Question about 1999 Suzuki Grand Vitara

1 Answer

Trying to wire up a warn rt25 winch am now at the 12v red wire to keyed line .Suzuki says accessory wire already avail which one and where is it

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that gotĀ 5 achievements.


    An expert whose answer gotĀ voted for 20 times.


    An expert who has answered 20 questions.

  • Expert
  • 138 Answers

There should be a spot in your fuse box to connect it to. You pobably need to put a contact clip(slide on) on your wire end. Personally I like it directly to battery, fused if needed and put a kill switch under the hood.

Posted on Jul 16, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Why do accessories stay on with key off and drain my battery

My first guess is the ignition switch being faulty.
1st unplug the switch module and see if that turns the accessory lights off.
Test the ignition switch (on the switch side):
A. White , White Red wire is 12V constant
B. Blue/Red wire is accessories.
If there is continuity between these two wires when the ignition switch is OFF then replace it. $55.00 for the module.

Mar 15, 2015 | 1991 Toyota Pickup

1 Answer

I've asked this earlier but not sure if it went in I have a 2005 Suzuki Verona the radio works but no lights on the radio what would cause this issue

the dash has a dimmer, this is dash park lights
and runs all radio back lights.
so if the dial is low, its dark
if the dash cluster glows good the dimmer is ok
and the wire to the radio called, dial

on after market radios its the orange wire. not 12v, its dead.

suzuki uses different colors.
turn on parks, with a voltmeter measure 12vdc at DIAL wire.
at radio.
0v bad, 12v good, if 12v then radio lamps are Blown out.

Mar 01, 2015 | Suzuki Cars & Trucks

2 Answers

KFI winch won't spool in or out there is power to it I can hear it clicking

If your wiring a remote control to the winch or inside control,,, 4 solinoids type,,make sure the solinoids have ground on the brown wire(warn)...if you don't have a ground all it will do is click,,,even if power is applyed

Feb 19, 2015 | Cars & Trucks

1 Answer

How do i rewire a warn 12v 8000lb winch

There are lots of links on the internet to wiring diagrams; just make sure they match the winch you have
warn 8000 lb winch wiring diagram Google Search

Feb 01, 2015 | Cars & Trucks

2 Answers

My winch don't move it all?

if you can use the winch manually by pressing buttons on the winch then the problem will be in either the remote unit(Battery in back to front) or the receiver in the winch

Dec 22, 2014 | Cars & Trucks

1 Answer

Suzuki alto (2011) 7 pin trailer wiring, wires don't match the colours in the instructions

iam colour blind red/green and i suspect you are too as a lot of males are and most dont even know it ,Anyway simple way out of this is to use one of them electrical 12v test screwdriver or a multimeter like i have to ,never trust colour on wires on a motor vehicle as they use any colour in the looms depending on what been used up and what stock is available ,the assembly line cannot be held up because the colour of the wire is different .

Oct 18, 2013 | Cars & Trucks

2 Answers

My Suzuki areo fuel pump is not kicking in and making buzzing under hood even after changing pump.Already checked relay.

i see you are guessing?
did you check all engine related fuses? that be first.
with a $20 DMM volt meter , the guessing ends.
the electrics form 2 paths,
1: power
2: ground
if either are bad, the pump fails. (suzuki love to do this)

when you turn the key, the ECU/PCM , energizes
the fuel pump relay,
if you have no power to the relay the relay will be dead.
the relay then passes pump power to the pump, on the pink wire
on most suzuki's state side (no location stated)
the pink wires goes hot (12v) for 3 seconds each key on.
if not the relay is bad, or the power to it is bad or the ECU is bad.
if you lose ground to the relay , the ecu or the pump. the pump
will be dead.
using a voltmeter allows you to find this simple failure.
lets pretend the pink wire is hot.
you key on, pink goes 12v , for 3seconds but the pump is silent.
1: the pump has 2 wires , not 1.
one or the other is open.
2: if you see 12v on the pumps ground wire for 3 seconds key on.that means the pump ground is dead open.
the voltmeter will not lie to you , use it and find the problem easy.

Sep 09, 2013 | 2003 Suzuki Aerio

1 Answer

How to make 12v DC power supply to power my winch

use a 12v car battery and a small battery charger... a winch draws alot of amps when in use... so you need the battery to supply the amperage ... 12v power supplies are low amperage output supplies... so will not work (inexpensively).

Mar 23, 2013 | Cars & Trucks

Not finding what you are looking for?
1999 Suzuki Grand Vitara Logo

286 people viewed this question

Ask a Question

Usually answered in minutes!

Top Suzuki Experts


Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Boyet Soriano
Boyet Soriano

Level 2 Expert

293 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides