Question about 1995 Chrysler Cirrus
Well, you can easily get to the front three plugs. However, the rear three are under the intake manifold. You will have to remove it change the rear plugs. It's not too hard, just time consuming.
Posted on Jul 25, 2009
How maney bolts to remove manifold do you have a picture o some thing to go of off
Posted on Dec 05, 2009
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
The #2 O2 sensor should be found "down stream" from the catalytic converter. When you crawl under the vehicle, follow the exhaust pipe from the engine to the catalytic converter. Right before the converter, you'll see one of the oxygen sensors. (That's number 1.) When you follow just past the catalytic converter, you'll see another one. (That's number 2, the one you're looking for.)
The role of the #2 O2 sensor is to make sure not only that the #1 sensor is actually doing its job of maintaining a 14.7:1 air/fuel ratio governed by the computer, but it's also making sure that the catalytic converter is not only present, but also that it's doing its job as well.
This isn't a very expensive part, it's easy to find, and will require an O2 sensor socket to do the job. Make sure you don't use any grease on the new sensor! It can actually render it unusable and cause your check engine light to come on again.
That reminds me...When you change out your #2 O2 sensor, in order to turn off the Check Engine light, you'll need to take it somewhere such as an auto parts store like Advance Auto Parts, who have a scanner to connect to your car's computer and clear the fault code. Otherwise, your computer will have to count a certain amount of ignition cycles before it determines that all is well with your emissions system.
Good luck, have fun, and I hope this helps! :)
Posted on Sep 08, 2009
A tee is located to the right hand side of the intake manifold, on top you should see the coolant system cap, its silver in color and is about 2-3 inches in diameter. This tee is the thermostat housing, it goes to your radiator and engine block, remove it from the block and you should see the thermostat. Remember when replacing the thermostat, the spring side goes into the block! 2.0L and 2.4L it is under where the upper rad hose hooks to the engine. 2.5L it is under where the lower rad hose hooks to the engine.
Posted on Dec 29, 2009
Tips for a great answer:
Nov 24, 2015 | Cars & Trucks
Apr 28, 2011 | 1998 Chrysler Cirrus
Apr 24, 2017 | 1998 Chrysler Cirrus
Feb 12, 2010 | 1995 Chrysler Cirrus
Dec 29, 2009 | 1996 Chrysler Cirrus
Dec 23, 2009 | 1995 Chrysler Cirrus
Oct 07, 2009 | 1995 Chrysler Cirrus
Apr 10, 2009 | 1995 Chrysler Cirrus
Nov 17, 2008 | 1995 Chrysler Cirrus
Dec 13, 2014 | 1995 Chrysler Cirrus
274 people viewed this question
Usually answered in minutes!