Question about 2006 Nissan Pathfinder

1 Answer

2006 nissan pathfinder a/c high pressure readings hitting 350 psi after a few minutes,already evac and recharged with exact amount of refrigerant?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 521 Answers

Ther is a blockage in the lines somehwere. usual suspect is the a/c orifice tube which is like a mini inline filter. Similar to the orifice in function would be a thermal expansion valve. both have small ports(orifice tube is a mini screen) that can become clogged with metal filings from the compressor as it wears and /or the dessicant material comming loose from the dryer bottle. if there is indeed blockage, the a/c lines will need to be flushed, dryer bottle replaced(recommended), a/c compressor replaced, and the orifice tube or expansion valve( whichever is on the vehicle) to be replaced. vaccumed to 28 inches of mercury and the recharged to proper charge.

Posted on Jul 18, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

When i turn on the a/c,the compressor does not work


CHECK REFRIGERANT CHARGE. USING A MANIFOLD GAUGE SET. HOOK MANIFOLD GAUGE SET TO LOW PRESSURE PORT AND HIGH PRESSURE SIDE PORT. LOW SIDE PRESSURE SIDE SHOULD HAVE 25 - 36 PSI AND HIGH PRESSURE SIDE SHOULD BE 178 - 237 PSI. IF LOW SIDE PRESSURE SIDE READ BELOW 20 PSI THE LOW PRESSURE SWITCH WILL NOT TURN ON THE AC COMPRESSOR CLUTCH NEED TO ADD LITTLE MORE REFRIGERANT. IF REFRIGERANT LEVEL CORRECT CHECK AC COMPRESSOR FUSE AND RELAY.IF POWER GOING TO AC COMPRESSOR CLUTCH YOUR COMPRESSOR CLUTCH HAS OPEN WINDING. AC COMPRESSOR CLUTCH NEED REPLACING.

Aug 11, 2011 | 1997 Nissan Pathfinder

2 Answers

What are the AC pressures supposed to be on a 2000 Monte Carlo?


On hot day @ 85=+ degrees it should be between 45 to 50 pounds on the low side pressure port

Jul 01, 2011 | 2000 Chevrolet Monte Carlo

2 Answers

What should the pressures on the low and high side of the air conditioner read ?


low side should be about 30 psi at idle speed, high side 120 to 180 psi depending on ambient temp. higher temp, = higher pressure, as you increase engine rpm to say 1000 low side should drop to 10 to 15 psi & high side should increase about 30 psi. If high side goes over 280- 300psi you have contamination (air) in system or over charged with refrigerant. you will need to recover freon, evacuate & recharge system with proper amount of refrigerant. If the low side drops below 0psi or into vacuum then the refrigerant level is low, you will have to check for leaks , repair leaks & refill refrigerant.
Hope this helps
Paul T

Jun 01, 2011 | 1997 Chevrolet Suburban

1 Answer

Ac blows cold air for about 15 minutes then starts blowing warm air then starts blowing cold air again freon is full


Freon is not full. If it goes back and fourth it is pumping then reaching a low pressure on the low side below 35 psi. Pressure while car is off should be pegged. Check at idle should be around 50 psi and 35 psi at 2000 rpms.

Good luck. If problem persists evac system replace dryer and recharge.

Oct 21, 2010 | 1983 Mercedes-Benz 300-Class

1 Answer

A/c recharge what is thew psi for refrigerant


Below are normal car AC pressure readings with 134A.

Normal readings on high and low side with AC OFF (static pressure) – Depends on outside temperature, but normally is between 80-105 PSI

Normal low side reading with AC on high speed and MAX & engine at 800-1000 RPM’s – Ranges from 25-35 PSI

Normal high side reading ranges from 200-350 PSI
Don’t assume that if adding little Freon is good that adding a lot is better! Overcharging just a little can decrease the performance of the system and possibly damage the compressor.

With the AC on the coldest setting, use a thermometer in a middle vent. Normal vent temperature readings will vary depending on the (ambient) outside temp. The vent temperature should range from around 42-55 degrees in my experience.

If normal gauge readings are obtained and the vent air is cold – STOP don’t overcharge the system. The only proper way to remove refrigerant is with a AC recovery machine so if this is being done at home I can’t emphasize enough not to over charge the system.

Thank you for using fixya and be safe.

Jun 17, 2010 | 2002 Ford Expedition

1 Answer

How do you change ac compressor on a 2000 nissan sentra


hook the high and low sides of the ac to a evac/recharge machine at a repair shop and evacuate the freon. apply a vacuum to the lines. measure how much oil comes out. disconnect the two aluminum lines from the ac pump, remove the serpentine belt, remove the (probably) 4 small long bolts. remove and install new part. reattach lines. do NOT overtighten lines. recharge ac refrigerant to specified ammount. if the pump is new you will have to measure how much oil comes out of it and put in that much oil in the new pump or it will burn up. if you dont have a evac/recharge machine they cost around 3000 dollars.

Mar 23, 2010 | 2000 Nissan Sentra

2 Answers

AC not cooling


You need to have the system vacuum evacuated, using a vacuum pump and a set of gauges, to verify that it is holding. You also must install EXACTLY the amount or refrigerant that the system calls for. Too much or too little will result in failure.

Sep 03, 2009 | 1995 Geo Prizm

1 Answer

How do I service my A/C 2000 Chevy Impala LS


To diagnose problems, an A/C manifold gauge set is needed to read high and low side pressure readings. Avoid adding refrigerant with a simple charging kit like the ones sold at parts stores. Don’t add any stop leak, this can cause problems in the compressor, expansion valve or condenser.
Keep in mind that using an A/C gauge set and seeing BOTH high and low side readings can help in diagnosing the problem when you know what to look for. First, on a 134A system the high and low side service ports are different sizes. AC gauge sets have color coded hoses, the blue color coded hose has a connection that fits on the low side service port and the red hose has a connection that will only fit onto the high side. The yellow hose won’t hook up to anything if just checking the readings; it can be used to connect to a vacuum pump or attached to a refrigerant can or tank.

