Question about 1996 Dodge Caravan

1 Answer

1996 dodge caravan 2.4 the water punp was replace and when the motor was on it star shaking do you think is aout of time.

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Dodge Master
  • 6,674 Answers

Could be, as timing belt needs to be removed to do water pump.

Posted on Jul 18, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

The front a/c blower does not work, all fuses are good. please help


J, I am sending you some info to read but it appears that the most likely cause is the blower motor relay. Give the following notes a read and if you need some more help give me a buzz... Best of Luck..

1996 Chrysler Town & Country 3.3L, Vin R 1996 Dodge Grand Caravan ES 3.8L, Vin L 1996 Chrysler Town & Country LX 3.3L, Vin R 1996 Dodge Grand Caravan LE 3.8L, Vin L 1996 Dodge Caravan LE 3.8L, Vin L 1996 Dodge Grand Caravan SE 3.3L, GAS, Vin R, Eng Cfg V6 1996 Dodge Caravan Sport 3.3L 1996 Plymouth Grand Voyager SE 3.3L, GAS, Vin R, Eng Cfg V6 1996 Dodge Grand Caravan ES 3.3L, Vin R 1996 Plymouth Voyager Rallye 3.3L Customer Concern: Front blower does not work; no power to it. Fuse is OK. Tests/Procedures: 1. At the blower motor, there is a Dark Blue wire. This wire should have battery voltage whenever the key is in the "on" position. Power for the blower motor comes from the blower relay.

2. Access the front blower relay, it is located on the driver's side under the dash, near the junction block. There will be four wires going to it. The Dark Green wire should have battery voltage all the time. The Dark Blue wire is going to the motor. The Black/Orange wire should have battery voltage with the key in the "on" position. The Black wire should be grounded at all times. On this circuit, the relay is energized whenever the key is in the "on" position. Potential Causes: Front Blower Relay
Front Blower Relay Wiring
Heater Ventilation Air Conditioner (HVAC) Control Head
Tech Tips: The front blower relay is located under the dash, on the driver's side. It may be necessary to remove the junction block (fuse and relay box) in order to see it. Diagnostic Codes: None

Aug 28, 2011 | 1996 Chrysler Town & Country

1 Answer

Water punp making a lot of noise


Have your water pump inspected by your repair shop. If the water pump is noisy it needs to be replaced asap. The bearings in the pump become loose and can break apart, which can be costly in the future.

Feb 19, 2011 | 2005 Dodge Caravan

2 Answers

Need step by step to replace water pump on 1997 dodge caravan v-6 3,0 mits. motor...


Chrysler Caravan/Voyager/Town and Country 1996-1999 Water Pump - REMOVAL & INSTALLATION
3.0L Engine
See Figure

a812cd7.jpg

Fig. 3: Water pump mounting detail-3.0L engine
  1. Disconnect the negative battery cable.
  2. Drain the cooling system.
  3. Remove the drive belts. Remove the timing belt covers and the timing belt.
  4. Remove the water pump mounting bolts.
  5. Separate the water pump from the water inlet pipe and remove the water pump.
  6. Inspect the water pump and replace as necessary.

To install:
  1. Clean all gasket and O-ring surfaces on the water pump and water pipe inlet tube.
  2. Wet a new O-ring with water and install it on the water inlet pipe.
  3. Install a new gasket on the water pump.
  1. Install the pump inlet opening over the water pipe and press until the pipe is completely inserted into the pump housing.
  2. Install the water pump-to-block mounting bolts and tighten to 20 ft. lbs. (27 Nm).
  3. Install the timing belt and timing belt covers. Install and adjust the drive belts.
  4. Reconnect the negative battery cable. Fill the cooling system to the proper level with a 50 / 50 mixture of clean, ethylene glycol antifreeze and water.
  5. Run the engine and check for leaks. Top off the coolant level, if necessary.

Hope this help (remember comment and rated this).

Apr 13, 2010 | 1997 Dodge Grand Caravan

2 Answers

Is the water pump on a 96 grand caravan 3.3L run by the timeing belt


Good morning! The water pump on this model is not run by the timing belt. The 3.3 liter engine uses a timing chain. Hope you find this information useful!

Nov 11, 2009 | 1996 Dodge Caravan

2 Answers

Labor time to replace a faulty water pump in 05 Gran Caravan 3.8


Try (repairpal.com) for estimate for your particular area. You may have to enter Grand Caravan to get the 3.8L engine .
I'm thinking 2 hrs.

Oct 05, 2009 | 2005 Dodge Caravan

1 Answer

Wheres the water pump located on 1996 dodge grand caravan


  • 2.4L water pump in timing belt
  • 3.0L water pump in timing belt
  • 3.3L & 3.8L water pump on right side under a/c unit

Sep 26, 2009 | 1996 Dodge Caravan

1 Answer

Shakes badly when it reaches 30mph


could be bad hub bearings, or cv axles. If the cv boots are ripped, replace the entire axles, both sides. if the cv boots are still intact then I would replace only the hub bearing assemblies.

Apr 21, 2009 | 1996 Dodge Caravan

1 Answer

My dodge caravan 96 shakes only when i am at a stop


Many things can cause it But A Bad IAC Motor (idle air control motor) can cause stalling and shaking to a point when you stop if its not providing the proper air mixture .

May 25, 2017 | 1996 Dodge Caravan

2 Answers

Van shakes while driving


I've had several of these vans with this problem, check the transaxle for low fluid. Each of mine would start shaking when the fluid was low.

Jan 02, 2009 | 1996 Dodge Caravan

1 Answer

98 Dodge Caravan


The most common size is a T-50 Torx socket.

Jun 28, 2008 | 1996 Dodge Caravan

Not finding what you are looking for?
1996 Dodge Caravan Logo

Related Topics:

105 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...