Question about 2000 GMC Jimmy

1 Answer

Door spring fellout whats the part called that the spring pushes on

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • GMC Master
  • 75,822 Answers

That is part of the door hinge.

Posted on Jul 17, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

How do I open the fuel door on a 2007 chevy avalanche


My guess is the rubber bumpers for the fuel door are missing causing the door to sit in too far. Probably need like a pocket screwdriver to pop it open. New bumpers are available.

Feb 28, 2015 | 2007 Chevrolet Avalanche LTZ

1 Answer

How can I get gas filler door open on Infinity G 35, will not spring open when pushed to front of door and usually sprung open


the filler door spring has broken and will not open the door until you get the door open to replace it.

Feb 07, 2015 | Cars & Trucks

1 Answer

Can anybody tell me how to fix my garage door?


This may happen because of door spring. I think you need to replace door spring. It can replace spring by your own or you can call an expert at http://accurategaragedoorhouston.com/

Jan 07, 2013 | Buick XP Cars & Trucks

1 Answer

2011 toyota sienna rear liftgate door open sensor needs to be replaced, where is it located?


This fix is for 2011 rear manual door.
You may experience some light turns on while driving over a bump or take a sharp turn. Your rear hatch indicator said door is opened.
The courtesy switch is located inside the rear hatch latch assembly. Nothing more but a simple thin lever line leave spring that contacts the ground pole to tell body ECU the door is opened.
The spring is so thin that it bent out of shape overtime therefore when you close the door it doesn't get pushed away from the ground pole far enough caused intermittently false door open alarm.
ALl you have to do is to remove the door latch assembly. Separate the actuator from the latch. Look into the latch you would see a copper like spring one end rests onto the ground pole. Jam your screw driver between the latch housing and spring lightly pride it away from the pole to unbend it. . Manually close the latch and look to see if it gets pushed away from the pole. If it doesn't try to unbend it again.
If you have or know how to use a ohm meter than check for continuity between spring and it housing. You should get 0.3-1.0. Ohm when the latch is open and no continuity when you closed the latch.
Any question shoot me a email constant12vdc@yahoo
ED

Aug 29, 2012 | 2011 Toyota Sienna

1 Answer

I recently purchased a 2007 Audi A4. When I use the remote to lock and unlock the doors, the door to the fuel tank pops open. Any clue why?


Probably has a spring that opens the door. My is the same but no spring I just have to push on the opposite side of the door and it opens. Doesn't affect the lock but I would try removing the spring that will stop it from opening. Hope this helps?

Jan 18, 2011 | 2003 Audi A4 Cabriolet

1 Answer

Its cold and the door was frozen stuck. But after unlocking it, I pried it open and when I got in the drivers seat to close the door. The latch is stuck in the down position and the door wont close or...


spray the latch catch with oil or silicone to loosen the latch mechanism than stick something [a screwdriver/ pen ] that u can use to push the catch upward to open push on catch while lifting handle if catch falls back either latch spring still frozen or latch spring broken and needs replacement

Jan 11, 2011 | GMC Yukon XL Cars & Trucks

1 Answer

Driver side window fellout of the track how does the window motor work


It did not fall off anything
You have a broken window regulator
Remove door panel and replace whatever is broken

Nov 29, 2010 | 2002 Buick Rendezvous

2 Answers

Replacing interior door handles on 98 Sierra


on the inside of the trim peice take a flathead screwdriver and gently work around the inside of the trim peice and if you find the right spots were the clips are it will just pop off.

Jan 14, 2010 | 1998 GMC Sierra

3 Answers

My 96 lincoln mark viii gas door will not release when i push the button to open it. I have to have 2 people to go to the gas station, one to push button one to push on gas tank door to open it.


There is A Spring or Spring type Mechanism At the Door that POPS the Door Open Once the Button has been Pushed . And when you Close the Door This Same SPRING ACTION Sorta Fights Against your Closing it. Well it Sounds to me as if this Spring Action is Not Working Properly,
Take a CLOSE Look at this and Be sure This is Working Properly, My References Do NOT Go into DETAIL on this so its Kinda a Common Sense Approach to it.

Jul 15, 2009 | 1996 Lincoln Mark VIII

Not finding what you are looking for?
2000 GMC Jimmy Logo

Related Topics:

108 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Freddy

Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...