Question about 2001 Dodge Durango

1 Answer

Front a/c used to work just on high and now it wont blow at all. but the back is working just fine

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 521 Answers

Blower motor resistor. usually found near the blower motor itself. 2 screws and one wire clip with about 4-5 wires. remove the wire plug...remove screws... installation reverse of removal.

Posted on Jul 17, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Front blower not blowing air.The rear one works fine.


The dealer messed up. Take it back to dealer for FREE FIX.

Dec 25, 2013 | Nissan Quest Cars & Trucks

1 Answer

Replaced reistor on blow about two months ago that thing that looks like a credit card and than it was fine but now last week it stop working the front blower wont come on but the back will blow


the front blower motor located near the resistor has to be replaced a bad motor can cause the resistor to burn out draws to much amperage you wont need to replace the resistor again

Jan 15, 2011 | 2004 Dodge Durango

1 Answer

My AC only works when the car is in motion. It blows warm air otherwise.


Sound like maybe your a/c condensor fan is not working, should come on with a/c on, the fan sit in front or back of radiator, condensor is bolted to the front of the radiator, if its not working at stops no air blows through condensor and pressure will get high and a/c wont blow cold, while driving air is running through condersor so a/c will work fine.

Jun 30, 2010 | 2003 Lexus RX 300

1 Answer

2001 Ford Windstar, front and back heaters, back works fine front blows cold air


check the front blend door actuator if it is working.The actuator may be working but the blend door is broken stuck.remove the dash console panel [ac heater panel and radio] you can see the door actuator.remove the 3 screws and pullout the actuator using flat screwdriver try to rotate the door

Jan 08, 2010 | 1999 Ford Windstar

3 Answers

99' Escalade a/c front vent blows cool air an rear blow cold air.


i have the same problem, my rear a/c blows great very cold, the front a/c blows but it is not cold at all. I had the the a/c seviced and it was vacumed and correct ammount put back in, no problems, the front still blows but it is not cold, i have checked everything and the a/c guy said it might be the door not opening. any help? still not working

Jul 13, 2009 | 1999 Cadillac Escalade

2 Answers

2002 Tahoe Rear A/C doesn't work.


the system could still be low on freon even though front works

Jun 21, 2009 | 2002 Chevrolet Tahoe

1 Answer

2005 Dodge Durango won't blow cold in front!! Rear air works fine


you are bodging it and as you dont know anything about the A/C system then leave well alone and get it done with a machine.the whole system needs to be evacuated oil drain needs to be measured then refilled with the correct grade of oil and then regassed with the correct WEIGHT of gas and possibly a leak sealer added using special equipment.If it still doesnt work properly then it needs draining again and the venturi valve removing and checking out on the front unit.This is a specialised job for highly skilled operatives with the right equipment

Feb 27, 2009 | 2005 Dodge Durango

1 Answer

Headlights work on high beam but not on low beam is there a fuse


on these cars if 1 of the bulbs blow out then you will have to replace them both because they wont work. replace both headlight bulbs and they will be just fine

Dec 29, 2008 | 1999 Volkswagen Beetle

Not finding what you are looking for?
2001 Dodge Durango Logo

79 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

74896 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7688 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...