Question about 1998 Mercedes-Benz E-Class

1 Answer

SRS light is staying on

After replacing indicator lever the SRS light is staying on. How do I reset this without going to a dealer. C180 1998.

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 404 Answers

Well there are some who say you have to turn the steering wheel all the way left, put the light on and off and then turn it as quick as possible to the right and do same with lights, reality is that normally it does not work so you have to find a mechanic that has a diagnostic for Mercedes and just reset it, takes about 5 minut but cost few good bucks.

Posted on Jul 21, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Abs light will not reset have replaced wheel sensor wires are good as i replaced speed sensor wires are good what next ??


Cluster warning lights

Whenever this warning light or any other stays on in the dash it is indicating that the systems control module (or the system sensor in the case of lights like low oil pressure, door open indicators etc.) has detected a fault, it then disables the system (this applies to ABS,TCS, TCM, SRS, TPMS, MIL, CEL and BCM faults and others) as long as the light is on. You must now have the dealer hook up a special electronic diagnostic tool and "scan" the system for the fault code that is stored for the problem(s)

Legend of Abbreviations. ABS Anti-lock brake system. TCS Traction control system, TCM Transmission control module, SRS Supplemental restraint system, BCM Body control module. TPMS Tire Pressure Monitor System, MIL Malfunction Indicator Lamp, CEL Check Engine Light.

Dec 06, 2012 | 2002 Chevrolet Astro

1 Answer

Air bag light stays on


Whenever this warning light or any other stays on in the dash it is indicating that the systems control module (or the system sensor in the case of lights like low oil pressure, door open indicators etc.) has detected a fault, it then disables the system (this applies to ABS,TCS, TCM, SRS and BCM faults and others) as long as the light is on. You must now have the dealer hook up a special electronic diagnostic tool and "scan" the system for the fault code that is stored for the problem(s)

Legend of Abbreviations. ABS Antilock brake system.TCS Traction control system, TCM Transmission control module, SRS Supplemental restraint system, BCM Body control module

Oct 22, 2012 | Peugeot Cars & Trucks

2 Answers

Srs light stays on on my Honda civic


The most likely possibility is the connector for the airbag is not on securely. Check the connector first. But if the connector is connected properly then you will have to get the error codes to locate the exact problem for SRS light ON.
There is a way to pull the codes from the SRS control unit without a scan tool.
1. Turn the ignition switch OFF , and wait for ten seconds. Then connect the SCS service connector to the service check connector (2P). If you do not wait ten seconds, the SRS unit will not be completely reset and will not output DTCs.
2. Turn the ignition switch ON (II). The SRS indicator light comes on for about six seconds and goes off. Then it will indicate the DTC:
· The DTC consists of a main code and a sub-code.
· Including the most recent problem, up to three different malfunctions can be indicated.
· In case of a continuous failure, the DTC will be indicated repeatedly.
· In case of an intermittent failure, the SRS indicator light will indicate the DTC one time, and then it will stay on.
· If both a continuous and an intermittent failure occur, both DTCs will be indicated as continuous failures.
· In case the system is normal (no DTC), the SRS indicator light will stay on.
3. Read the DTC.
4. Turn the ignition switch OFF, and wait for ten seconds. Then disconnect the SCS service connector from the service check connector (2P).
The SCS Service Tool is nothing more than a jumper wire.
Thanks. you can rate this solution and show your appreciation.

May 19, 2010 | 2000 Honda Civic

1 Answer

Battery was low and put in new battery,problem SRC Light stays on how can I reset the SRC light?


