Question about 1985 Chevrolet S-10

1 Answer

I have an old 1986 Chevrolt S 10 and today the driver door window fell into the door. when I brought it back on track I noticed the small window clip guide that is on the rear edge of the glass was broken causing the window not to glide properly up and down. can these small pieces be purchased?

Posted by on

  • 1 more comment 
  • mark955 Jul 16, 2009

    Just wanted to thank you on the advise for the window channel guide (I now know what it is called and have a part number) however lmc required I buy 4 at $9 a piece plus $8 shipping. I guess if I had several of these it would be worth but I just need the one, lol.

  • mark955 Jul 16, 2009

    Just wanted to thank you on the advise for the window channel guide (I now know what it is called and have a part number) however lmc required I buy 4 at $9 a piece plus $8 shipping. I guess if I had several of these it would be worth but I just need the one, lol.i

  • Greg Bernett
    Greg Bernett May 11, 2010

    go to www.lmctruck.com.....check the catalog pertaining to your year and make. They carry just about everything.

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 41 Answers

Go on line to LMC truck. hope this helps

Posted on Jul 16, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Drivers front window just FELL down into the door frame after closing the door. there is a cable that looks to be hanging loose with a white clip on the end closest to the window cable connection (to the...


A. The glass came off of the track.

B. You are going to have to remove the interior door panel and the door 'frame' and re insert the glass back into the track.

Should not be too difficult.

Sep 08, 2011 | 2004 Dodge Dakota

1 Answer

My front driver window fell off the track or the clips fell apart. I got the interior panel off have realigned the glass...... Now what, is there a diagram of the window and track so that I could just put...


you should have adjustments along the bottom of the tracks, what you need to do, is get the window inside those glides, and squeeze the slides into the edges of the glass window, that should keep it in line and on track here watch this, it might give you a better idea, this is pretty much the same as with Most door glass http://www.youtube.com/watch?v=Uu3SiUyWo-8

Jul 19, 2011 | 2001 Lincoln LS

1 Answer

How to take door panel of? window fell off of track i beleieve


there will be 2-4 screws you will need to unscrew. usually one located around inner door handle and 2 of more around arm rest and maybe some on the lower part of the door and panel. the screws are usually covered by plastic covers. you can remove these with a small flathead screw driver to find the screws. after all screw have been removed carefully pry the panel off with plastic pry bar to prevent scratching. it will literally "pop" off with clips. be careful, you dont have to use tons of force, check to make sure all screws have been removed. then the panel will hang there because its still connected to lights, switch, and door handle. remove these connectors and the panel will come right off. if the window fell off the track, it might be as simple as screwing it back on the window regulator. worse case the regulator linkage is cracked and you will need a new window regulator.

May 04, 2011 | Cadillac DTS Cars & Trucks

2 Answers

How to get the window handle off a 1986 S-10 right passenger door.


theres a tool for this at an auto part store.

i know on most chevy vehicles it is a clip that you *could* get off with a small flat screwdriver.

to locate the clip, push inward on the door panel near the window crank. rotate the crank slowly and you should see the clip. its just like a bent paperclip holding it in place. however the tool is a lot easier than a screwdriver to use, and the screwdriver may damage the door panel.

once you remove the clip, pull on the handle, you may need to pry on it a bit, around the base, as it is plastic on a splined shaft.

Aug 20, 2010 | 1986 Chevrolet S-10 Blazer

2 Answers

Power window


was the part used if so it may have been on the way out if it was new get it warranteed sounds like cables in regulator goin bad

Jul 22, 2009 | 1996 Buick Regal Olympic Gold

2 Answers

Front drivers window dropped out of track


They Should go At the Bottom Of Glass With the Attatchment Track Glued to Bottom of Window, More than Likely they are Broken or Ineficient to Hold As Needed.

Jun 03, 2009 | 1999 Pontiac Grand Am GT

1 Answer

Window off track driver side 1997 sebring


You'll need to remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. If needed, you can pull back the weather seal (can't reuse it, but it's not that important) and you will be able to access everything inside the door

Mar 23, 2009 | 1997 Chrysler Sebring

1 Answer

Window fell off the runner in the door


The door panel has screws on the bottom of the door panel. If there is carpet on the base of the door panel, the holes are hidden within the carpet.

Also, you have to remove the arm rest, typically it has 2 screws holding it to door and plastic push-in door panel clips on the sides. You can use a screw driver to help pop them out.

The door panel, when loose from door, lift up and off. Take your time so you dont break any tabs on the back side.

If the window is falling off the track, there is a small plastic tab that is mounted to glass or track; it slides in the window channel on front and rear tracks.

You can get this part at your local auto parts house, in HELP section.

Feb 16, 2009 | 1991 Chevrolet S-10

1 Answer

Power window fell down inside door


there are clips holding the door panel around the edges. to remove the clips, use a small screwdriver to feel for them, then use another one to pull the panel on the other side. Pull outward from both sides of the clip until it comes loose. Do this repeatedly, and then loosen and remove the arm rest.

Pull the window up and have a helper hold it as you work it back into the track.

Good luck.

Feb 15, 2009 | 2006 Saturn ION

4 Answers

Passenger door window off track


Is this what it lookes like? I found these at O'Rileys. I have the same problem.


gpi?id=340936745&thumbnail=true DORMAN/HELP - Window Guide Item No: 38480 $9.79 per Card checkmark.gif 1 Per Vehicle checkmark.gif 1 year limited warranty (View Details) checkmark.gif SASH KIT checkmark.gif FRONT & REAR addtowishlist.gif storebothheader.gif gi?id=52917.5142 gi?id=52924.5135 addtocart.gif

Jul 20, 2008 | 2000 Oldsmobile Alero

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

90 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7726 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...