Question about 2007 Toyota Corolla

1 Answer

How do you turn off the maintenance lamp after doing an oil change?

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 38 Answers

Disconnect your battery for 10-15 minutes, it should dissapear

Posted on Jul 16, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I clear a service emissions message on a 2005 Mercury Mariner with a 3.0L engine. I have performed the required maintenance procedures at both 30,9000090's and 60,000miles. Still have message.


Warning Messages The warning messages can interrupt the display until cleared or reset by the driver. The warning messages are either single cycle, non-resettable, or repetitive warning messages.
The single cycle warning messages display once whenever the ignition switch is turned to the ON position or a fault occurs in a system, and can be cleared by pressing the RESET button. The single cycle warning messages are:
  • liftgate ajar
  • liftgate glass ajar
  • service emission system
  • low brake fluid
  • service brake system
  • check left headlamp
  • check right headlamp
  • check left turn lamps
  • check right turn lamps
  • check left high beam
  • check right high beam
  • check brake lamps
  • check parking lamps
  • washer fluid low
  • check fuel cap
  • change oil soon
  • change oil now
  • low fuel
  • service 4x4
  • turn signal on

Jun 15, 2016 | Mercury Cars & Trucks

2 Answers

Reset oil light 2011 jeep gand cherokee


Turn key to on position(do not start). Hit gas pedal completely to floor 3 times. Change oil light should reset.

Jul 25, 2012 | 2011 Jeep Grand Cherokee

1 Answer

How do i reset low tire indicator on rav 4 2010, i just changed tire


The TPMS lamp should go out when the proper air pressure in all tires is detected. Too much pressure will cause it to light also. The low threshold is somewhere in the 24-27lb range, dunno what the upper limit is, but one member at R4W had 44lbs, IIRC, and the lamp wouldn't go out until he dropped it back down. Some members run 38lbs and get away with it, but I run the recommended 32lbs and don't have any problems. Out of spec tire pressure does not cause the maintenance required lamp or the MIL to light up, see page 161 of the owner's manual. The maintenance required lamp will light up every 5000 miles as a reminder to change the engine oil, see page 136 of the manual for reset instructions.

Sep 10, 2011 | 2009 Toyota RAV4

2 Answers

My maintenance light is on, and I've already changed the oil and air filter and other maintenance items. How do I reset the light?


  • With the ignition switch OFF, press and hold the select/reset button
  • Turn the ignition switch ON, and hold the button more than 10 seconds.

Apr 19, 2011 | 1999 Honda Accord

1 Answer

How do I reset the maintenance required message on


With ignition off, press and hold "SELECT" and "RESET" buttons on dash and turn ignition to the "ON" position. Continue to hold until lamp resets.

Dec 15, 2009 | 2005 Acura RL

1 Answer

Tundra 2007 - turn off "maintenance required" light


Oil Change Reminder Lamp: Service and Repair
Engine Oil Replacement Reminder Light
This light acts as a reminder to replace the engine oil.
This light will come on when the ignition key is turned to "ON" and will go off after about a few seconds.
When you drive for about 7200 km (4500 miles) after the engine oil replacement, this light illuminates for about 3 seconds and then flashes for about
12 seconds with the ignition key turned to the "ON" position. If you continue driving without replacing the engine oil, and if the distance driven
exceeds 8000 km(5000 miles), the light will come on. The light will remain on thereafter.
If the light is flashing, we recommend that you replace the engine oil at an early opportunity depending on the driving and road conditions. If the light
comes on, replace it as soon as possible.
Resetting the system
The system must be reset after the engine oil replacement. Reset the system by the following procedure:
1. Turn the ignition key to the "OFF" position with the odometer reading shown.
2. Turn the ignition key to the "ON" position while holding down the "TRIP METER" reset button.
Hold down the knob for atleast 5 seconds. The odometer indicates "000000" and the light goes off.
If the system fails to reset, the light will continue flashing.

Sep 30, 2009 | Toyota Cars & Trucks

2 Answers

Can't get change oil light to go off after having oil changed.


If you are getting an Maintenance Oil light then that is a reminder to have your oil changed...You will need to reset the mainteince light.
To reset "Maint. Notice" on the display, turn the ignition key on (do not start)...with engine off. select the "Maintenance Schedule' key by using the button to right or left. Using the button select the "Reset" key and push the "Enter" button. This should be outlined in your in owners manual as well. The oil pressure or low oil light looks like a little genie oil lamp. The Maint. Tire is the same concept, it's a reminder to check your tires pressure or do a rotation on them.
I hope this helps.

May 13, 2009 | 2008 Nissan Altima

1 Answer

Oil light comes on after oil change 1992 acura integra.


If the oil lamp itself is illuminating it is not a maintenance light that can be reset the oil pressure sending unit is detecring low oil pressure. You should have the vehicle serviced right away. The reset procedure for the maintenance indicator is as follows,with the key off depress & hold the odometer/trip button on the instrument panel turn key to run position wait 10 seconds for reset

Apr 17, 2009 | 1992 Acura Integra Hatchback

1 Answer

Maintenance light and brake lamp light what does it mean


The Maint Req Light is only a reminder light to get the Oil changed and fluids checked and what nots.. Its on a timer that must be reset.. Its no big deal if ya had it seviced recently.. Heres how to turn it off: 1) Make sure Key is Off 2) Press and Hold Mileage reset button. 3) While Holding Milelage Reset button, swicth car to run, but dont crank..4) Continue to hold button until light flashes and goes off.. then switch it off .. Start the engine to make sure it worked.. Sometimes ya gotta do it twice.. NOW.. And ur Lamp indicator.. Means you probably have a brake light or turn signal bulb out on the rear.. Get someone to help ya look for that.. Lemmie know if this works.. and Take care.. Thanx

Mar 11, 2009 | 2001 Acura 3.2TL

1 Answer

2006 toyota camry


It's basically a type of oil change life/ idiot lamp that will come on briefly after 4K just after startup and then stay on steady after 5K reached after reset procedure done after each oil change.
The explanation of it's purpose and the reset procedure should be covered in your owner's manual.
I remember resetting some Toyota maint req lamp by holding in the trip reset button ,turning on the ignition key ,the mileage indicator appears as a row of flashing segments that gradually disappear and your done.
If that doesn't work ,try releasing the trip switch momentarily,just after turning the key to run position and then redepress and hold the trip reset button in (before the cluster completes it's lamp prove out)

Aug 03, 2008 | 2006 Toyota Camry

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

100 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

75051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7726 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...