Question about 2002 Nissan Maxima

1 Answer

Will not go in reverse, but will go in forward.remove power supply and it reset for a few minutes

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 61 Answers

Hello and thank you for using FixYa!

Most likely you have some internal trans issues going on. It may be possible that reverse has failed. I would have a transmission pressure check performed. This test will help determine what is going on with the transmission.

Hope this helps. Thanks Jay!

Posted on Jul 18, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Getting a warning buzzer and a red N on console when put in gear forward and reverse new 580 SM case backhoe its a newer one with 350 hours


If the tranny is the electronic controlled type, the buzzer and N lite means that there is an error or fault code in the control system. You may have to get the error code read and start your repair/service from there. Some car owners tried to reset the code by removing the negative terminal of the battery for a few minutes and then reconnecting it. However, if the fault recur, you need to get the code read.

Dec 29, 2016 | Cars & Trucks

1 Answer

My Sirion 2008 has about 50,000 miles and I was in reverse backing out of my driveway when I went to go forward I noticed I could barely steer the wheel and I saw the red direction on I pulled back forward...


Either a sensor or the motor for your electrically assisted power steering is having an issue. Not something that can be diagnosed without actually touching the car with tools and talking to it's computer.

May 22, 2014 | Cars & Trucks

1 Answer

1993 grand wagoneer transmission slips


Time for another rebuild

Any slipping your done- no fix,plus you
continued to use it like that & finished it off

Feb 11, 2013 | 1993 Jeep Grand Wagoneer

1 Answer

Here are the issues with my 2000 Subaru Legacy L with 5 speed manual transmission: 1. ABS light illuminates when transmission is put in reverse and remains illuminated until car is turned off. 2. Reverse...


These assorted problems usually come from the control modules, in this case the transmission control module (TCM)
First, reset al ECM' by removing the battery negative terminal for a minute or so then re-fit it. This reset should cure all your problems. If not I shall consult my TSB's after you post the results of the reset.

Mar 24, 2010 | 2000 Subaru Legacy

1 Answer

Suddenly lost power in any forward gear or reverse after 600 mile trip in 1994 Roadmaster estate. After leaving engine off for a few minutes and turning it on, it moves forward/back for a few minutes...


Will it idle normally? Will it move in gear slowly? If it is only affected when you try to move faster it could be a plugged catalytic converter. Or a bad throttle position sensor. Not sure.

Feb 20, 2010 | 1994 Buick Roadmaster

1 Answer

4x4 light flashes six times every two minutes or so and 4x4 will not engage. Can you help me?


try shifting it to neutral and wait a few seconds,if it still flashes try shifting it to drive and wait a few seconds,then reverse.if it still doesnt lock in then move the vehicle a few feet either forward or reverse,worst case the electric motor on the transfercase is bad

Dec 26, 2009 | 1995 Ford Ranger Supercab

2 Answers

I need to erase my compter for a 2004 jeep liberty i hear that disconnecting the battery cables do it but am unsure


Usually disconnecting the negative terminal for at lease 15 to 20 minutes should reset computer.

Jun 12, 2009 | 2004 Jeep Liberty

1 Answer

NO REVERSE FORWARD GEARS WORK. IS THERE A BAND AJUSTMENT FOR REVERSE ?IF I PUSH IT OFF IT WORKS BUT SLIPS


I have a 2000 Honda Accord EX, it shifts normal on forward with no problem. Also when the car is cold the reverse gear works just fine, but when the car runs for about few minutes the reverse gear will not work. It will seem as if it wants to go but then if feels like its neutral.

Oct 06, 2008 | 1988 Mazda RX-7

Not finding what you are looking for?
2002 Nissan Maxima Logo

Related Topics:

94 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...