Chime doesn't work, When you leave the key in the ignition and door open, no chime. When you turn the truck off with the headlight on, no chime. Also when you open the drivers door, no interior lights

chime is there so you dont lock the keys in the car

cant disable it
want it it stop remove key
or you have to shut the door with window down

You have a problem with the switch in the ignition responsible for sensing ignition key, the switch is stock on.

Key in ignition or the spring in the ignition cylinder that activates chime for "key in ignition and door open" is stuck. Fast chime is lights and slow chime is key in ignition while door open

you may have a bad switch which is located on the latch asm

Hi,the chime is triggered by the ignition and door switch a easy way to test the ignition is if ignition is on and radio on and key is turned of and key is removed from ignition the radio must go of by it self if not ignition is faulty or have dirt inside so clean out with some cleaning spray.if problem is in door the interior lights will not work like it must with opening and closing of door.hope this helps.Conraad

The headlight switch turns on the courtesy light when twisted. Tell her to make sure that the headlight switch is twisted off the indent. If this isn't it, it may be the body control module.

you need to replace the chime control and you need to have the transmisson oil filter serviced and the oil replaced and add some lucas transmisson additive to get it to stop slipping, transmissons slip over time because of sticking valves and bands that are hardened.

Section 13-09: Gauges, Warning Devices — Chime System 1996 Windstar Workshop Manual
DESCRIPTION AND OPERATION Warning Chime Systems Three distinct sounds are used to indicate the area of concern. Seat belt warning generates 1 chime per second
key-in-ignition generates 2 chimes per second
headlight on generates 4 chimes per second.
Key-In-Ignition Warning The key-in-ignition warning will sound when the driver's front door (20125) is opened with the key in the ignition switch. It will continue to sound until the key is removed, the front door is closed, the ignition switch is turned to START or the vehicle speed is over 24 kmh (15 mph).

Safety Belt Warning When the ignition switch is turned to RUN or START from OFF or ACC, the chime will sound for six seconds or until the safety belt is buckled.

• The safety belt warning indicator lamp (10C859) will activate for 60 seconds or until the driver's safety belt is fastened. Both the chime and lamp activate at the same time.

Anytime the ignition switch is released from START and returns to RUN while the safety belt lamp or chime is activated, the safety belt warning lamp or chime will remain activated until either the timing sequence has been executed, or the safety belt is buckled.

Headlamp Switch On Warning The chime will be activated if the headlamps or parking lamps are ON, the key is not in the ignition and the driver's door is opened. The chime will sound at a rate of four per second.

take fuse out

2000 Mazda 626
Note: Make SURE the battery is new.
Instructions for programming ONE keyless remote fob.
1. Open the driver’s door & leave open.
2. Insert the key in the ignition.
3. Turn the key to the on and off position 3 times.
4. Remove the key from the ignition.
5. After door open chime stops, press the door open button 3 times.
6. After chime, press any fob key twice.
7. After second chime, press any fob key twice again.
8. After third chime, press any fob key twice again.
9. Press the door open button once.
10. The car should give another acknowledgement chime.
11. Test key fob.
This DOES work. I just programmed mine successfully today, three hours ago.