Got the 2 pins/clips removed but i think its an adjusting ***** that wont let the light come out tried unscrewing just spins and spins
SOURCE: headlamp housing removal
well you need to take off the bumper to get all of these its pretty easy top of bumper has retainer bottom of bumper has retainers and 2 bolts one on each side of the front fenders and pull of then you will see headlight bolts and how to change mount panel/ Please rate my response thank you very much
SOURCE: I'm trying to remove the right rear axle from a
unbolt the pinion shaft bolt -slid the pinion shaft out -then either with help or yourself push the axle[at the flange] inward than remove "C" clip go back to axle and slid it out to take out other side same push in axle remove clip and slid out
Fig. Fig. 1: Unfasten the 2 Torx® fog light retaining screws (1), making sure not to disturb the adjusting screw (2) 
Fig. Fig. 2: Squeeze the bulb and socket retaining clip prongs inward ... 
Fig. Fig. 3: ... then pull the bulb from the rear of the fog lamp 
Fig. Fig. 4: Unfasten the fog lamp electrical connector 148 views
Usually answered in minutes!
×