Question about 2006 Hummer H3
HOW DO YOU COMPLETELY DISENGAGE TRANSFER CASE FULLY ON H3 HUMMER 2006 BECAUSE THEY WANT ME TO CHANGE A PART IN THE TRANSFER CASE THAT IS PLASTIC TO METAL AND CHARGING ME 800.00 IN LABOR I DON'T FOUR WHEEL AND IM GOOD WITH 2 WHEEL DRIVE
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
I brought my 2006 H3 in to the dealer for the same thing. My blower stopped working all together but it started as an intermittent problem. He said he had to replaced a diode or resistor either behind the switch on the dash that controls the fan or on the fan motor itself. Have not had a problem since but that was only about 4 months ago.
Posted on Apr 09, 2009
I'm not 100% on this but I think it's like a lot of GM's; turn the key to the "on" position(not running), stomp the gas pedal to the floor 3 times within 5 seconds & the light should flash & go out.
Posted on Sep 24, 2009
SOURCE: 2006 H3 Hummer fan problem
Hi if your internal fan not work in any position well i fixed up myself easy and save your money.
locate the fan motor air just outside right courtesy drawn document in front of passenger. go from down and look up you will see a motor with a big connector white with 2 screw secure inside the motor block. loose the two screws and pull out gently the connector from motor fan block. you will see a green multiresistor connected with this big connector. Usually the first + voltage connector is burnet out. disconnect the connector pull from resistor and check for any burn. in my case the first pin was burned out completely
you can buy another connector or you can clean the burned connector take out form connector weld a small copper cable of 5 mm dia from resistor to the burn cable and reconnect the connector without buy a new one. after replace again the resistor in the hole of motor blow with the 2 screw.
Done all work again without buy another new connector.
Gabriel from Italy Turin
H3 hummer 2007
loveling one and Humvee owner
Posted on Jun 11, 2010
Tips for a great answer:
Jan 01, 2016 | 2006 Hummer H3
Sep 29, 2012 | 2006 Hummer H3
Oct 04, 2011 | 2006 Hummer H3
Nov 16, 2010 | 2006 Hummer H3
Aug 09, 2010 | 2006 Hummer H3
May 07, 2010 | 2006 Hummer H3
Mar 14, 2009 | 2008 Hummer H3
Nov 24, 2008 | 2006 Hummer H3
634 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: