There was no 2001 Caravans built with 3.3 motor without A/C, so no belt will be listed , there might be a belt that fits , but not always.You could try unplugging the compressor clutch , depending on whats seized you may have to put a new clutch bearing in, but that should be around $20, then just let it freewheel.
SOURCE: 1993 DODGE CARAVAN SERPENTINE BELT DIAGRAM
Link for a 99 - 3.3.L, but diagram should be same. Scroll down to figure 11 when you click on this link.
http://www.autozone.com/addVehicleId,2546504/initialAction,repairGuide/shopping/repairGuide.htm?pageId=0900c1528003c186
SOURCE: how to route serpentine belt for 1995 dodge caravan 3.3 no ac
Click on link below and scroll down that page until you see the 3.3L. click on picture to enlarge it.
http://www.autozone.com/addVehicleId,1956001/initialAction,repairGuide/shopping/repairGuide.htm?pageId=0900c1528006a6c8
SOURCE: replace serpentine belt on 2004 dodge caravan
Hello
Here is a link for belt replacement
RD
http://www.autozone.com/addVehicleId,2945902/initialAction,repairGuide/shopping/repairGuide.htm?pageId=0900c152800b639e
SOURCE: fix serpentine belt on 1998 dodge Caravan
If it's the diagram you're looking for, click on the link below and enter your engine size. You will be directed to a page that has a Belt Routing Diagram. Select the appropriate one (some Caravans do not have AC) and you will receive the diagram for your vehicle.
1998 Dodge Caravan Serpentine Belt Diagram
SOURCE: Need serpentine belt routing diagram for 1994 Dodge grand caravan
3.3L?
Looking at the engine from front (right side of the Van): Stating at the Top, Going Left to Right and Clockwise:
Over the Alternator
To under the Idle Pulley,
To Over the AC Compressor.
To the Left Side of the Water Pump.
To the Right side and Under the Crankshaft Pulley
To the Right side and Over and Down the Tensioner
To Under the Power Steering Pump
And Back up-to the Left side of the Alternator.
Advise when puting it on:
Put the Belt around everything else accept for the Alternator. After it is around all the rest of the Pulleys - Pull the belt up - tight from the Power steering Pump and the Idle Pulley to form a loop, holding the Belt close to the Altenator Pulley.
Using the 15mm wrench or belt tensioner bar - rotate the Tensioner Pulley towards the front of the Van and then place the belt over the Alternator.
Let me know if this helped or if you have additional information or questions. Feel free to contact me at FixYa.com!
506 views
Usually answered in minutes!
×