Question about 2001 Chevrolet Silverado

1 Answer

Why does the blower motor only work on spped 4 and

Why does the blower motor only work on speed 4 and 5 and not 1, 2, and3? This is for a 2001 Chevy Sliverado.

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 218 Answers

Usually when the blower only works on the higher speeds, the blower motor resistor has gone bad. This should be located somewhere near the blower motor itself, it is usually bolted to the blower motor housing (or in that area), just unbolt it and you can replace it. Hope this helps

Posted on Jul 17, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2003 Chevy Impala w/dual zone heat /AC stopped blowing on speed 5. Worked fine on speeds 1 thru 4 for about 4 weeks then stopped working on all speeds.


Likely the blower motor resistor. located right next to the blower motor, this device is resposible for reducing the voltage suplied to the motor. when it fails you may loose some or all speeds of the motor

Nov 04, 2012 | 2003 Chevrolet Impala

1 Answer

123 on blower switch does not work have new resister Where is it located 2001 Chevy truck 2500HD 4x4 Sliverado


Hi you have to locate the the blower motor it is behind the glove box door the resister right behind the blower motor look for a 4 or 5 wire plug.

Aug 13, 2011 | 1999 Chevrolet C2500

1 Answer

2006 Chevy Silverado 4wd HD. Blower motor started running all the time even whe the key was removed. I removed the fuse under the hood and the fan stopped. It now works only on speeds 1-4. Is there a high...


there could be partial contact in the blower controls which has resulted in total loss of contact, in blower speed affected. replacement of the entire blower control switch should resolve it

Dec 26, 2010 | 2006 Chevrolet Silverado

1 Answer

The a/c and heater fan speed switch with the 1,2,3, and 4 modes are not working. first 1 and 2 didnt work now only 4 works. so if i want my a/c on the only option i have is 4. the car is a 2002 chevy...


most probably the heater resistor is bad , its just beside the blower motor, with a harness of 4 to 6 wires connected to it , usually blown because the blower motor is drawing too much power

Aug 20, 2010 | 2005 Chevrolet Silverado

1 Answer

Heat/ac blower motor works on high. intermittent on other speeds.


Check the blower resistor pack - usually located in the heater air ducting in the blower fan airflow. Check for loose connections and open circuit resistors on the unit.
If speed 4 works always, its unlikely to be the blower motor ground connection.

Aug 10, 2009 | 2004 GMC Canyon

4 Answers

2005 Chevy Surban blower motor resistor


When the blower is on speed 5, it is a direct 12 volts for high speed and the first four operate through the resistor, check your breaker for the blower motor to insure it is not cutting out.

Jul 18, 2009 | 1995 Chevrolet K1500

2 Answers

Blower motor or resistor?


I had a truck about the same year with the same problem, it was the wiring harness, but id check the resistor and the fan first before replacing anythings,

May 20, 2009 | 2002 Chevrolet Silverado 1500

1 Answer

On my 2000 chevy S-10 ZR2, speed 4 of my fan stopped working


It's not the motor, if you have replaced the resistor/relay and that didn't work then it is likely the switch.

Mar 15, 2009 | 2000 Chevrolet S-10

1 Answer

Blower motor or resistor?


If it was the motor that went out then it would not blow at all. The resistor is the culprit that starts killing off speeds. It should be about $25 to $30 at an aftermarket store like autozone or advanced auto parts.

Jan 09, 2009 | 2000 Chevrolet Malibu

Not finding what you are looking for?
2001 Chevrolet Silverado Logo

433 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...