.
  1. Position the LCM aside.
    1. Remove the screws.
    1. Release the locking tab.
    1. Position the LCM aside.

  1. Remove the LCM.
    1. Disconnect the electrical connectors.
    1. Remove the LCM.
Installation
  1. swg~us~en~file=ani_caut.gif~gen~ref.gif CAUTION: Once the new module is installed, it is necessary to download the module configuration information from New Generation STAR (NGS) Tester into the new module.
    NOTE: When the battery is disconnected and reconnected, some abnormal drive symptoms may occur while the vehicle relearns it adaptive strategy. The vehicle may need to be drive 16 km (10 miles) or more to relearn the strategy.
    To install, reverse the removal procedure.

888bfe5.gif

Oct 30, 2010 | 1998 Lincoln Town Car

1 Answer

How do i progam my ing/switch for a 1998 lincoln town car


If you dont have 2 existing programed keys it must be done by a locksmith or dealer with the proper electronic tools. No way to cheat it

Jan 10, 2010 | 1998 Lincoln Town Car

1 Answer

Speedometer has incorrect mileage


U can't reset the mileage, there is no way to do this because the movement is electronic, u can buy a new speedo, but that is very expensive.

Dec 24, 2008 | 1998 Lincoln Town Car

2 Answers

1998 ford crown victoria fuse box diagram


it should be in your owner manual. if not, I can look up something for you but can't post illustrations to this site.

Sep 10, 2008 | 1998 Ford Crown Victoria

Not finding what you are looking for?

Open Questions:

0 Answers

98 Lincoln TC,Cold starts fine ,runs good until warm, then shuts off. No codes,Cranks ok, have spark, PATS ok. No fuel pressure, cant hear fuel pump prime,New Fuel relay. jumped fuel pump - works. I do not hear fuel pump prime up, do not have fuel gauge, but pressing on valve in fuel rail- no pressurized fuel. Fuel regulator seems ok, not leaking / vacuum line dry as a bone. If I let it set for 15 min , it will start up again, but for a few minutes then dies out. If I let it set overnight it starts up perfectly and runs until operating temp is reached then stalls/stumbles, and shuts down. Vacuum is good while cranking, even with no start, Checked Inertia switch in trunk, it is not tripped. I have seen Ford TSB summaries' that mention issues like this , but I am not able to see to description. A point to add, the MAF sensor was cleaned, then I decided to replace it and did not make a difference. I do not have any stored codes, and the PATS is working fine, typical 2 second flash from and once key is inserted a 3 second steady light, then disappears. I have seen the TSB mentioning C103 Connector, it looks fine, I swapped out fuel pump relay with ac relay, still no difference.mention of wires around battery, do not know where to start. in dash service engine light and odometer is normal, seen other posts the say they only have lines, but mine is ok. the start of all of this , I washed engine with regular garden hose, ( not using pressure washer).also in the mean time, rear window defroster stopped working as well, can not say for same reason, but a mention.My problem started after washing engine. this is one of four Panther platform vehicles I owned with exact 4.6l w code engine, which I rinced down before. The only sensor I can think of is Oil pressure , or a corroded wire

Feb 27, 2017 | 1998 Lincoln Town Car

See all 1998 Lincoln Town Car Questions

1998 Lincoln Town Car Logo

183 people viewed this question

Ask a Question

Usually answered in minutes!

Top Lincoln Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

fordexpert

Level 3 Expert

5537 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Are you a Lincoln Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...