Where to locate purge valve in a 2006 chrysler town and country

Gary Queen

• 85 Answers
• Posted on Aug 24, 2008

SOURCE: changing fuel filter on 2004 chrysler town and country

1. Remove or disconnect the following:
   • Negative battery cable
2. Raise the vehicle and support the fuel tank with a transmission jack.
   • Fuel line from the front of the tank
   • Ground strap
   • Inboard side of the fuel tank straps and front T strap fastener and lower the tank about 6 inches
   • Fuel lines from the fuel pump module
   • Fuel filter
3. Installation is the reverse of removal. Tighten the fuel filter bolts to 40 inch lbs. (4.5 Nm), the main tank straps to 40 ft. lbs. (54 Nm) and the T strap to 250 inch lbs. (28 Nm).
4. Start the engine and check for leaks.

Marvin

• 85242 Answers
• Posted on Mar 23, 2009

SOURCE: where is the body control module located on a 1997 town & country

It is located on the back side of the underdash fuse box (junction block). You remove the lower steering column cover and knee blocker reinforcement. Then remove two plugs from the bottom of the BCM.
Remove the bolts holding the junction block to dash panel mounting bracket. Remove the junction block from the bracket. Remove screws holding the BCM to the junction block. Slide the BCM downward to disengage guide studs on jb from channels on BCM mounting bracket

Greg Bernett

• 2993 Answers
• Posted on Nov 13, 2009

SOURCE: Front PCV Valve on chrysler town and country

PCV valve location-2.4L engine


PCV valve location-3.3L and 3.8L engines

SOURCE: code EGR P404

Or before shelling out that kind of cash; you could try cleaning the seal on your gas cap and/or replacing your gas cap first. My '06 has tripped this code twice (after very dry or very cold weather).

ZJ Limited

• 17989 Answers
• Posted on Mar 23, 2010

SOURCE: I need the diagram of the 2006 Chrysler Town &

For 2006 Chrysler Town & Country fuse diagram, check the Owners Manual (page 434 and next).

Hope this help (remember rated and comment this).