Follow the 2 links below for definition and descriptions of issue.
http://www.obd-codes.com/p0120
P2135 TPS Sensor Voltage Correlation DTC
SOURCE: pedal position malfunction
You can change the tps alone. You do not have to change the entire throttle body. It shouldn't be riveted in place, it should have screws or bolts on one side or the other. If it's riveted in place, use a dremmel and grind the rivets off. You can replace rivets with screws on the new unit.
SOURCE: P2135 CODE throttle/pedal position sensor/switch
Hi,
if you feel confident in using a digital auto test meter. Disconnect the sensor, and check the value range with the test meter to ensure it is within the set parameters.
However, before embarking on that task. Some ECU's will display a fault code, but will require re-setting to clear the code. With a new sensor fitted the ECU should re-set, although some "hold" the code in memory, it does not come up as a visible fault. Some vehicles can be driven a few miles, then the ECU will learn that the new sensor is within specs and will react accordingly.
SOURCE: 2004 chevy express van codes p0894
P0894 Transmission Slipping
P1258 Engine got Hot
P1516 Throttle Actuator Control (TAC)
Chevrolet Tahoe vehicles may experience a performance issue where they
will not go over 15MPH. The vehicle may appear to be in "limp-in" mode,
giving just enough power to get you to a shop. The
codes indicate a problem with the throttle position sensor circuits and
throttle actuator performance. Do NOT start replacing parts. Shops
report a pattern failure in the electrical harness to these sensors.
Chevrolet has issued a revised replacement harness to correct the
problem. The original connector was prone to vibration and broken wires
that disrupted the signal to the PCM and put the vehicle into reduced
power mode.
SOURCE: Is there a way I can reset my computer in my 2006
yes. disconnect the battery COMPLETELY and let it sit for a bit(30 minutes) hook it back up.
code p 0120 refers to mass air flow(MAF) sensor/volume air flow(VAF) sensor---low input===causes wiring short to ground ---MAF/VAF sensor---ECM
code p 0220 refers to throttle position sensor (TP) B /accelerator pedal position (APP) switch B--circuit malfunction===causes --wiring--TP/APP switch---ECM
code p 2135 refers to the same as p 0220 causes and sensors
1,918 views
Usually answered in minutes!
×