Question about 2002 Honda S2000

2 Answers

SRS light stays on

After a heavy hail storm my dealer fitted a new roof. Now the SRS light stays on. the dealer changed the fuse box checked all wires then after 2kms it came back on.

Posted by on

  • go4itjeff Sep 06, 2009

    All is now fixed. There is a sensor for the airbag where the seat belt is bolted to the chassis & this had water damage. Now replaced all is okay. thanks for help & I hope this answer may help someone with the same problem.

  • silver top May 11, 2010

    srs may i suggest you check all the seatbeltwires under the front seats are secure(unplug /clean/replug ) then check the rear seat belts ? also ensure the rear seats are firmly locked in position if they are fold down ? try foldding then slam firmly into lock positions these may have been disturbed whilst renewing roof cover ?

×

Ad

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 4 Answers
Ad
  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 36 Answers

The Supplemental Restraint System (SRS) is definitely something you want working. Those airbags can be a lifesaver in an accident. Take it back to the Dealer and tell them it wasn't broke before they worked on you car, it's broke now after they worked on it, and stress how much of a Liability this might be. Okay, okay... just ask them to fix it because you would like to have it in case you are involved in an accident. My Civic's Service Repair Manual (from Honda), says Take it To Your Dealer (see below)
===========================================
All SRS electrical wiring harnesses are covered with yellow insulation. Related components are located in the steering column, front console, dashboard, dashboard lower panel, and in the dashboard above the glove box.
Do not use electrical equipment on these circuits.

-WARNING
To avoid rendering the SRS inoperative, which could lead to personal iniury or death in the event ol severe frontal collision, all SRS service work must be pertormed by an authorized Honda dealer

Posted on Jul 19, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2001 e320 wdb210 srs light on blinks once stays on? help


You should have it scanned but before that make sure you didn't blow any fuses in fuse panel or box

Dec 09, 2015 | Cars & Trucks

1 Answer

Had a leak in front windshield window after it was replaced. After heavy rain this morning, some water was on my steering wheel and some on steering column. Now my SRS light stays on & horn does not...


Depending on the year and make of this car or truck when you turn on the key the system runs a test and if the problem was repaired it will shut light off, if the light remains on then theres a problem. even if you had a scan tool reset the light it will come right back on as soon as the engine is started, this sounds like something got wey and shorted out, the first thing i would check is the fuses and then look around at the bottom of the steering column and check connections for water or rusted terminals,inside the steering wheel is a clock spring that contains wires for horn air bag and other controls if cars has them like cruise or steering wheel radio controls, the part called clock spring is what makes the wheel be able to turn without ripping wires, it like a retractable bunch of wires and sometimes they go bad just from turnning the wheel so often, heres a picture of it, chrysler is famous for problems with this, good day.johnjohn2_97.jpg

Apr 13, 2011 | Toyota Sienna Cars & Trucks

3 Answers

What is the red warning light "SRS"


It is the air bag malfunction warning light.

This will show if the fuse for the air bag operation has blown or if the fuse is removed and not replaced. There can also be other causes such as problems with the wiring or wiring connections.

As a first step check the fuse panel and ensure the fuse is OK. The fuse location is covered in the owner's manual.

Dec 01, 2010 | 1992 Mercedes-Benz E-Class

1 Answer

Battery was low and put in new battery,problem SRC Light stays on how can I reset the SRC light?


I'm guessing you mean the SRS light, yes. When you have a bad battery the battery voltage can drop below 10 volts. The SRS unit detects this voltage loss and set a DTC (diagnostic trouble code) for an internal SRS unit failure. You have to erase the DTC memory. You'll need an SCS service connector tool (P/N 07PAZ-0010100) You can order one from your local honda dealer. Don't worry its not more than $10. Then you'll have to find the MES 2pin connector located in the upper right hand corner of the drivers underdash fuse box. It can be gray, green or yellow in color. 1.)Turn the ignition switch off. 2.)Unplug the MES connector from the fuse box and plug your SCS special tool into the MES connector. 3.) Turn the ignition switch on. 4.) The (red) SRS light in the dash will come on for 6 seconds and then go off. Remove the SCS tool from the MES (2P) connector within 4 sec. after the SRS light went off. 5.) The SRS light comes on again. Reconnect the SCS tool to the MES (2P) connector within 4 seconds after the SRS light came on. 6.) The SRS light goes off. Remove the SCS tool from the MES (2P) connector within 4 sec. 7.) The SRS light indicates that the memory is erased by blinking twice. 8.) Turn the ignition switch off and wait ten seconds. You may have to do this procedure a few time to get the steps correct. If this sounds to complicated I'm sure your local Honda dealer would be happy to reset the light for you for no charge. Just let them know that the battery was recently replaced and you think that the SRS light came on due to low battery voltage. -Hope this helps:)

Jan 13, 2010 | 1997 Honda Civic

1 Answer

How to replace the rear passenger tail light lens on 1989 Olds


open trunk remove screws or nuts from inside trunk undo wires and reinstall new one.hope i helped..

Jul 06, 2009 | 1989 Oldsmobile Ninety Eight

1 Answer

Honda crv 2000 computer reset


Ok,
1. ensure ignition off
2 . bridge the 2 pin connector, Put a piece of wire across both terminals
3.switch ignition on
4. SRS lamp should illuminate for 6 seconds
5.disconnect the bridge wire within 4 seconds of the warning lamp extinguishing
6.SRS lamp should illuminate 2 times, Codes erased
7.switch ignition off
8 Wait 10 seconds. switch ignition on and check SRS warning lamp operation.
hope this helps

Feb 18, 2009 | 2006 Honda CR-V

1 Answer

I have a 1994, 80 Series GX Landcruiser. After driving through heavy storms all the dashboard lights came on simultaniously (including battery charge light, ATF Oil temperature, engine oil temperature,...


I worked on an expedition that the moon roof got left opened for 4hrs in heavy rain and I had to replace several relays under the hood and some in the fuse box under the dash on the driverside my best advise to you there should be diagrams on the fuse cover box itself telling you which one is what but let the car dry out on its own 2-3 days and then go to work on finding out what fuses or relays you have to replace and if your owners manual does not give you exactly what they are stop by a dealer and in the parts department they can print you out a diagram

Jan 22, 2009 | 1994 Toyota Land Cruiser

1 Answer

SRS light stays on


I have 2002 Odyssey( 59000 miles without warranty). Several months ago the SRS light stayed on after I started the car. Some people said the dealers usually charge $ 80 to 95 to reset the light. Today I sent the car to dealer. After checking the car, they told me the car is under warranty, the parts and repairing are free.

Jun 16, 2008 | 2002 Honda Odyssey

Not finding what you are looking for?
2002 Honda S2000 Logo

370 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...