Question about 1999 Chevrolet Silverado 1500

1 Answer

Cleaned oil pressure sensor engion light went out but oil pressure guage reads 80 lbs

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 94 Answers

Time to replace

Posted on Jul 26, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Oil pressure guage is stuck on 80 lbs 2003 silverado 4.8 liter


It could be your oil pressure sending unit is sending a steady signal because its defective. If it is, they are very simple to replace.

Nov 25, 2013 | Cars & Trucks

1 Answer

Just bought a used 2002 chevy s10 crew cab and drove it will trailer in tow this weekend. when I got to my desination over several mountians, the check engine/guages light came on. The oil pressure was...


Normal oil pressure at operating temperature should be around 40 lbs, 30 at an idle. Either you have a bad oil pressure sending unit or you actually have low oil pressure that indicates a serious engine problem.

Jul 19, 2011 | Chevrolet S 10 Cars & Trucks

1 Answer

2003 yukon xl oil pressure guage is at 80 (top end) When I excellerate the gas pedal the oil pressure guage drops to 0.


Hello: You may have a inaccurate oil pressure sensor, you might try replacing the sensor but you have to remove the intake manifold to access the oil pressure sensor

Jan 21, 2011 | 2005 GMC Yukon

1 Answer

The oil pressure guage on my 2000 Jeep Grand Cherokee is registering 0. My oil was just changed and I don't see any indication of oil leaking anywhere. Could it be the sensor?


First off I wouldnt drive your car until you make sure that you have indeed oil pressure and that the gauge is a false reading, driving your car if in fact it has no oil pressure will severly damage your engine, but firstly i would check the oil pressure switch its located on the passenger side of the engine right back from the oil filter make sure the connector is clean and free from oil and corrosion if the connector appears to be in good shape take a paper clip and insert it between the 2 terminals inside the connector your oil pressure gauge should peak at 80 PSI that tells you that your gauge and all related wiring are good and in working condition, secondly remove the oil pressure switch and hook an manual oil pressure gauge up to you engine and start the engine the guage should have a oil pressure reading anywhere from 30 PSI to 55PSI depending on engine temperature if theres oil pressure on your manual gauge replace the oil pressure switch with a new unit, if you still have 0 PSI on your gauge then stop your engine immediatly and start looking at your oil pump and lubricating system for a problem.

Dec 06, 2010 | 2001 Jeep Grand Cherokee

1 Answer

I put air into my two front tires last night. THen my "check right rear tire pressure message comes on when I start the vehicle and the pressure reads 53 lbs even though a manual rire gauge shows 32...


Two things, first try another tire guage, second the sensor is bad. these can cost up to $80.00.
Replace the sensor or ignore the light and keep check on the tire pressure.
Randy

Nov 09, 2010 | 2009 Chevrolet Impala

1 Answer

I have a 1992 El Dorado. It runs like a TOP! It has just over 182,000 miles. I took it for an oil change and now, at low idle, the "LOW OIL PRESSURE / STOP ENGINE" comes on. I took it back and...


I would check the wiring between the oil pressure sensor and the computer. The computer is reading low or no pressure, hence the warning light. If your mechanic is telling the truth about the pressure and the pressure sensor is good, that is the only thing it could be.

Oct 26, 2010 | 1992 Cadillac Eldorado

1 Answer

1989 F150 351 oil pressure guage starting dropping to 0 suddenly and engine light comes one. When I rev the engine it goes back to normal but a soon as the rpms drop the needle goes all the way to the left...


Hi:
Usually your oil light doesnt come on unless you have less than 10 lbs of oil pressure. You either have a bad oil pressure sending unit, or your engines oil pump is bad. The only way to verify your engines oil pressure is to buy a direct reading pressure guage and install it on your truck, or have a mechanic check your engine oil pressure. Eitherway, you need to do something soon, because the long term effects of running with low oil pressure will ruin your truck engine.

Jan 25, 2010 | 1989 Ford F 150

1 Answer

Just started up my 2003 chevy and my oil gauge went to 80


the oil sending unit could be out or the pressure guage is malfunctioning is the service engine light on?

Jan 11, 2010 | 2003 Chevrolet Silverado 1500

Not finding what you are looking for?
1999 Chevrolet Silverado 1500 Logo

93 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75117 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7772 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...