Sounds like faulty ignition switch...
Sounds like faulty ignition switch...
Sounds like faulty ignition switch...
if you mean warning lighs ect? Sounds like a faulty ignition switch...
if you mean warning lighs ect? Sounds like a faulty ignition switch...
if you mean warning lighs ect? Sounds like ignition switch is not turning off fully..
if you mean warning lighs ect? Sounds like ignition switch is not turning off fully..
×
SOURCE: My running lights will not turn off unless I unhook the battery.
Subaru Outback Legacy Flashing
Q. I have a 1996 Subaru Outback Legacy AWD manual transmission. the hazards flash when I turn the car off. I tried to reset the system by pushing the little black button under the drivers' side dash but it won't reset the system. I had problems with the brakes so I did not drive it for about two months and when I tried to start the car the battery was dead.
Now the brakes are fixed but the hazards won't quit flashing and the guy who repaired the car said I needed to reset the system by pushing the little black button. And I don't know if I should have it looked at, or change the battery, or if it is something very simple I can fix by my self.
Thank you very much,
Patrick
A. Patrick, you are the third person in the last two days that has come to me with this same exact problem under the same conditions. As of now I don't have any concrete information on this, but I believe the problem to be in the alarm system.
I believe the battery being disconnected or dying does something to the Anti-theft and Alarm System module and having a Subaru dealer reset the system will correct it.
If you do this and it works, please, let me know and I will pass the information on to the others.
Added 11/7/2003
Dear Mr. Ciulla,
I read your Q&A titled "Subaru Outback Legacy Flashing". I recently had the same problem on my 1996 2.5 liter Subaru Legacy Outback and your response is correct but I can give you a little more detail on what worked for me to stop the light flashing (which occurs sometimes if the battery had been dead):
There is a black reset button under the I/P near the anti-theft module.
This also resets the key FOB so as step 2.5 you should also press the "lock" button on the key FOB before releasing the black reset button (door locks will lock/unlock one more time--do this with each key FOB you own). That's all!
The questioner in your Q&A said he tried the reset button; I suspect he either didn't turn the ignition on/off or didn't hold it in for over 20 seconds.
PS... pulling the door lock fuse will stop it temporarily if you can't get the above to work and have to take it to the dealer
Regards,
John
Photo Courtesy John Spieth ©2003
Additional Information provided courtesy of ALLDATA
SOURCE: 2000 Acura RL and 2000 Acura Integra GS ABS light on
The SRS computer needs to be reset, if you dont have a repair manual i would first suggest finding one for each car. The basic principal is that you jumper the diagnostic plug (under the glove box in the RL). The next step I believe is that you must depress the TCS button, then while holding it down you turn the key to on, continue to hold the TCS button for 15 sec and then let off. The check engine light should then blink really quick a few times and that means its reset. Im reciting this from memory so dont quote me on it. I have done it before for the RL but not the integra, id really suggest finding a repair manual though.
SOURCE: how do i remove the radion on a 200 acura rl
You cann't remove only radio you have to remove whole panel which contains radio.
There are two possible scenarios for you car radio panel
1. Your car can have Navigator, Climate Controller and Radio.
2. Your car can have Climate Controller and Radio.
You have to open whole panel.
This Panel contains some of SRS components, so have to be very careful while removing it!
Please search for "Acura RL Service Manual"
Follow this link you will be able to download it for free.
http://rapidshare.com/files/55768439/1996-2004__Acura3.5RL_Service_Manual.rar.html
PLEASE RATE!
SOURCE: Radio code for 2002 Acura RL
You need to get the serial number off the sticker attached to the radio and the nav. It will require pulling apart your dash. Call an Acura dealership with that serial number and they should be able to provide you the code. Or you can take it directly to the dealer but you will be charged labor.
SOURCE: 97 Acura 3.5 RL-dome lights, bose stereo won't turn on
Are you sure no fuse was blown? there are more than 1 fuse box (in engine and under dashboard).
185 views
Usually answered in minutes!
×