Question about 1988 Dodge Shadow

1 Answer

Idle is very ruff.at 2000rpm it will drop to 1500,1000 rpm.it will not start unless gas pedal is held to the floor.

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 51 Answers

Fuel filter

Posted on Jul 20, 2009

×

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Toyota corolla hatch 2002 idle at 2000 rpm when


All the above is normal , except 2000rpm is a little high at idle . can be adjusted down to 1500rpm. the computer adjusts the engine speed . in drive the transmission loads up the engine idle drops to 1000rpm . in park engine unloaded rpm increase all normal.

Sep 17, 2014 | Cars & Trucks

2 Answers

2004 GMC YUKON DENALI idling rough and trouble starting


unless you want to blow up the intake stop giving it gas before you turn it over what you are doing is dangerous all you are doing is dumping raw unburned gas into the bottom of the intake to the motor, one of these times you go to start it it will do this boom really loud then die, it will lift the whole back end of the vehicle off the ground, then if you try to start it again okay I edited the answer also could be your catalytic convertor plugged is the exhaust coming out good, change the sensors whatever you do stop pumping the gas if it wont start now get in as you need silence so shut the door and the radio off can you hear the fuel pump? it will sound like a huum for a few seconds if you cant there is your problem all I can say is stop pumping the gas as that's why its running bad you are burning out the sensors and all the computer code stuff and wasting expensive gas too. you prolly fouled your plugs as well.

Mar 07, 2017 | GMC Yukon Denali Cars & Trucks

1 Answer

92 jeep cherokee will not start when hot,starts when you hold the gas pedal to the floor ? Then runs ruff cuts off.


replace the fuel filter then check the air/fuel mix needle valve according to manufacturer specs. Sounds like you have way to rich a fuel mixture.

Aug 08, 2014 | 1992 Jeep Cherokee Sport

1 Answer

1993 f350 460 cid wont start unless you press gas pedal to the floor


my truck starts right up if I hold the petal to the floor but wont start if I don't hold petal to floor

Feb 12, 2013 | 1993 Ford F350

1 Answer

High rpm at idle: code P1294 target idle not reached


Hi Rodrigo, The idle control is activated by the temperature sender unit. It sounds as though yours is giving a cold signal to the computer and it pushes up the idle speed to compensate as if it has just started. The sender unit is a different unit from that which operates the gauge on the dash instrument panel. Replace it and I believe your problems will be over.Regards John

Apr 29, 2012 | 1995 Mitsubishi Eclipse

2 Answers

Motor starving for fuel pump ok pressure 100lbs book calls for 44lbs which do I replace the fuel pump relay or pressure regulator engine will not Idle with pedal too floor only 2000rpm


sounds like the regulator is not doing it's job, but you say starving? Is the engine running lean or rich? Is there black smoke coming out the exhaust? I'm thinking high pressure would normally cause a rich condition.

Sep 08, 2010 | Volvo 240 Cars & Trucks

1 Answer

88 dodge shadow idles very ruff. pedal to floor to start.


i have an 88 dodge shadow turbo with a five speed. the car will fall on its face at 5500rpm coming out of first gear. and its rpm range gets lover with each gear. the fuel pressure rises when it fall on its face. the car never dies just falls then picks back up and will fall again unless you keep it under the that rpm. then it is fine. what could be the problem?

Jul 17, 2009 | 1988 Dodge Shadow

2 Answers

2004 Mazda Mpv high idle and will not idle down.


Check your throttle position sensor

Mar 19, 2009 | 2004 Mazda MPV

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

81 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8180 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...