Question about 2002 Chevrolet Impala

1 Answer

When battery was unhooked, the security system came on and locked out the ignition. Car wont start.

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Chevrolet Master
  • 3,854 Answers

 If you have the second ignition key's with you try it.  If not try this, it takes about 30 min to do. 30-Minute Learn Procedure 1. Turn ON the ignition, with the engine OFF. 2. Attempt to start the engine, then release the key to ON; the vehicle will not start. 3. Observe the SECURITY tell tale light. After approximately 10 minutes, the light will turn OFF. 4. Turn OFF the ignition switch, and wait 5 seconds. 5. Repeat steps 1 through 4 - two more times - for a total of 3 cycles of 10 minutes. 3x10 = 30 minutes. The vehicle is now ready to relearn the Passlock Sensor Data Code and/or passwords on the next ignition switch turn from OFF to CRANK Important: Turn the Ignition Switch OFF. The vehicle learns the Passlock Sensor Data Code and/or password on the next ignition switch transition from OFF to CRANK. You must turn the ignition OFF before attempting to start the vehicle. 6. Start the engine. The vehicle has now learned the Passlock Sensor Data Code and/or password. 7. With a scan tool, clear any DTCs if needed. History DTCs will self clear after 100 ignition cycles. Without a scan tool you may have momentary starter interruptions while history clears itself. Good luck and hope this helps, keep me posted, be glad to help.

Posted on Jul 17, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Is there an anti-lock switch on my 2005 dodge stratus


Sorry Debi , It does not work like that ! If the engine computer doesn't receive a signal from the anti-theft system , it wont let the car start . Could disable fuel , ignition , an sometimes it wont let the car crank over , There are bypass kits you can by , need to google it for your car. Other wise you'll lock up the system an it won't work .


Feb 03, 2015 | 2005 Dodge Stratus

1 Answer

Car wont start


Your passlock security system has gone bad, you need to have your ignition key lock assembly replaced ! This is very common for this type of car and can be done with a lil time and a lot of patients.

Jan 14, 2014 | 2006 Chevrolet Impala

1 Answer

2003 buick lesabre problems


unhook battery 15 min hook back on lower driver window put key on ignition just bump the engine and wait until security lit stop flashing turn key off do it again 3 times once lit goes off crank engine an should start if lit wont go away or flash while cranking you have a security issue at switch or bcm now need a scanner capable to look at the security data

Dec 22, 2013 | Cars & Trucks

1 Answer

Have new ignition lock cylinder but car wont start


The lock cylinder only lets the key turn to enable the ignition switch. The only way the lock cylinder would prevent the car from starting is if it no logger turned or it was tied into the security system. What engine do you have and what are the symptoms? Can you hear the starter turning the engine over? Have you checked for fuel and spark? Is the battery charged? Etc.

Sep 08, 2013 | 2001 Mitsubishi Eclipse

2 Answers

Hi I own A 98 Chevy Malibu, my ignition locked n i had to put a new ignition switch in, well now my cars tellin me Something Theft Service. Im wonder what I need to do? Iv unhooked battery for hours ect...


You need to reset the theft system. To do this, try to start it. It should start and die. Then after it dies and the theft light is flashing, leave the key on for 10 minutes. After 10 min, the theft light should go out. After the theft light goes out, turn off the key. Count to 5, then restart it. Then it should work.

Nov 07, 2010 | 1998 Chevrolet Malibu

1 Answer

Security light on car wont start


Yea the car is in lock down mode. Something triggered the security system, and as a result, the computer engaged the ignition kill. Disconnecting the battery alone wont solve the problem. What I would suggest is call a local Chevy dealer and ask to talk to a technician, they know the procedure and can walk you throuogh it right over the phone.

Jul 28, 2009 | 1998 Chevrolet Camaro

2 Answers

Car alarm wont let me start the car it wont stop going off


try unhooking the battery while the battery is disconnected turn the ignition on leave the ignition on while you reconnect the battery this should override the alarm

Jan 31, 2009 | 1994 Volkswagen Golf

Not finding what you are looking for?
2002 Chevrolet Impala Logo

338 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

77201 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...