Question about Jaguar XJS

Open Question

1995 XJS Jaguar, 2x2, Convertible top wont go up and down

1995 XJS Jaguar, 2-Door Convertible 4.0L Straight 6 Cylinder Engine, Auto Trans, Front Wheel Drive.

Issue: Convertible top wont go up and down.

Would like to know the names /part numbers of all the control modules assoiciated with this car, and what the modules do.


Thank you

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

pugwash814
  • 377 Answers

SOURCE: 1995 Jaguar convertable XJS quarter light windows wont go up

The rear windows are controlled by a timer in the top's ECU. If
the rear windows stop fully closing before your top is closed, the
problem MAY be with top's hydraulic system.

Check your top's hydraulic reserve tank for low fluid level. Lack
of fluid will greatly delay the top's closing sequence, leaving
those rear windows partially open.
Your top's hydraulic pump system is located beneath the right side
of the cubby/storage box behind the front seats. Raise the cover
and you'll see a removable trim panel on the right side. The pump
is behind that access panel.

You can use power steering fluid to top off the tank, but don't
fill it above level indicator line. You may have to add more fluid
after you cycle the top up and down to get the air bubbles out of
the lines.
It could also be a relay. On a 95 the relays that are in the trunk above the battery.
Perhaps, just switching the relays might prove which one is failing..

Posted on Mar 27, 2010

dealt_soul
  • 296 Answers

SOURCE: jaguar convertible

Download this document and you may find it.

www.arh.ee/jaguar/Xjs_help.doc

Posted on Jan 19, 2009

jeepz
  • 65 Answers

SOURCE: 1995 Toyota Toyota Tacoma 4WD 6 cylinder 3.4

no, you will tear up the differential.

Posted on Dec 19, 2009

tburtk
  • 158 Answers

SOURCE: 1995 DODGE RAM 2500 4WD ENGAGEMENT PROBLEM!!!

You have vacumn lines the run to your transfer case and then to the vacumn motor on the front axle. you need to check the lines and connections. If vacumn is working fine, then motor on front axle is bad.

Posted on May 13, 2010

daves944
  • 1050 Answers

SOURCE: transmission hesitates going in drive. shifts

A common problem with Mazdas, it's a sign that the transmission is worn out. There is a seal on a hydraulic system that activates the clutch for Drive. When this seal wears out, it leaks and it takes longer for the clutch to engage. The only way to repair it is to take the transmission apart. You may be told to try flushing the the transmission, chances are this won't work. The seal needs to be replaced.

Posted on Jul 10, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Spark plug firing order


Hello Harvey, My information shows firing order of 123456. #1 being passenger's front cylinder and #2 being driver's front cylinder.

Jul 30, 2014 | 1995 Isuzu Rodeo

1 Answer

Jaguar xjs 1995 v12 engine lack of power


I would start with a tune up, then isolate any symptoms other than lack of power if it persists, like rough idle, sputtering, jerking, engine trouble codes, etc.

Jul 30, 2014 | 1995 Jaguar XJS

1 Answer

Obd connector location for 1995 jaguar xj6


the data link connector is located under the dash. Next to the centre console expect for xjs and for an xjs it is under the dash near the drivers kick panel in front of the door

Dec 14, 2013 | Cars & Trucks

1 Answer

How to find and change fuse for drivers seat in 1995 Jaguar XJS convertible?


hi, there are fuse pannels on the side of the footwells on both side of your car, i know the side lights, head lights are on the left hand side (in britian left meaning (near side to the kerb)) not looking at the car from outside

Sep 07, 2010 | Jaguar XJS Cars & Trucks

1 Answer

1995 Jaguar convertable XJS quarter light windows wont go up


The rear windows are controlled by a timer in the top's ECU. If
the rear windows stop fully closing before your top is closed, the
problem MAY be with top's hydraulic system.

Check your top's hydraulic reserve tank for low fluid level. Lack
of fluid will greatly delay the top's closing sequence, leaving
those rear windows partially open.
Your top's hydraulic pump system is located beneath the right side
of the cubby/storage box behind the front seats. Raise the cover
and you'll see a removable trim panel on the right side. The pump
is behind that access panel.

You can use power steering fluid to top off the tank, but don't
fill it above level indicator line. You may have to add more fluid
after you cycle the top up and down to get the air bubbles out of
the lines.
It could also be a relay. On a 95 the relays that are in the trunk above the battery.
Perhaps, just switching the relays might prove which one is failing..

Mar 24, 2010 | 1995 Jaguar XJ-R

1 Answer

Where is the right side fuse panel on a 1995 XJS Convertible ?


Right side fuse panel is behind panel under air bag wood facia. pull it & it swings downard,revealing a black fuse cover. Good luck!

Jul 05, 2009 | 1995 Jaguar XJ6

2 Answers

Front Bumper


They are regularly advertised on Ebay. Depends where you are though!

Jan 08, 2009 | 1995 Jaguar XJ6

1 Answer

Jaguar convertible


Download this document and you may find it.

www.arh.ee/jaguar/Xjs_help.doc

Sep 29, 2008 | 1986 Jaguar XJSC

2 Answers

1988 Jaguar Vanden replace headlight


What you need to do is remove the 2 screws on the top bezel from inside the engine bay, then underneath the outer corner of the plastic headlamp surround there is a philips screw, (put your head under neath car near from wheel) loosen the screw, do not remove it, now the headlamp plastic bezel/surround will come free enough so you can get a philips screwdriver in through the middle of the headlamp surround, there is a chrome retaining ring holding the headlamp in place, loosen the 3 philips screws (do not remove) The retaining ring will rotate and you can slide the ring out from the outer edge of the headlamp surround. The headlamp will then come out throught the middle of the surround, disconnect the 3 pin multiplug and reverse process for install.

May 18, 2008 | 2000 Jaguar Den Plas Supercharged

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

342 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jaguar Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

yadayada
yadayada

Level 3 Expert

75822 Answers

SPEEDY CAR WORK SHOP...

Level 2 Expert

489 Answers

Are you a Jaguar Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...