SOURCE: torque specs.
connecting rod = first pass 18 ft lbs , second pass 75 degrees
main bearings = first pass 37 ft lbs , second pass 77 degrees
wow that wasn't easy to find for some reason .
SOURCE: electricall problem w/2002 V6 mazda tribute
When that light comes on, it is indicating charging system problem which could mean alternator not charging for one reason or another like loose belt, faulty alternator, or yes, bad battery or connection at battery, for example. First & easiest thing to do is check all your connections to battery, which you've probably done, and make sure they're tight & clean. Make sure belt driving alternator is good & tight, and in good shape. Now boost the vehicle to get it going & test voltage at battery, after you take cables off. My guess is in your case, the voltage will begin to go down, indicating a bad alternator, that will need to be replaced.
SOURCE: main and rod bearing torque specs
do you have a Haynes Manual or Chilton? if not check your local library, they may have one, the specs are in there
SOURCE: i'm looking for the 2000 isuzu rodeo 3.2L v6 connecting rod bearings torque specs.
1. Check the connecting rod alignment If either the bend or the twist exceeds the specified limit,the connecting rod must be replaced. Bend per 100 mm (3.937 inch) Limit: 0.15 (0.0059) Twist per 100 mm (3.937 inch) Limit: 0.20 (0.0078)
2. Measure the connecting rod thrust clearance. Use a feeler gauge to measure the thrust clearance at the large end of the connecting rod If the clearance exceeds the specified limit, the connecting rod must be replaced. Standard: 0.16 mm - 0.35 mm (0.0063 inch - 0.0138 inch) Limit: 0.40 mm (0.0157 inch)
3. Measure the oil clearance between the connecting rod and the crankshaft.
SOURCE: 2002 Mazda Tribute V6 difficult to start.
IT SOUNDS LIKE THE IAC VALE OR IDLE AIR CONTROL VALVE IS BAD, WHAT YOU CAN DO IS TAP ON THE VALVE. IT IS LOCATED ON THE INTAKE RIGHT BEHIND THE THROTTLE BODY, JUST TAP ON THE SILVER PART WITH THE BACK OF A SCREW DRIVER A COUPLE OF TIMES. THIS SHOULD UNSTICK THE VALVE AND YOUR TRIBUTE SHOULD RUN. THEN IT IS JUST A MATTER OF REPLACING THE VALVE. YOU CAN GET THEM FROM ANY AUTO PARTS HOUSE.
209 views
Usually answered in minutes!
×