Question about 1996 Isuzu Rodeo

1 Answer

I need to find out what rear end is in my 1993 Isuzu Rodeo

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Isuzu Master
  • 6,982 Answers

Should be a tag on one of the bolts...If not open it up and count the ring gear teeth and pinion teeth. Divide ring # by pinion number and you should get something like 3. (something) whatever that number is is the ratio (like 2.70, 3.23 , 4.11etc)

Posted on Aug 15, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a knock in the front end of a 1993 isuzu rodeo when in 4 wheel drive, only when going up hill. I've also had problems w/ the auto locking hubs disengaging. Could this be related? How do I insta


Your problem may be as simple as a bad ball joint, CV joint, tie rod end, hub assembly or other front end part. Something is not tight anymore. Have the front end checked and go from there. GOOD LUCK FRIEND.

Nov 15, 2014 | 1993 Isuzu Rodeo

1 Answer

The code flashed 4x fast 6x in a row. I assumed the code was 44 ... Autozone said the code was the "Right rear fuel supply system circuit" ... any ideas where this is located or even if this is correct ?


1st learn to read the codes all by self. it's like USA Indian smoke signals. the delay it the end tells you it's a repeat.
most cars repeat forever , 1 code or many. (OBD1 typical)
44 is O2 lean on one engine .

No engine displacement stated, so .. very hard to answer.
for 100% sure discover what engine is in car, no guessing...
all this is in the FSM.
did you read it?
and autozoned is the last place on earth to ask. (clerks)
and this jewel !!
For Passport procedure, refer to ''Isuzu'' Rodeo.
wiki that, it is true.
and has the ISUZU ECU and ways and means.....
and quotes:
1993-95 Rodeo models W/3.2L engine, connect a jumper wire between data link connector terminals 1 and 3.
and
. On 1993-95 Rodeo models W/3.2 engine, the data link is located under the left hand side of the instrument panel. On all models, turn the ignition switch to the On position. At this point, the "Check Engine" light should flash.
all above is 1st hits with google, my lil friend.
and 2nd hit.

http://www.troublecodes.net/isuzu/iszucel/

Aug 25, 2013 | 1995 Honda Passport

1 Answer

Schematic for 1993 isuzu rodeo 3.2 l engine ignition coil pack placement


i not sure where to refill the clutch fluid as nothing is marked on my 93 isuzu rodeo. i have no pressure in my clutch any suggestions?

Jun 17, 2010 | 1993 Isuzu Rodeo

1 Answer

'93 Isuzu Rodeo, CV Joint replacement.


unbolt the tie rod end and the lower a arm and it should slide out of there

Jan 26, 2010 | 1999 Isuzu Rodeo

1 Answer

1993 Isuzu Rodeo


Have a look under the front of the transmission column/dash near the pedals. theyre usually there, tucked behind the trim. Not attached to anything, just on the end of wires. And you usually need a Tech-II diagnostics machine for any Isuzu kit, as even the likes of Snap-on won't read it.
:(

Jul 11, 2009 | 1993 Isuzu Rodeo

1 Answer

Transmission light starts flashing when coming to a stop after driving over 70 miles an hour on a 93 isuzu rodeo


hi, i also have a isuzu rodeo v6. i have the same problem and i recently discovered that the rear speed sencor was damaged. it's likated at the rear difrentail on the top. oyu should get that checked

Apr 26, 2009 | 1993 Isuzu Rodeo

1 Answer

Where is the distributor on a 1993 Isuzu Rodeo


At the opposite end of the wire where it connects to the sparkplug on a 4 cyl and V6. A 1993 V6 has a coil pack and is not called a distributor. Should be three delco coils.

Apr 11, 2009 | 1998 Isuzu Rodeo

Not finding what you are looking for?
1996 Isuzu Rodeo Logo

Related Topics:

104 people viewed this question

Ask a Question

Usually answered in minutes!

Top Isuzu Experts

yadayada
yadayada

Level 3 Expert

75117 Answers

Steve Hurc
Steve Hurc

Level 3 Expert

450 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you an Isuzu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...