Question about 1999 Dodge Durango

1 Answer

Need to find out what wires are for what on tps 1999 5.2

Posted by on

  • auto43 Jul 18, 2009

    ok...i need to know what color wires do what...like which is the 5v...which is ground...and signal...
    i just dont have a wiring diagram...
    thanks and sorry for the confusion..

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 55 Answers

TPS switch is located on the throttle body(like a carb) and connects to the butterfly valve there. hence the location of the wires.

Posted on Jul 18, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My name Ilsur, I of Tatarstan , I have a jeep Grand cherokee WJ laredo 1999 4.0 error P0123 I replaced TPS but nothing helps, replaced the clockspring does not help, help me please


i had the same car.... what mileage.... 200K?
TPS errors. (its real its a real measured error)
this error is catastrophic, , meaning, not just a tad off,
the FSM covers this in details.
clock spring, the Air bag clock spring? has nothing to do with this.
or do you meant the throttle return spring, (my guess?)
the TPS output pin was discovered to have an illegal high voltage
on the output (you can be sure it idid)
spec:
TP Sensor indicated more than 4.50v for 700 ms.

caused by a bad TPS ground wire, or the output pin cut.
or the TPS internals are cracked in half (bad inside) (i have photos)
its bad TPS or bad wires to it. simple huh?
it will not be a bad ECU. as is on the list; it will not.
The jeep has great cheap TPS to buy ofter market,
on other cars not, and can cost $300 , for them
i connect my potable scope and watch the TPS output while i drive.
and find out if it is really truly bad.... hell the part, costs more than my
scope.!
be happy its not new car with throttle by wire, !!!
or the big V8 , whole new throttle body for $1000

recap. bad TPS, bad wires.

the tps on most cars are calibrated.
if you just thrown on a new TPS and not calibrate it, that is
a big failure.
here are the steps
1 key off
2 remove TPS.
3: put back new.
4:
The TPS is mounted to the throttle body. The throttle shaft end of throttle body slides into a socket in the TPS. The TPS must be installed so that it can be rotated a few degrees. (If sensor will not rotate, install sensor with throttle shaft on other side of socket tangs). The TPS will be under slight tension when rotated.
  1. Install TPS and retaining screws.
  2. Tighten screws to 7 Nm (60 inch lbs.) torque.
  3. Connect TPS electrical connector to TPS.
  4. Manually operate throttle (by hand) to check for any TPS binding before starting engine.

adjust the TPS for
0.26 volts at minimum throttle opening (idle)

worst case:
the FSM says it auto calibates
if the new TPS errors,. set it to 1/4 volt at idle.
reset ECU , all DCTs using scan tool
pull battery for 5min neg. lug (backup radio codes first)
put back lug
start engine, drive 25miles or till CEL comes on (failures)



Nov 23, 2013 | 1999 Jeep Cherokee

1 Answer

P0123 Just put new Tps and it is showing this code now can adjust the TPS?


DTC P0123 - Throttle Position Sensor/Switch A Circuit High Input
This code means that the the car's computer has detected that the TPS (throttle position sensor) is reporting too high a voltage. Were codes deleted after this job? This is a code for TPS voltage high.

The sensor voltage should never be greater than 5volts. It normally reads .5 to .8 volts at idle (closed throttle). The orange and dark blue is the signal wire, black and light blue is the sensor ground, and the violet and white is the 5volt supply wire. You will need to back probe the signal wire to find the value. It is possible the signal or ground wires are open. Or the PCM is faulty.

zjlimited_775.gif


Hope this helps (remember to rating this free answer).

Oct 10, 2011 | 1999 Dodge Ram

1 Answer

1999 Dodge/cummins can the P0122 code cause my hard start problem


this obd2 trouble code table can help you understand the meaning of code, for this code, you can try:
Carefully check the throttle position sensor (TPS), wiring connector, and wiring for breaks, etc. Repair or replace as necessary
Check the voltage at the TPS (refer to a service manual for your vehicle for specific information). If the voltage is too low that is indicative of a problem. Replace if necessary.
If recently replaced the TPS may need to be adjusted. On some vehicles the installation instructions call for the TPS to be properly aligned or adjusted, consult a repair manual for specifics.
If there are no symptoms at all, the problem may be intermittent and clearing the code may resolve the issue temporarily. If this is the case then you should definitely check the wiring to be sure it's not rubbing on anything, grounding, etc. The code may come back.

Sep 08, 2011 | 1999 Dodge Ram 2500 4WD

2 Answers

Where is the TPS sensor loocated on a 1999 oldsmobile silhouette van? I am attempting to do this on my own. The van does not accelerate normally when I pull out. Once I am on the freeway or at higher...


Follow the accumulator cable from the firewall to the intake manifold/throttle body air tube.

It will end right next to the TPS.

TPS is a 3 wires electronic unit.


Please rate my answer is it's helpful to you.


Cheers,

Mustgo.




Dec 12, 2009 | 1999 Oldsmobile Silhouette

1 Answer

Were is the throttle position sensor on a 1999 alero


3.1 l engine from air filter box air duck hose goes to the throttle body tps is the sensor connected to the butterfly of throttle bodyround senor with 3 wire connector the other one is idle air control sensor mush bigger then the tps wit 5 wire connector before changing it check for corroded or broken wire there very tin wire thanks pierre

Jul 31, 2009 | 1999 Oldsmobile Alero

2 Answers

Finding the TPS


Look for the throttle cabe and follow the cable you will see the throttle postion switch at the throttle plate in the air intake for the engine.

Jun 27, 2009 | 1999 Pontiac Sunfire

2 Answers

My Daewoo dies after it warms up


1999 Daewoo Leganza Daewoo leganza stop running when I slowed down just after I noticed a hesitation while driving at a steady speed. It wouldnt start up again until I waited for awhile.

Apr 12, 2009 | 1999 Daewoo Leganza

1 Answer

Tps location on 1999 camaro


TPS is always connected to one end of the throttle plate shaft It should not be difficult to identify. If you already have the new one the old one is identical. Usually fastened with two small torx screws.

Apr 09, 2009 | 1999 Chevrolet Camaro

1 Answer

1999 wrangler problem: high idle,and hesitant.


If it was originally scanned by auto zone and they said Throttle Position Sensor (TPS),i would go back and have it scanned again,this will tell you for certain what it is.Try and get the code number and definition written down.If it were TPS again,the sensor itself would need to be replaced unless the cost was prohibitive,or the wires to and from the sensor and PCM (vehicle computer),ohms checked for continuity first.Eliminating the wires leaves 2 entities in the circuit,the PCM or the TPS.Checking circuits is costly in labor dollars.Good luck.

Jul 10, 2008 | 1999 Jeep Wrangler

Not finding what you are looking for?
1999 Dodge Durango Logo

Related Topics:

65 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

75197 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7782 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...