Question about 2003 Ford Windstar

1 Answer

2003 Windstar is stalling when going in reverse

Recently, when putting my 2003 Ford Windstar Van into reverse and backing up it stalls out. There aren't any codes showing up or other problems. It just dies and does not miss or give a sign that it is going to die. Any ideas as to what could be happening?

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 39 Answers

It sounds like an idle air motor, located on the top of the intake

Posted on Jul 25, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

It did not stall i stop put in park with motor runing put it back in drive and it would not go back into drive why


Sounds like no transmission fluid. Check the fluid level for your transmission, there should be a seperate dipstick

Aug 31, 2014 | 2003 Ford Windstar

1 Answer

2003 windstar stalls when driving, idles high in neutral, now 4 codes


ok so much done owell next is the mass air flow to be checked then the fuel regulator to check pressure and the fuel pump for pressure and then check the cat,s for back pressure wood be my next thing and Last is the how many Km,s does it Have ?sounds like filter needs lookin at in the tranny if she,s got High Km,s if not then check the intake for leaks it,s Plastic so don,t hurt gone this far Let me Know What Happens,s Thank,s

Apr 08, 2013 | 2003 Ford Windstar

1 Answer

2003 Ford Windstar----I had battery light, abs and brake light intermittantly coming on. Found that alternator was over charging and there was a bad wire overheating going from battery and fuse panel. ...


Hello, It could be what you said. But if you know the Voltage was too high, you may want to replace the Ignition Relay and the Fuel pump Relay. If the contact points are cooked, they could work intermittently and it would be difficult to test. A bump or a little overheating could cause the contact points to break loose and then work when they cool.

It is good that the "check lights" are off. I always tell my clients that the scans are free at Autozone, Oreillys, and Advance. Some things like Relays may not trigger a light.

Be careful with a Wiggle test, but you may find a short in the wiring by shaking the wiring under the hood. I doubt the Voltage Regulator is causing your current stalling problem. A fully charged Battery without a Regulator or an Alternator would provide an amount of reliable power until the Battery was drawn down.

I hope my Solution is very helpful.

Jun 26, 2011 | 2003 Ford Windstar

1 Answer

03 windstar cuts out when a/c is turned on


hi

2003 Ford Windstar-this may the idleing amount is too much so which may makes it to idle rough. that means too much of fuel going inside the engine.

Engine stalls- this is because the when the car is off and when AC is on the AC runs in battery. When you try starting the car the starter motor takes power from the battery. it doesnt have enough battery power t o starts thats why it stalls.

Jul 09, 2010 | 2003 Ford Windstar

1 Answer

1995 Ford Windstar has an intermittent stalling issue.


If it wont stall in neutral or park it may have a bad torque convertor clutch in the trans causing the engine to stall.

May 07, 2010 | 1995 Ford Windstar

1 Answer

2002 Ford Windstar Van


When it is jerking does it nealy stall, if so thats why the alt light flashes, almost stalling.

Have engine "scanned"

Mar 30, 2010 | 2001 Ford Windstar

1 Answer

Windstar van stalls while driving


Inspect Carburetor Dirty and Improperly Functioning Carburetor. Inspect Carburetor Incorrect Carburetor Adjustment. Inspect Carburetor Worn, Faulty or Damaged Carburetor. Inspect EGR Valve EGR Valve Sticking Open/Leaking. Inspect Idle Air Control Valve IAC Valve Sticking or Faulty. Inspect Mass Air Flow Sensor Damaged, Loose, or Faulty Mass Air Flow Sensor or Circuit Inspect FreshAir Intake Hose Clogged or Damaged FreshAir Intake Hose. Inspect Throttle Position Sensor Faulty or Incorrectly Connected Throttle Position Sensor. Inspect Fuel Filter Clogged or Dirty Fuel Filter. Inspect Fuel Injector Dirty or Worn Fuel Injectors.

Sep 10, 2009 | 2001 Ford Windstar

1 Answer

1999 ford windstar stalls at 30 to 50 mph when at


you should check the all vacuum hoses starting at the egr valve. if the vaccum hoses are soft they will collapse and stall the van.

Jun 30, 2009 | 1999 Ford Windstar

2 Answers

2000 ford windstar stalling when too much power being used


o2 cencers will cause stalling if your engine light is on get it scanned it will tell you if it needs to be changed

Oct 20, 2008 | 2000 Ford Windstar

Not finding what you are looking for?
2003 Ford Windstar Logo

Related Topics:

545 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

74945 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

fordexpert

Level 3 Expert

5467 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...