Question about 1995 Oldsmobile Aurora

1 Answer

Where is the temp sensor for radiator fans. have heard a couple of different places but can't find it.

Posted by on

  • medic41 Jul 16, 2009

    thanks for the help. will look tomorrow.

  • yadayada
    yadayada May 11, 2010

    near the thermostat in the housing.

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Location of temp sensor for radiator fans on 1995 olds aurora

Posted on Aug 14, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 2006 scion xb keeps heating up already change the radiator,water pump, thermostat, fans and temp.sensor but just keeps heating up already took it to 5 different mechanics just cant find the problem


How are you determining that it's over heating ? Temp. Gauge ? Do the cooling fans turn on ? 5 different mechanics ? Did any of them hook up a scan tool , to see what the coolant temp is . Use a inferred temp tool to see what it shows for temp.

Mar 26, 2016 | Scion Cars & Trucks

1 Answer

Engine overheating 1997 buick park avenue


Hi, heard this a few times. First make sure you fans are coming on if there electrical. If they are electrical, by turning on your air conditioner usually turns on your fans automatically. There is a sensor/coolant temp sensor that tells the fans when to turn on and off by sensing the temp of the water in your radiator. some are located on the radiator. Unplug the sensor and unscrew it. Put the new one in and tighten it down put the plug back on and if that was the problem you should be good to go. PS could also be right by the large hose at the top of your radiator where it goes into the motor. either way when you remove the sensor make sure the engine is cool and the anti freeze is going to leak out so move quick.

Jan 11, 2014 | Chevrolet Cars & Trucks

2 Answers

High coolant temp


It is possible, how ever, I would check for inop coolant fan, or restricted radiator. If parts of the radiator are cool to the touch when the coolant fan has kicked in, very possibly resricted flow of coolant through the radiator.

Nov 09, 2011 | 2005 Scion xA

1 Answer

Doesnt seem to come on not sure what the problem is there a certain temp that the fan will kick on the car has sit for two yrs and just now getting it up and running


Check the temp sensor on side of radiator. It's a large brass fitting with a couple of wires coming from it. To test, get car/truck up to normal operating temp and turn AC on. AC usually triggers fan to come on. Others try bypassing sensor with leads or leads to fan directly from battery but you "chance" damaging fan. The part is called "aux fan sensor"

Mar 03, 2011 | Chevrolet Cavalier Cars & Trucks

1 Answer

Cooling fan kicks on when start of vehicle, the temperature gauge wont read a temp, just stays at "cool". fans shut off when car is turn off.


PCM is probably not getting a signal from the temp sensor, so it's kicking the fans on just in case. Check connector on sensor. If connector is OK, replace sensor. The sensor is mounted on the thermostat housing near the end of the upper radiator hose. See picks of a couple engine examples below. The part is only $11 at autozone.com, and a pic is pasted below. Let me know if you have any questions.


2.4 liter engine:

jturcotte_124.gif


3.4 liter engine:

jturcotte_125.gif

coolant temp sensor:

jturcotte_15.jpg

Nov 08, 2010 | 2001 Pontiac Grand Am SE

1 Answer

RADIATOR FANS NOT COMMING ON CHECKED POWER TO FUSES & RELAYS. FANS OPERATE WITH 12 VOLTS. REPLACED TEMP SW & THERMOSTAT. SIGESTIONS ?


Check the temp sensor in the radiator. It should be on the side with a couple wires coming to it. You can test it for power and then you can short it to see if the fans come on. If they come on then you can test the sensor by warming up the car with a continuity checker attached to the sensor to see if it closes or not.

May 12, 2010 | 1996 Chevrolet Camaro

1 Answer

1992 Geo Prizm/Corolla 1.6 L 120k mi, Fan 1 intermittent


what is the problem?
is your car overheating?

Apr 28, 2010 | 1992 Toyota Corolla

2 Answers

Engine coolent temp circuit high input. what is


More than likely the fan switch in the radiator has failed or the fan itself has failed / is not running, so the water returning from the radiator to the engine is HOT therefore you are seeing the high coolant temp input indication. Check out the operation of your radiator fan.

If the fan circuit is OK then the water temp thermostat may very well be be stuck closed.

Thanks for using FixYa.

Kelly

Mar 20, 2010 | 2002 Kia Sedona

2 Answers

2001 Oldsmobile Alero overheating


I think you started out looking in the right places. Replacing the coolant, thermostat, relay and sensor are all fairly inexpensive.

I believe you either have blockage in the system (especially if you're using tapwater), or your water pump may be failing.

I would first either take it to a radiator shop and have them flush the cooling system out thoroughly, or else pick up a chemical flush kit and do it yourself. This involves more than just drain and refill.

If this doesn't work, your next step will probably be replacing the water pump. At almost 200k miles, it's probably about due anyway.

Jun 16, 2009 | 2001 Oldsmobile Alero

1 Answer

1997 Sunfire - Radiator fan not working.


It is most likely the temp sensor. you can test sensor and all wires with an ohmmeter. On the ohm setting, place one probe on one end of wiring or sensor, and the other on the other end and there should be a reading.

May 05, 2009 | 1997 Pontiac Sunfire

Not finding what you are looking for?
1995 Oldsmobile Aurora Logo

Related Topics:

341 people viewed this question

Ask a Question

Usually answered in minutes!

Top Oldsmobile Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8140 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...