Question about 1995 Toyota Camry

1 Answer

95 Toyota Camery, The car remote locks and unlocks, the security led flashes when set, the locking and unlocking beeps and alarm sounds are now gone. Whole system replace or is it the loud speaker unit under the hood?

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 88 Answers

If the light is flashing and the central locking works then its all good the speaker wire has maybe broken inside plastic casing but hey if it all works with out the noise then leave it

Posted on Aug 07, 2009

  • mark Aug 07, 2009

    if the light is flashing and the central locking works then its all good the speaker wire has maybe broken inside plastic casing but hey if it all works with out the noise then leave it

×

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Security Lock Flashing. Even when I lock with key it stops flashing but stays on. What is solution?


You are going to have to use the Key fob or remote alarm fob to go threw a set of lock and unlock procedure. Crank the car shut it off remove the key outside the vehicle at a distance of at least 30ft then lock the car, wait till it arms and the dash light blinks once this is active you want to unlock the car with the remote. If this one does not work do the same thing except when you unlock it do so with the key to re open after arming security.Also make sure you have both fobs or all remote fobs with you when you do this lock with one unlock with the other then vise, versa ok if you need any further help just ask also make sure your battery is fully charged and the terminals are clean this will affect a security system bad a low battery or low battery in the FOB's.

Apr 23, 2015 | 2012 Toyota Camry

Tip

How to set & cancel theft deterrent system or how to set & cancel security...


Theft deterrent system (on some models)

Theft deterrent system is designed to deter vehicle theft. The system flashes the turn signal lights and turns on the interior light or the signal lights only (depending on the model), and sounds security horn and vehicle horn when it detects abnormalities such as follows:

• Any door or hood is forcibly opened.
• The batter terminal is disconnected and then reconnected
• The system control is disconnected and then reconnected.
• Abnormal impact is detected when the impact sensor function is on.

The system flashes the turn signal lights and turns the interior light or the signal lights only (depending on the model), and sounds security horn and vehicle horn if someone attempts to damage or break into your car.

Setting the system

You can set the system with or without the impact sensor function. For details, see "Canceling the impact sensor" below.

1. Turn the ignition key to "LOCK" and remove it.
2. Have all passengers get out of the vehicle
3. Push the lock (set) switch on the wireless remote control key once. At this time, the turn signal lights flashes once and the security indicator light comes on.

The system is set after 30 seconds. At this time, the security indicator light start flashing slowly.

Once the system is set, you cannot start the engine until you cancel the system.

The system will not be set in the following cases.

• When any of the door is open; security horn sounds for 1 second, close the door and set the system again.
• When the hood is open; close the hood securely.

Canceling the Impact Sensor

The impact sensor can be cancelled to prevent false alarms from being triggered incase of the following conditions:

• When parked in the noisy area
• The vehicle body or glass is subjected to a strong impact from the (such as in highly pressurized car wash).
• When transporting by a car carrier or ferry.

To cancel the impact sensor;

1. Lock the door by pushing the lock (set) switch on the wireless remote control key once, and turn signal light flash once
2. Then push the lock (set) switch twice within 5 seconds. At this time, the turn signal flash 5 times to indicate the impact sensor function is disable.

The impact sensor is deactivated as long as the system remained armed.

Canceling the system

The system will be cancelled by the following two ways:

• Turn the ignition key from "LOCK" to "ON" position.
• Unlock any of the doors by pushing the unlock (cancel) switch

If the turn signal lights flash 3 times, the system has been alarmed. Check to see if there is any abnormality with your vehicle.

If any of the doors is not opened within 30 seconds, all doors will be automatically locked and the system will be set.

When the system is set

Activating the system; When the system detects abnormalities such as follows, it flashes the turn signal lights and turns on the interior light or the turn lights only (depending on the model) and sounds the security horn and vehicle horn of 30 seconds.

• Unlocking any door without using wireless control
• Any door or hood is forcibly opened.
• The battery terminal is disconnected and then reconnected.
• The system control assembly is disconnected and then reconnected
• Abnormal impact is detected when the impact sensor function is on.

Reactivating the alarm;

Once set, the system automatically resets the alarm after the alarm stops.

The alarm will activate again under the same circumstances described in "Activating the system".

Stopping the Alarm

The alarm will be stopped by the following two ways;

• Turn the ignition key from the "LOCK" to "ON" position.
• Unlock any of the doors by pushing the unlock (cancel) switch.

The system can be cancelled by these ways at the same time.

If the battery becomes discharged due to the vehicle being unused, for a long time etc., when the battery is recharged or replaced, the system will activate the alarm. If this happens, immediately unlock any of the doors by pushing the unlock (cancel) switch, and the alarm will stop.

Testing the system

1. Set the system
2. Insert a wireless remote control key into the key hole on the driver's door handle, and unlock the door.
3. Open the door, and an alarm will sound.
4. Stop the alarm by pushing the unlock (cancel) switch.
5. Repeat this operation for the front passenger's door.

Good luck.

on Nov 08, 2010 | Toyota Pickup Cars & Trucks

2 Answers

How to disable alarm on 95 jaguar xj6


Your Car is equipped with an Electronic Security System. If you disable it (which most probably you can not), you will bet on security of your car. If you still want to disable it, you should contact your Dealer or Authorized Service Station with Purchase Bill. If possible, they'll change locking system to old one.

Apr 24, 2014 | 1995 Jaguar XJ6

1 Answer

Hello, so I'm 20 years old and have recently bought a 2004 Toyota Camry LE from my grandmother because she recently just bought a new car. Car works great, has less than 50K miles on it, never were any...


sounds like the alarm sensors are quite sensitive and r picking up air vibrations or could b a cat climbing on the car u should be able 2 get the alarm ajusted

Sep 08, 2011 | 2004 Toyota Camry

1 Answer

My battery was dead in my 1999 camery this morning. I took the battery out and took it to the auto parts store to get it tested. They told me I needed a new battery so I bought it and brought it home and...


If you have a keyless remote, use it to lock and unlock your doors-if not, lock your door with the door lock, close the door, and unlock the door with the key. This should reset the alarm.

Mar 23, 2011 | 1999 Toyota Camry

1 Answer

I have a 98 Nissan altima gxe and my alarm won't honk when I lock the car but the lights go off when I lock it and Wen I take the alarm off no honk or lights go off Wat can I do


holdboth the lock and unlosk buttons on your remote simultaneously for about five seconds until the lights flash and horn chirps.that should do it.if not i believe these models used a separate horn for security system.possibly fuse for this horn is bad or the horn itself is bad.to see if this horn works lower drivers window.stand outside vehicle and lock doors with remote.wait about a minute and reach in window and MANUALLY unlock and open door(do not use power door lock button)this should cause the system to activate...horn should beep and headlamps should flash.if horn beeps try my first suggestion.if it doesnt beep and just the head lamps flash check fuses and horn for security system.

Feb 21, 2011 | 1998 Nissan Altima

2 Answers

2002 VW Cabrio alarm problem: alarm will not un-set. Door will not lock using the key OR the remote. Hitting "alarm off" button on remote, it unsets, then arms again immediately. With engine...


i have a 2002 vw cabrio and won't start after i took out the battery everbody is telling me that anti-theft is lock mode how do i rest it so i can start my car

Nov 08, 2010 | 2000 Volkswagen Cabrio

1 Answer

We understand that your problem is: My 95 jeep


Have it towed to a car alarm specialist that is familar with Chrysler products. With a little luck they can fix it.. To reset alarm
(if it will work}, try locking drivers door and unlock it with the remote from outside.

The 5 second thing does not sound good.. Usually this locks your ECM out so it will never start. Thinks someone is trying to steal it.

Jul 29, 2010 | Cars & Trucks

1 Answer

Replaced the battery on my 95 Camry and as soon as I open the door the alarm starts sounding. Help.


you set off the alarm.if you do not have the remote,get one as you need to unlock it with the remote.some vehicles if you lock and unlock the passenger door twice,will turn it off. call toyota,they can reset it more than likely with the obd2 computer. in the future,when changing the battery,a back up battery has to be wired in parallell with the main battery before it is disconnected.

Jul 13, 2009 | 1995 Toyota Camry

2 Answers

Alarm won't beep when doors are locked with key fob


hold both the lock and unlock buttons for three seconds the horn will honk and the lights will flash!

Nov 16, 2008 | 2002 Nissan Altima

Not finding what you are looking for?
1995 Toyota Camry Logo

371 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

76051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8265 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...