SOURCE: my check engine light does not flash when i turn key before start
bulb is probably blown... you have to remove the instrument cluster to change the bulb
SOURCE: How to reset the "Check Engine Light" on my 2003 Cadillac STS
Your car is equipped with an OBD II system and requires and OBD II scan tool to reset the check engine light. There is a port under the dash that it hooks to.
A very basic tool is available from a variety of places for about $20.(i.e ebay, Harbor Freight)
SOURCE: 2007 lexus rx350 ,vsc light on and check engine light is flashing
First check and make sure your gas cap is tight, if this does not resolve the problem read below.
A vacuum hose has become disconnected, more than likely due to having your air filter replaced. The VSC and Check engine light typically don't come on until after 150-200 miles after the vacuum hose was pulled out.
The fix: on the right-hand-side of the engine compartment behind the big plastic housing that holds the air filter you will find a black rubber hose that is not connected to anything. Squeeze the finger clamp on the hose and slide the hose back onto the half inch nipple on the back of the air filter's plastic housing.
In order for the VSC and Check engine light to be turned off, you will need to open the fuse box, right-side of the engine compartment, and pull the 20 amp EFI fuse for 10 seconds. This will reset the system. The fuse location is marked on the lid of the fuse box, also I believe the EFI fuse is the only 20 amp fuse
. This will help. Thanks, please keep updated. please do rate
the solution positively .thank you for using fixya
SOURCE: Check engine light is on check engine light
Take the vehicle to Auto Zone, advanced Auto parts or o'Rieley's Auto parts and ask them to use their scanner to read the stored Code from the ECM for you.
SOURCE: How to reset the check engine light on a 2005
I have an 05 sts Cadillac. I hears this rattling sound everytime I'm driving in the 20-30 MPH frame what could tht be?
229 views
Usually answered in minutes!
×