Question about 1996 Ford Explorer

1 Answer

Over heating 1996 ford explorer - 1996 Ford Explorer

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 521 Answers

Ccooling fan not workinig, bad realy for fan, stuck thermostat, to low coolant level due to leakage.

Posted on Jul 18, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Can you use atf+4 transmission fluid in a 1996 ford explorer


The transmission fluid you use should have a Ford approval number on the back of the bottle. If it doesn't, then any warranty done by a Ford Dealer on the trans since 1996 is void. Most trans have a 100K mile warranty when new and after any complete replacements. Using the wrong Spec. trans fluid will damage the transmission and always check the level when the engine is hot as ATF expands when heated. Mobil ATF D/M will work... Mobil Synthetic ATF won't in your Explorer! Ford comes with Exxon ATF from the factory and owners state that it's not the best.

Apr 24, 2015 | 1996 Ford Explorer

1 Answer

1996 ford explorer with no heat, replaced blem and thermostat still no heat


check your heater control cable and check your coolant control valve for vacuum operations. control valve located under hood @ coolant hoses leading to the heater core. cable operates a blend door inside truck under dash/behind glove box.. this should help

Aug 31, 2012 | 1996 Ford Explorer

1 Answer

Hi Bob, we hav a 1996 ford explorer and it has no heat, we replaced the Blem and the thermostat and it still has no heat, any ideas?


How long have you had the vehicle? If you purchased used. someone may have bypassed the core. Make sure all lines are connected.
Is the blend door moving when you select heat/cool?

Aug 31, 2012 | 1996 Ford Explorer

2 Answers

How do you fix the oxygen sensor for 1996 ford explorer


pctech1_31.jpg

NOTE: If excessive force is needed to remove heated oxygen sensor, lubricate heated oxygen sensor with Penetrating Lubricant prior to removal.

  1. Disconnect battery ground cable.
  2. Disconnect heated oxygen sensor from engine control sensor extension wiring.
  3. On 3.0L, 4.0L and 5.0L raise and support vehicle.
  4. Remove heated oxygen sensors from exhaust manifold, inlet pipe, or dual converter Y pipe, using an Oxygen Sensor Wrench.
Installation
  1. To install, reverse the removal procedure.
  2. Apply a light coat of anti-seize compound to thread.
  3. Tighten heated oxygen sensors to 36-46 Nm (27-33 lb-ft).

Mar 06, 2011 | 1996 Ford Explorer

1 Answer

1996 Ford Explorer XLT V6 - will start but stalls after 5 mins.


This can be cause by many things, such as a fuel pump going bad / or is bad, fuel injectors need cleaned / replaced, fuel filter dirty just to name a few. Could also have a vapor lock where the fuel line is running to close to a heat source like the manifold or engine and the heat creates a vacum in the fuel line stopping the flow of fuel. Best bet have a garage repair shop look at it. To many hit and miss causes.

Mar 10, 2010 | 1996 Ford Explorer

1 Answer

Heat, A/C cuts in and out. 96 E.B Explorer 4.0


It most likely is the heater control assy. say this a lot when i worked for ford.

Mar 29, 2009 | 1996 Ford Explorer

2 Answers

1996 Ford explorer 4x4


there is a vacuum line off that controls the 4x4

Sep 04, 2008 | 1996 Ford Explorer

1 Answer

Heater core replacement for 1996 explorer (eddie Bauer ) 8cyl


i have a 1996 ford xlt explorer my heat dose not work ihave changed the fan is blowing water is flowing

Aug 28, 2008 | 1998 Ford Explorer

Not finding what you are looking for?
1996 Ford Explorer Logo

Related Topics:

91 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76848 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

fordexpert

Level 3 Expert

5546 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...