Question about 1989 Ford Crown Victoria

1 Answer

What is the fuel pressure for 89 Ford Crown Vic with 5.0. Idle and blipped throttle

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Governor:

    An expert whose answer got voted for 20 times.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 10 Answers

34-45 psi. for EFI. No seperate pressures between idle and WOT.

Posted on Jul 21, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a '97 4.6 ford crown vic. Only starts up when i apply gas n dies when i let off the pedal any ideas?


Most likely the Idle Air Control Motor, but you could have other issues suck as a leaking fuel pressure regulator, bad EGR valve, or massive vacuum leak.

Dec 01, 2014 | 1997 Ford Crown Victoria

1 Answer

84 crown vic wont start


IF THE PROBLEM IS NOT THE FUEL PUMP, FUEL RELAY, FUEL PRESSURE, AND OR FUSE WAT ELSE COULD B THE PROBLEM

Dec 03, 2011 | 1984 Ford Crown Victoria

1 Answer

My 96 crown vic police interceptor, cranks won't start without spraying starter fluid.. the car won't start without spraying starter fluid into air intake hose to carb...


starting fluid is a thing of the past. dont use it. this car doesnt have a carb, its a throttle body/ electronic fuel injection system. you most likely have a fuel pump or fuel pressure regulator issue. test the fuel pressure, should be anywheres from 35-50 psi

Oct 11, 2011 | 1996 Ford Crown Victoria

1 Answer

Just picked up and 85 Crown Vic with 69k miles on it. Starts right up, but idle is very high. It sat for over a year in a garage without running, but fired right up when jumped. Where can I fine tune-up...


This should be fuel injected. But it is throttle body and it is an early one. It has a choke coil mounted to the passenger side of the throttle body. It doesn't run a choke it just controls fast idle. It might be bad or unhooked. Check for power on this.

Jul 07, 2010 | 1985 Ford Crown Victoria

1 Answer

My 1996 crown vic will not start motos turns over and trys to start but wont I have replaced intake manifold spark pulgs. motor has spark


basics,,,air,,fuel,,spark,,compression,,timing,,,pull a few plugs,,smell them for fuel,,if dry,,,take snorkel off throttle body,, open throttle body or flap half way,,spay a little starting fluid or injector spay into throttle put the snorkel back on see if motor fires up,,if so then ck fuel delivery & pressure,,,,hope it helped

May 28, 2010 | 1996 Ford Crown Victoria

1 Answer

Cant loc the idle air control vavlve located on a 1988 crown vic


attached to the throttle body,looks like an electric motor bolted to a square piece with the corners notched out,with 2 wire connector on the end.

Feb 19, 2010 | 1988 Ford Crown Victoria

1 Answer

SPUTTER AND PINGING OR KNOCKING


Try higher octane and decarbon engine. fuel filter good idea also. sounds like detonation

Jul 14, 2009 | 1998 Ford Crown Victoria

1 Answer

1999 crown vic keeps getting air locked at the fuel rail?


check your fuel pressure
if you dont have enough pressure this will happen
when the fuel pressure is good the system will just push the air out through the injectors or the fuel return line

May 15, 2009 | 1998 Ford Crown Victoria

2 Answers

We have a problem with a 1992 crown vic. It bogs


run a presher test on your fuel pump.check your fuel filter. have nice day

Apr 02, 2009 | 1992 Ford Crown Victoria

1 Answer

2005 Crown Vic Police Interceptor: Starts then stalls


Have you checked the fuel filter. Fuel pump will pressure up, but fuel filter could be clogged and not work without the pressure of the fuel pump.

Nov 27, 2008 | 2005 Ford Crown Victoria

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

226 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75005 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

fordexpert

Level 3 Expert

5470 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...