Question about 1992 Honda Accord

1 Answer

Where is the transmission computer - 1992 Honda Accord

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert whose answer got voted for 500 times.

  • Master
  • 1,050 Answers

Under the passenger side front floor mat. Pull the carpet back and you will see both computers, the engine and the transmission. The transmission computer is a very common failure item, do not replace it with a used one, there are rebuilts available on Ebay.

Posted on Jul 19, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

3 Answers

I have a 1999 bmw 323I I bought a transmission.thinking that it was the transmission cause it doesnt drive or revorce.they put in the transmission and still doing the same thing.what could it be!!

Could be the shifter cable broken, bad wiring,bad computer, or(If you bought a used on) could be a bad transmission. Unlikely both transmissions would have the exact same problem though.

Apr 25, 2015 | 1999 BMW 323i

1 Answer

2010 camry in limp mode

if you had someone put in the engine they should have reset the computers-its not transmission in limp mode its your engine and the computers have to be flashed to the engine most shops dont have the software to flash or reprogram the computers as to the transmission same if you put the engine you can ask a dealer what options you have, to get the computers reprogrammed

May 23, 2014 | 2010 Toyota Camry

1 Answer

Ford Explorer Limited 1996 4 liter engine transmission replacement cost

No such thing there may only be 3 cars in the entire world that would have to program a transmission replacement if and only if needed its to clear any transmission codes out of the computer but if the problem dont exsist anymore the computer mil lamp goes out anyway

Mar 10, 2014 | 1996 Ford Explorer

1 Answer

Shift solenoid transmission

thats the dealer for you you can scan the codes if it says shift solenoid thats what id change i have had good luck as a tech doing so

Jul 10, 2013 | 2008 Mercury Milan

1 Answer

Transmission selonoid assambly

Diagnostic Test Code (DTC) P1750 is a "generic" OBD fault code that is output by your engine control computer to let you know that the transmission control computer is reporting a problem with one of the transmission control solenoids. To find out the nature of the problem and which of the solenoids has the failure, you must access your transmission control module and retrieve the fault codes from there.

The transmission control computer outputs 2-digit codes that are not accessible by a generic OBD code reader.

Jan 20, 2012 | 1998 Mitsubishi Montero Sport

2 Answers

Can you explain to me how to get to the sensor located underneath my dash that has to do with my transmission shifting? And what that fuse is called? in my 1999 buick park avenue


Jan 22, 2011 | Buick Park Avenue Cars & Trucks

1 Answer

1996 rodeo 4x4 transmission wire diagram changing transmission from a standard to an auto trans but need to wire a five wire plug at lower drivers side of transmission as it dose not have one in the truck...

You are going to need to purchase the computer that came with the transmission you are putting into the vehicle. A manual transmission computer is not programmed to monitor the same stuff as an automatic transmission. It would be the equivalent of using microsoft word the fix a digital photograph. The program is just not up to the job... I would just buy the whole wiring harness and computer. Then you know it will work. Good luck.

Nov 10, 2009 | 1995 Isuzu Rodeo

1 Answer

2001 Town and Country Transmission and Speedometer not working ri

It was probably the computer from the beginning,and the placement of it,,,well Chrysler has always been a little mystic,thats why i work with GM. ;)

Aug 25, 2009 | 1998 Dodge Ram 1500 4WD

1 Answer

I have a '91 deville with 70k. The digital speedometer fluxuates sometimes goes to 0mph. The transmission shifting follows the speedometer. My local mechanic replaced the vss twice. First time it lasted 1...

I don't believe the problem is in the vehicle speed sensor. I suspect the problem may be the computer. The speed sensor is just a magnet inside the transmission with an induction coil outside to create an electrical signal every time the transmission output shaft turns. That signal goes to the computer and the computer tells the transmission when and how to shift and displays the speed on your electronic display. I would start by having a reputable transmission shop check out the transmission, then take it to a good mechanic to have him check the computer. It is a relatively expensive fix, but with only 70,000 miles on the Caddy, it should be worth it.

Feb 22, 2009 | 1991 Cadillac DeVille

Not finding what you are looking for?
1992 Honda Accord Logo

Related Topics:

160 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts


Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides