SOURCE: ball joints repair on a 1997 chevy blazer
If they are the original ball joints you will have to remove the rivets on them. The new ones should come with replacement nut and bolts. You will have to remove the brakes, and move the steering knuckle out of the way (You don't have to remove the tie rod end). It isn't difficult, just time consuming. You can do it in the driveway on stands. Make sure you have a couple hours, and a case of beer.
SOURCE: The 1997 Chevy Malibu does not have a dipstick for the transmissi
with just a fluid and filter change it is 7.4 qts. heres how to check it!! jack up car get it as level as possible, start car and let run, get under car when running and take out the plug just in back of tranny pan. if car is not running you will lose fluid, so make sure its running. before removing plug, go thru all gears and end back in park, if fluid just seeps out you are ok!! if it pours out it is to full.place pan to catch fluid,to add the red cap on top of tranny under hood on drivers side about 2 feet down, it is under exhaust on v6. use a tranny funnel to reach hole to fill.
SOURCE: 1997 chevy blazer heater does not blow already
check the blower motor resistor, it on passenger side under dash bolted to heater box, those go bad often, hope this is helpful.
SOURCE: where is the fuel pump relay located in a 1997 chevy blazer 4-dr.
In the glove box behind a plastic panel. There are 3 relays in there. The fuel pump is the one closest to the drivers side.
145 views
Usually answered in minutes!
×