Question about 1996 Jeep Grand Cherokee

1 Answer

Vehicle has been stalling or engine cutting out at low revs over last fews days, thought it may have been fuel related. Now brakes have little or no power which makes me think that both issues are related and an electrical issue. Any thoughts?

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 35 Answers

If your cars fuel is not electronically controlled... try overhauling the carburator. brake problems? replace the vaccum pump assy.... then drain the air out of the brake fluid drain nipple located in each wheel your going to need assistance here.. someone has to continually step on the brake while u bleed the air bubbles on the fuel line.... when ur help feels the peda is getting heavy.... close the nipple and repeat the procedure on the other tires.... be sure to wear protective glass brake fluid burns.... good luck...

Posted on Jul 19, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Replaced fuel filter and new coil pack which was bad anyway. truck stalled after sudden hesitation for a couple of days. hesitation was on acceleration, then just stalled and restarted then quit. now it...


You aren't telling me what kind of vehicle you have, so I can only be generic on the advice I am giving. This sounds suspiciously like a failed coolant temperature sensor...the one that supplies coolant temperature to the ECM. When these sensors fail, they tell the ECM that the coolant temperature is about -40 degrees F. This makes the ECM send massive amounts of fuel to the injector(s). This can cause flooding on start-up, and will result in the need to feather and rev the engine at isle to keep using the fuel so it doesn't load up in the cylinders and stall the engine. It won't normally set any engine codes, because when the engine is in "choke" or "warm-up", the ECM allow a much greater variance in the sensor readings from the emissions sensors. It's a relatively simple device to replace and not too costly.

Mar 13, 2015 | Cars & Trucks

1 Answer

Is it my fuel pump???? Sorry will post a vid soon but the description is exactly what it does...


Locate the fuel pressure regulator and remove the vacuum line and start the engine, inspect, if vac port leaks fuel , replace regulator, provided your vehicle is equipped with a vacuum operated fuel pressure regulator.

Jan 08, 2014 | Cars & Trucks

1 Answer

2000 Lincoln Ls Stalling While in Motion


Check the water temp sensor. I'm not too familiar with Lincoln, but on GM vehicles a bad water temp sensor will tell the computer that the engine is cold causing it to dump more fuel than it really needs thus flooding the engine. The only way to start the engine is to open the throttle body enough to get the air/fuel ratio right so it will burn. If that doesn't work look at your EGR system to make sure the valve isn't sticking. It should move freely. If it's binding then it can cause similar issues, though not as likely.

Nov 10, 2013 | 2000 Lincoln LS

2 Answers

1996 3.8l firebird stalling


check alternator,check battery connection,fuel filter,air filter,check coils and module,spark plugs,last thing crankshaft sensor.

Feb 12, 2013 | 1996 Pontiac Firebird

2 Answers

1999 mazda 626 lx engine stalls when put in any gear


It can be low fuel pressure issue or clogged fuel pump. Or its engine related issues,---------------
Check the help link mentioned below to troubleshoot the problem: ------

Engine stalls, car stalls while starting, vehicle stalls while starting, Engine stalls and dies, Car stalls and stops,
http://alltypesofpartsreplacing.blogspot.com/2012/12/engine-stallscar-stalls-while.html

------
These will help.
Thanks.

Dec 17, 2012 | 1999 Mazda 626

1 Answer

INTERMITATE ENGINE STALLING FAULT WHEN BRAKING ON


Can you give me some more information? Does it run fine if you do not apply the brakes? This could be a failing brake booster and you are loosing vacuum when the brakes are applied....

Jun 14, 2010 | 2001 BMW 3 Series

2 Answers

Vehicle engine seems to stall at low revs or approaching a stop, been doing that last few days. Now brakes do not seem to have any power assistance. Any thoughts, think this is now not fuel related and...


check for a vacuum leak... the brake booster could be bad and need replacing.
check the vacuum hose that runs from the brake booster to the manifold. Sometimes they crack, leak, or get partially disconnected...the gromet on the booster itself as well.
Good luck...i hope this helps.

Jul 19, 2009 | 1996 Jeep Grand Cherokee

1 Answer

I am currently experiencing engine idle problems, i have recently purchased the vehicle and the engine has been fine until now. When i stop at junctions and the engine is idleing it seems to now and again...


You need to replace your IAC (idle air control valve). The IAC, like it sounds, control the idle of your car. When they go bad they will cause the low idle and stalling. The IAC is located on the throttle body and is usually held on with a couple of screws. It is an easy relatively cheap fix that you can take care of by yourself. Let me know if you have any more questions. Thanks for rating my response and for using FixYa!

Aug 04, 2008 | 2001 BMW Z3

Not finding what you are looking for?
1996 Jeep Grand Cherokee Logo

119 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

76682 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...