Question about 1994 Jeep Grand Cherokee

1 Answer

How to replace turn signal arm

Replace turn signal armon 94 grand cherokee

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Cheetah:

    An expert who has answered 20 or more questions within one hour.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 50 Answers

Gonna need some very specific tools, steering wheeel puller, lock plate puller sometimes you can rent them from the parts store. get a service manual. it will walk you thru it.. lots of tricky little peaces in there. pay attention is the biggest thing.. take notes and or pictures as you take it apart. then you can make sure it all goes back together alright. another thing. take your time. if your tilt is loose or lock and tumbler needs replacing its also a great time to do it

Posted on Jul 18, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to take off the rear windsheild wiper on a 94 grand cherokee


You will need a 13-inch wiper blade for the rear window. 1 - When removing the wiper blade lift the wiper arm away from the window. ----- 2 - With one hand holding the wiper arm press the small tab on the underside of the wiper blade where it meets the wiper arm. ----- 3 - Slide the wiper blade off of the arm by pulling the center toward the bottom of the arm.----- 4 - Lightly lay the wiper arm on the window.----- 5 - Prepare your new wiper blade by taking the curved part of the plastic clip and line it up with the curve of your wiper arm. ----- 6 - Lift the wiper arm and press it through the center of the wiper blade up and over the plastic clip. 7 - Pull the wiper blade up until it clicks. Place the arm back on the window.

Jan 11, 2012 | 1994 Jeep Grand Cherokee

1 Answer

I have a 94 jeep grand cherokee that's overheats


I had a similar problem on my jeep and it turned out to be the cooling fan, watch it and see if it turns on after its been running for a while. Good luck

Jun 29, 2011 | 1994 Jeep Grand Cherokee

1 Answer

I CANNOT LOCATE FLASHER FOR MY 94 JEEP GRAND CHEROOKEE


the turn signals and hazzard flashers are located on back of convenience center on 93 models.

Apr 29, 2011 | 1994 Jeep Grand Cherokee

1 Answer

Where is the wiper motor located on a 1996 Jeep Grand Cherokee Limited? Do I need to remove the cover at the bottom of the windshield? If so, how do I detach the wiper arms themselves to lift it out?


Yes you have to remove this cover. the arms have a clip thingy on the side I believe. if you genty pry the clip away from the arm then lift the arm a bit to hold the clip out near the base they should slip right off. this is true on a 94 yours should be the same.

Jan 17, 2011 | 1996 Jeep Grand Cherokee

1 Answer

My 94 jeep grand cherokee has no spark or fuel to the engine. the check engine light will not come on and the security system doesnt work. gas down the throtle boy doesnt let it start.


1-check fuses if fuses ok go number 2.
2-check for power to the crank shaft sensor (test light) for a positive if no positive replace asd relay.
if you got power to sensor check for signal while cranking on the engine (connect the test light to (+) on battery if no signal replace the sensor. hope this helps.

Jan 11, 2010 | 1994 Jeep Grand Cherokee

2 Answers

Just bought my 94 jeep cherokee & the screen in the middle consol continues me beep and flash ''rear lamp failure''


the driver information center(DIC) is telling you one or more of your rear light bulbs has failed. it could be a tail light,stop light,center high mount stop light,turn signal or license plate light. have someone in the vehicle turn the lights on and hit the brakes and turn signals so you can see which one is burned out.

Nov 06, 2009 | 1994 Jeep Grand Cherokee

1 Answer

Adjust wiper arm tension on 94 Jeep Grand Cherokee


there is no tension adjustment if the arm is too loose and dosen't put enough pressure on the windshield you need to replace the arm you can bend the center of the arm very slightly and get a little more tension BUT the arms are over 15 years old and teh springs are probably weak

Apr 20, 2009 | 1994 Jeep Cherokee Country

Not finding what you are looking for?
1994 Jeep Grand Cherokee Logo

Related Topics:

132 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...