Turn signal relay 2008 jeep location - 2008 Jeep Grand Cherokee Laredo

MAKE 100% SURE BATTERY IS GOOD AND FULLY CHARGED BEFORE BLAME IS LAID.
THEY BLINK CONSTANTLY EVEN KEY OFF?
OR STUCK BLINKING ENDLESSLY KEY ON.?
OR BOTH.>????????
AND WIGGLING THE STALK (BLINK) DOES NOT FIX IT. (Mine failed once (intermittant) and remove it and put it back and runs now or 1 full year, spare in my kit never used. sigh.
NO YOU HEARD WRONG ON RELAY, THE MIP IS SOFTWARE THAT BLINKS BLINKERS.
1995 JEEP IS NOT SAME AS 2008 OR 2010.
SO DO NOT TALK TO OTHERS ON 1995 JEEPS.
OR BELOW 2005 OR ABOVE 2010; OK?
SEE HOW GOOGLING GETS LIES.?
AND SOME OWNERS ARE CLUELESS ABOUT YEARS.
the "module left control" can not be replaced by you
and is not sold new , and most be programmed.
it is dealer only fix. and super expensive over $1000
yes the stalk is easy fix. and PnP plug and play.
why not scan the PCM first see errors. i bet.

cars are complex. I have the full service manual on this car and own one too.
first tell all that works and does not work right, in brief
engine starts?
and runs and drives:?
all other lamps work, brake, park,heads?
left blinker stuck on front and rear and the dash cluster blinking too? (3 lamps to see)>>??????????

USA answer and Car only.'
left lamps only thing failing. answer.

the front located MIP, controller has 2 sub modules
for front L/R and rear L/R
ALL LEFTS FAIL, (STUCK)
or bad stalk.
after removing mine last year, and putting it back it never failed again.

just snaps off after 1 screw.

You replaced factory bulbs with led bulbs ? There is no relay BCM - body control module does it
Turn Signal Lamps
The body control module (BCM) is responsible for controlling the turn signals and hazard lamps. When the turn signal switch is placed in either the left turn or right turn position, the BCM receives a signal from the turn signal switch. The BCM then sends an on-off voltage signal to either the left or right turn signals and their instrument panel cluster (IPC) indicator. When the hazard switch is pressed, the BCM receives a signal from the hazard switch. The BCM then will send an on-off voltage signal to all the turn signal lamps. All the turn signal lamps will flash including both IPC turn signal indicators.

Put the stock lamps back . LED's won't work .

It is probably the multi purpose switch

At this website
https://big-manuals.com/products/jeep-liberty-complete-workshop-service-repair-manual-2002-2003-2004-2005-2006-2007-2008-2009-2010-2011

I found so many manuals that aren 't here.. Also complete, this one is not, much better language, complete manual of 800+ pages, and they also have live assistance feature

Can you give us the code number? I looked at turn signal diagram for your vehicle, didn't see a relay?
Check voltage and ground for the turn signals.

turn signal relay switch. $15 part. located under driver steering colum

It is not the relay, you have a defective bulb on the side that is not.

More than likely the Flasher Relay is defective. Replace it. It has two relays and the turn signal relay is located driver's side, under dash, above kick panel, mounted in top of convenience panel. The other relay for the hazard lights is mounted in the same place only it is located in the bottom of the convenience panel.

in your vehicles owner manual, look up fuses, and flasher units or flasher relay. Fuses are normally located under the dash, but when both turn signals quit working it is usually the relay. The relay is located under the hood yours owners manual should show you the location.