SOURCE: location of blower resistor
The 96 LeSabre Custom and LeSabre Limited use an electronic module in place of a blower resistor.
It is under the hood on the firewall on top of the heater plenum, but below the relay rack.
They tend to short and run on high until the module burns out and then it quits.
The same part is used on many high-end GM cars from 92 to 96. The electronic module has two connectors on it. (If yours has only one plug it is a real resistor pack and not electronic.)
SOURCE: where is the heater blower motor resistor located
if you locate the blower motor the rester is the wire that atachec to blower motor fallow wire till you find a circuit bord this is ur resistor
SOURCE: 2002 Chevy Impala Blower resistor location
It is on the passenger side, you have to remove the black plastic kick plate, below the glove box, to expose it (held in place with 2 latches and 1 push pin). The resistor is in front of the blower motor ( sandwiched between the motor housing and the firewall) it is tricky to get to, i think when i changed mine i didnt replace all the screws as they were difficult to remove and even harder to replace. Good Luck, Mike
SOURCE: help with location and replacing blower motor resistor
depends on what year van..1996-2000,located in engine compartment just above right strut tower at firewall..2001-2007..located behind glove box
SOURCE: blower motor resistor location on a 1996 gmc 1500?
It is located on top of the heater box in the passenger side remove the glove box to gain acess there are two 7mm srews and a relay braket holding it in place it is a tight squeeze but can be removed with a 1/4 inch ratchet.
885 views
Usually answered in minutes!
×