I'm guessing you mean the SRS light, yes. When you have a bad battery the battery voltage can drop below 10 volts. The SRS unit detects this voltage loss and set a DTC (diagnostic trouble code) for an internal SRS unit failure. You have to erase the DTC memory. You'll need an SCS service connector tool (P/N 07PAZ-0010100) You can order one from your local honda dealer. Don't worry its not more than $10. Then you'll have to find the MES 2pin connector located in the upper right hand corner of the drivers underdash fuse box. It can be gray, green or yellow in color. 1.)Turn the ignition switch off. 2.)Unplug the MES connector from the fuse box and plug your SCS special tool into the MES connector. 3.) Turn the ignition switch on. 4.) The (red) SRS light in the dash will come on for 6 seconds and then go off. Remove the SCS tool from the MES (2P) connector within 4 sec. after the SRS light went off. 5.) The SRS light comes on again. Reconnect the SCS tool to the MES (2P) connector within 4 seconds after the SRS light came on. 6.) The SRS light goes off. Remove the SCS tool from the MES (2P) connector within 4 sec. 7.) The SRS light indicates that the memory is erased by blinking twice. 8.) Turn the ignition switch off and wait ten seconds. You may have to do this procedure a few time to get the steps correct. If this sounds to complicated I'm sure your local Honda dealer would be happy to reset the light for you for no charge. Just let them know that the battery was recently replaced and you think that the SRS light came on due to low battery voltage. -Hope this helps:)

Jan 13, 2010 | 1997 Honda Civic

2 Answers

Endeaver srs light is on after replacing battery how can I reset also the passenger seatbelt light stays on


The light is on because the SRS computer detected excessively low voltage, likely right before your battery failed/was replaced.
To clear the light you will need to take it to a dealer or a repair shop with a Mitsubishi-compatible SRS scantool.

This happens so frequently, I never charge customers for clearing SRS lights that are related to battery changes (code will be IG low voltage A and B).


Oct 03, 2009 | 2006 Mitsubishi Endeavor

2 Answers

SRS light blinking then staying on?


A flashing/steady-on SRS light indicates a problem with the SR system. Because the system contains an explosive, it is best serviced by a Saab trained and certified tech; you can be seriously hurt working on it yourself. SRS system problems can be diagnosed and fixed, and the light reset, by the dealer or trained workshop tech.

Pulling the bulb from the warning lights on the panel treats the symptom, without curing the cause - you've still got whatever fault triggered it in the first place! Definitely not recommended for a safety feature. (You wouldn't just pull the bulb if your ABS light stayed on, would you? Wouldn't you want to know why?)

The best source of info on this car is the "Bentley Bible" aka the Saab 900 Official Service Manual, costs about $40 from Amazon!

16 valve manual: http://www.amazon.com/Saab-900-Valve-Service-Manual/dp/0837603137

8 valve manual :http://www.amazon.com/Eight-Official-Service-Manual-1981-1988/dp/0837603102

Get the appropriate manual for your car and enjoy the Saab!

Hope this info helps; if it does, please give a "thumbs up"

Thanks

Saabreur

May 06, 2009 | 1991 Saab 900

1 Answer

E320 reset SRS


Hi, Joe here to help,
Without going to a dealer, you need to get a scan tool to reset the srs light. Go to an Autozone store, They will scan it and reset it free of charge.

Apr 06, 2009 | 1998 Mercedes-Benz E-Class

2 Answers

My srs light had been on


It is my understanding that the SRS is a dealer only reset because it requires a code that is proprietory to MB dealers only. Now, a garage with a good scanner (loaded with applicable MB program) may be able to reset it for cheaper than a dealer. Nonetheless, I do not believe you can reset it on your own.

A side note, as long as the SRS light is on, your airbag and/or belt tensioners may not work if you're in a collision.

Jan 15, 2009 | 1998 Mercedes-Benz C-Class

1 Answer

ABS SRS BRAKE LIGHTS


I watched a video on resetting the airbag indicator for HONDA civic. It seems a simple thing to do. have a look at the video. It may be helpful.

fr.truveo.com/How-to-Reset-SRS-Airbag-Indicator-Light/id/3118442620 - 85k -

Oct 21, 2008 | 2002 Honda CR-V

1 Answer

SRS light stays on


I have 2002 Odyssey( 59000 miles without warranty). Several months ago the SRS light stayed on after I started the car. Some people said the dealers usually charge $ 80 to 95 to reset the light. Today I sent the car to dealer. After checking the car, they told me the car is under warranty, the parts and repairing are free.

Jun 16, 2008 | 2002 Honda Odyssey

Not finding what you are looking for?
1998 Mercedes-Benz E-Class Logo

849 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercedes-Benz Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

yadayada
yadayada

Level 3 Expert

76846 Answers

Michael Contreras
Michael Contreras

Level 2 Expert

166 Answers

Are you a Mercedes-Benz Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...