Question about 2001 Oldsmobile Alero

1 Answer

Rear window fell into door fell of track How do I get panel off to get to window

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 13 Answers

The is a little square shaped thing under handle pop that off you will see screws un screw then pop sides around edge of door the panel should pop right off

Posted on Jul 24, 2009

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 713 Answers

SOURCE: Right rear window is off the tracks. How do I remove the panel?

if the window is off track the regulator is probably bad. to remove the door panel should be a couple of screws by the inside pull handle and possibly one by the door handle itself also check the bottom of the door for any then just pull it off and lift up to clear latches and remove plastic film to get to inside of the door

Posted on Aug 31, 2009

  • 1986 Answers

SOURCE: left rear window off track

you'll need to remove your door panel (screws are by the door handle, arm rest, under door and side of door) and pull back the weather seal (can't reuse it, but it's not that important) and you will be able to access everything.

Posted on Aug 13, 2009

  • 295 Answers

SOURCE: how remove the rear inside door panel on a 2001 oldmobile aurora

The inner door panel is held in by clips and screw.
Look at the door near the door handle there should be screws holding it in and along the outer edge of the door. Once loose, and the door handle removed or the arm rest removed. The door panel then prys out , because of the clips that hold it on. Then pops out by applying pressure to the panel upward to the top of the door. The clips always break because of the design and plastic.

Good luck

Posted on Mar 21, 2009

SOURCE: passenger door window off track

Here is a guide for taking the door panel off and replacing the window regulator. It is for a grand am but I assume it's pretty close.

http://www.a1electric.com/grandam.htm


Posted on Sep 22, 2008

  • 1986 Answers

SOURCE: REMOVING A DOOR PANEL

You'll need to remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. If needed, you can pull back the weather seal (can't reuse it, but it's not that important) and you will be able to access everything inside the door

Posted on Aug 14, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Drivers window fell off the track. how do I put it back?


just remove the door card/panel , lower the regulator/winder and manipulate it back into position then secure it.
You may want to investigate why it came off.
h

Jun 14, 2015 | 2009 Cadillac CTS

1 Answer

How to fix the right passenger rear window that fell off track to 1994 Mercedes-Benz e320 right passenger rear


REMOVE THE REAR DOOR PANEL AND REPLACE THE REGULATOR ASSY. VERY COMMON ON THIS MODEL.

Apr 20, 2015 | Mercedes-Benz Cars & Trucks

2 Answers

How to repair drivers window


Remove door inner panel.. Look for why it fell .. It is off the lift track, probably something broke.. find broken part and replace or repair.. its not uncommon for window regulators to break.

May 31, 2014 | 2001 Pontiac Grand Am SE

1 Answer

Driver rear window came off track


And you don't see the problem?

How about a broken window regulator!

May 08, 2014 | 2007 Hummer H3

2 Answers

Rear door panel removal:rear door window just fell down oneday and i was told it might just be off the track. it has electric windows


Its not off the track!!
You just lost the holders clipping your window glass piece.
  • Look for screws in door panel or around the speaker vents.
  • If you are sure that the speaker cant be removed without opening the door panel then read this below.
  • Mostly seen near areas like door lever(inside), power window switch set, bottom and each sides of the whole panel.
  • If its manual window, then look for a circle clip in between the winding window lever and the door panel. Plunge screw driver between them a make a gap then look.
  • Assure that all clips or screws which obstacles the removal of the panel.
  • Simply pull the panel from sides towards you

Sep 23, 2011 | 2007 Chevrolet Malibu SS Sedan New Cars

1 Answer

Passenger side window came off trac and is sitting in door


you have to remove the door panel..unbolt the tracking from inside the door..slide the windows back inside the track rails....push window all the way up..tape the window so that id does not fall back down or have someone hold window up while you rebolt the track to the door.replace door panel....the tracks move over time and that it why the window fell.

Jan 26, 2011 | 2004 Cadillac Deville

1 Answer

2006 volkswagen beetle convertible rear passenger window fell off track- how do i get to it to fix it?


On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge.

Sep 10, 2009 | 2006 Volkswagen New Beetle

1 Answer

Window fell off the runner in the door


The door panel has screws on the bottom of the door panel. If there is carpet on the base of the door panel, the holes are hidden within the carpet.

Also, you have to remove the arm rest, typically it has 2 screws holding it to door and plastic push-in door panel clips on the sides. You can use a screw driver to help pop them out.

The door panel, when loose from door, lift up and off. Take your time so you dont break any tabs on the back side.

If the window is falling off the track, there is a small plastic tab that is mounted to glass or track; it slides in the window channel on front and rear tracks.

You can get this part at your local auto parts house, in HELP section.

Feb 16, 2009 | 1991 Chevrolet S-10

1 Answer

Rear window will not stay up


You fist have to take the rear door panel off to see if the window fell of the track. If it has electric windows determine if the moto is running.

Nov 26, 2008 | 2002 Buick Century

Not finding what you are looking for?
2001 Oldsmobile Alero Logo

Related Topics:

320 people viewed this question

Ask a Question

Usually answered in minutes!

Top Oldsmobile Experts

yadayada
yadayada

Level 3 Expert

76682 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8531 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...