Normal readings on high and low side with AC OFF (static pressure) - Depends on outside temperature, but normally is between 80-105 PSI Normal low side reading with AC on high speed and MAX & engine at 800-1000 RPM’s - Ranges from 25-35 PSI - Note that on many Chrysler products a normal reading on the low side may be 15-25 PSI Normal high side reading ranges from 200-350 PSI

Don’t assume that if adding little Freon is good that adding a lot is better!  Overcharging just a little can decrease the performance of the system and possibly damage the compressor.

Both low and high side readings are lower than normal, this indicates a cars AC system is low on refrigerant and is under-charged.

If both low and high side readings are too high, this indicates an overcharged system - too much refrigerant. This also can indicate that the condenser fan is not working, is too slow or the car is overheating and heat is transferring from the radiator to the condenser.

If you are going to by the recharge kit at an Auto Parts store, With the AC on the coldest setting, use a thermometer in a middle vent. Normal vent temperature readings will vary depending on the (ambient) outside temp. The vent temperature should range from around 42-55 degrees in my experience. If normal gauge readings are obtained and the vent air is cold - STOP don’t overcharge the system. The only proper way to remove refrigerant is with a AC recovery machine so if this is being done at home I can’t emphasize enough not to over charge the system. And actually the best way to insure the proper charge is in a system, is to use an AC machine to recover the freon and then evacuate and recharge the system with the correct amount. Most cars have the specified amount on a decal under the hood. 
Good luck and keep me posted, be glad to answer more questions you may have. 

Jul 02, 2009 | 2000 Chevrolet Impala

1 Answer

The a/c on my 2006 honda pilot is not owrking and appears to have a low refrigerant charge. I want to recharge it and find the leak with die. what is the amount of 134a to be fully charged


Adding freon or topping off a cars A/C system is the most common task performed to restore performance and get cold air blowing again. However, adding refrigerant isn’t always the solution for car air conditioning problems. There can be many other things wrong besides a system being low on refrigerant. To diagnose problems, an A/C manifold gauge set is needed to read high and low side pressure readings. Avoid adding refrigerant with a simple charging kit like the ones sold at parts stores. Don’t add any stop leak, this can cause problems in the compressor, expansion valve or condenser.
Keep in mind that using an A/C gauge set and seeing BOTH high and low side readings can help in diagnosing the problem when you know what to look for. First, on a 134A system the high and low side service ports are different sizes. AC gauge sets have color coded hoses, the blue color coded hose has a connection that fits on the low side service port and the red hose has a connection that will only fit onto the high side. The yellow hose won’t hook up to anything if just checking the readings; it can be used to connect to a vacuum pump or attached to a refrigerant can or tank.

*Make sure the condenser fan comes on when the readings are being checked.

Normal readings on high and low side with AC OFF (static pressure) - Depends on outside temperature, but normally is between 80-105 PSI
Normal low side reading with AC on high speed and MAX & engine at 800-1000 RPM’s - Ranges from 25-35 PSI - Note that on many Chrysler products a normal reading on the low side may be 15-25 PSI
Normal high side reading ranges from 200-350 PSI

Don’t assume that if adding little Freon is good that adding a lot is better!  Overcharging just a little can decrease the performance of the system and possibly damage the compressor.

With the AC on the coldest setting, use a thermometer in a middle vent. Normal vent temperature readings will vary depending on the (ambient) outside temp. The vent temperature should range from around 42-55 degrees in my experience. If normal gauge readings are obtained and the vent air is cold - STOP don’t overcharge the system. The only proper way to remove refrigerant is with a AC recovery machine so if this is being done at home I can’t emphasize enough not to over charge the system. And actually the best way to insure the proper charge is in a system, is to use an AC machine to recover the R143a and then evacuate and recharge the system with the correct amount. Most cars have the specified amount on a decal under the hood. 

Hope this helps. Keep me posted, be glad to help get you cooled again. 

Jul 01, 2009 | 2004 Honda Pilot

1 Answer

Ac compressor took one can of freon will not take other also it still is not cool


You may have over charged the system, An over charged system will also give you poor A/C performance and worst can lead to expensive repair if the compressor get's damaged.
 With the AC on the coldest setting, use a thermometer in a middle vent. Normal vent temperature readings will vary depending on the (ambient) outside temp. The vent temperature should range from around 42-55 degrees in my experience. If normal gauge readings are obtained and the vent air is cold - STOP don’t overcharge the system. The only proper way to remove refrigerant is with a AC recovery machine so if this is being done at home I can’t emphasize enough not to over charge the system. And actually the best way to insure the proper charge is in a system, is to use an AC machine to recover the freon and then evacuate and recharge the system with the correct amount. Most cars have the specified amount on a decal under the hood. 
Normal readings on high and low side with AC OFF (static pressure) - Depends on outside temperature, but normally is between 80-105 PSI
Normal low side reading with AC on high speed and MAX & engine at 800-1000 RPM’s - Ranges from 25-35 PSI - Note that on many Chrysler products a normal reading on the low side may be 15-25 PSI
Normal high side reading ranges from 200-350 PSI

Don’t assume that if adding little Freon is good that adding a lot is better!  Overcharging just a little can decrease the performance of the system and possibly damage the compressor.

God luck and hope this helps. 

Jun 30, 2009 | 1994 Ford Escort

Not finding what you are looking for?
2006 Nissan Pathfinder Logo

513 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

75117 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

705 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...