Question about 2007 Volkswagen Jetta 2.5 Sedan

3 Answers

Replaced all tires, tire pressure monitor came on, never disapear

I recently changed all 4 tires on my 2007 Jetta 2.0T. the tire pressure warning light came on and does not turn off. I checked the pressure, they are all even and to the VW specs. What do I do?

Posted by on

Ad

3 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

What are wrench and min button/ have no owner's manual~

Posted on Dec 11, 2014

Ad
  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 75 Answers

Air pressure sensor was knock off on install. see dealer.

Posted on Jul 27, 2009

Ad
  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 154 Answers

Make sure all tire pressures are fine.. my have to go to dealer have them ck semsors

Posted on Jul 19, 2009

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: How do you reset a low tire pressure warning on a 2008 Jetta?

Reset the tire pressure warning, same as you would any service issue. Insert key in ignition, hold wrench button and min button, then start engine.

Posted on Jun 08, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Tyre pressure warning light showing when pressures are correct


Hi, the tire pressure monitor detects any changes in the tire inflation pressure. Therefore, it must initialize and store it in its memory if the tires or wheels have been replaced, re-inflated or the tires have been rotated. You can re-initialize the system by following these steps:

1. Check and make sure that your tires are inflated to the correct pressure

2. Turn the ignition switch to the ON position. If the low tire pressure warning light comes on, push and hold the tire pressure warning reset switch (in the glove box) until the warning light turns off and then release the switch.

3. Now press and hold the tire pressure warning reset switch until the low tire pressure warning light blinks three times.

4. Initialization is *not* completed until driving at the vehicle speed of 19 mph or over for more than one hour. the tire pressure monitoring starts when initialization is completed.

May 13, 2011 | Renault 18I Cars & Trucks

1 Answer

Own a 2004 VW Phaeton V8. Recently bought it with 56,000 miles. Tire pressure warning indicator is on. Just filled tires and pressure is at correct level. Seems like a common problem. Is there anything...


Hi. It is very difficult to remove the Tire pressure warning system.
To reset the light, the vehicle must be driven for a period of about 20 minutes.After the pressures have been check(don't forget the spare, unless you have set the monitoring of it off). If this does not reset it, then there may be a fault in the system. This needs to be rectified by a VW franchise. The sensors are often damaged when the tyres are replaced.
Hope this helps.

Apr 21, 2011 | 2005 Volkswagen Phaeton

1 Answer

What does an ! in a circle mean with ( ) around it


This (!) symbol is your TIRE PRESSURE MONITORING SYSTEM (TPMS) warning light.
The manual has this to say about it:
This system monitors tire pressure. if the low tire pressure warning light illuminates, check the tire pressure in all four tires. Adjust the low tire pressure to the recommended cold tire pressure shown on the Tire and Loading information label located in the driver's door opening. After tire pressures are adjusted, the vehicle will need to be driven at speeds above 16 MPH (25 km/h) to activate the TPMS and turn off the low tire pressure warning light.

Mar 02, 2011 | Nissan Pathfinder Cars & Trucks

1 Answer

How to reset the pressure monitoring system warning light on Mazda 3


Read the manual on the mazda site... it's very helpful. Have you changed tires recently? have a spare on?

"After adjusting the tire air pressures, it may
require some time for the TPMS warning
light to go out. If the TPMS warning light
remains illuminated, drive the vehicle at a
speed of at least 25 km/h (16 mph) for 10
minutes, and then verify that it goes out."

Might help...

Feb 03, 2011 | 2008 Mazda Mazda3 Hatchback

2 Answers

WHAT IS THIS WARNING SIGNAL ( ! ) THANKS,


Thats your tire Pressure. One or more of your tires are low. check then and correct them then the light will go off after a while. Good luck
.

Dec 21, 2010 | 2007 Volkswagen Jetta 2.5 Sedan

2 Answers

How do I reset the low tire pressure indicator light on my 2010 Jetta TDI? I had to replace the tire and now have all four tires with the recommended pressure and have driven over 50 miles... but the...


With the ignition on, but before you start the car, press and hold the the "Set" button located in front of the gearshift.
You should hear a tone after holding it for a few seconds. Once you hear the town you can release the button and the light should be reset.

Oct 26, 2009 | Volkswagen Jetta Cars & Trucks

1 Answer

Changed right front tire now reads zero on dash light is on


Your tire pressure monitor needs to be reset whenever you change or rotate your tires...

1. check and make sure that your tires are inflated to the correct pressure

2. turn the ignition switch to the ON position. If the low tire pressure warning light comes on, push and hold the tire pressure warning reset switch (think the switch is in the glovebox, but not sure) until the warning light turns off and then release the switch.

3. now press and hold the tire pressure warning reset switch until the low tire pressure warning light blinks three times.

4. initialization is *not* completed until driving at the vehicle speed of 19 mph or over for more than one hour. the tire pressure monitoring starts when initialization is completed.

Aug 24, 2009 | 2008 Chevrolet Tahoe

3 Answers

The check tire pressure light and ABS auto traction sensor light keep coming on. Tire pressure is good


The tire pressure monitor detects any changes in the tire inflation pressure. Therefore, it must initialize and store it in its memory if the tires or wheels have been replaced, re-inflated or the tires have been rotated. You should be able to re-initialize the system by following these steps:

1. check and make sure that your tires are inflated to the correct pressure

2. turn the ignition switch to the ON position. If the low tire pressure warning light comes on, push and hold the tire pressure warning reset switch (think the switch is in the glovebox, but not sure) until the warning light turns off and then release the switch.

3. now press and hold the tire pressure warning reset switch until the low tire pressure warning light blinks three times.

4. initialization is *not* completed until driving at the vehicle speed of 19 mph or over for more than one hour. the tire pressure monitoring starts when initialization is completed.

Aug 11, 2009 | 2004 Cadillac Deville

1 Answer

How do you reset a low tire pressure warning on a 2008 Jetta?


Reset the tire pressure warning, same as you would any service issue. Insert key in ignition, hold wrench button and min button, then start engine.

Apr 30, 2009 | 2007 Volkswagen Jetta 2.5 Sedan

1 Answer

Check tire pressure warning


check tire pressures with a gauge and set to the specs either in door jam or in glove box. your car must be equipt with tire preasure monitoring system so the sensors are inside the wheel normally part of the valvestem.

Mar 28, 2009 | 2005 Pontiac Grand Prix

Not finding what you are looking for?
2007 Volkswagen Jetta 2.5 Sedan Logo

734 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volkswagen Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

yadayada
yadayada

Level 3 Expert

76649 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8518 Answers

Are you a Volkswagen Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...