I have a 2010 Dodge Charger 3.5 sxt can anyone tell me where the transmission control Module relay is located
Disconnect the battery for a few minutes. It will reset. If it goes back to limp mode, Have the codes read, Some code reader will. Most times it has to be a scanner.
2009 dodge
for the easy solution download the pdf file
SOURCE: tranny stuck in limp mode
sounds like to prndl switch may be malfunctioning.
gear selector switch, which tells the transmission which gear it is in.
SOURCE: 2002 Dodge Caravan stuck in
Change the output speed sensor as well and clear the vehicle codes either via a scanner or disconnecting the battery.Also make sure the transmission is at the proper fluid level.
SOURCE: I have a 2001 Chrysler
Many times on Chrysler products, one or both of the speed sensors screwed into the front of the transmission will fail, and cause the tcm to go to limp mode. Also make sure you have power to the tcm. Someone with a scanner can check these for you, or the speed sensors are less than 20 bucks each, replace them both and cross your fingers. If the transmission has internal problems, the tcm will sense this and go into limp-mode as well.
SOURCE: reset dodge magnium in limp mode
Limp mode can be reset as eaily as shutting off the car and restarting it. the computer will then retest the system, if the problem is gone you will not go into limp mode. but if the problem is still evident, you will have to have it repaired before it will work properly.
3,724 views
Usually answered in minutes!
09 dodge charger RT stuck in limp mode after a relay in the trunk was pulled. Diagnostics code says lost communication w TCM module. Tried unplugging battery overnight n checked fuses... Please help
-Holly
×