Re: I put a five speed u241 in my 02 camry will I have to...
Bad move. Put the correct model rebuilt transmission in the car , same as the original, or you are going to have numerous expensive problems to deal with.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
The resister puts current to the motor when you change
speeds on switch so if you motor only work in one or two
speeds you no the resister is bad if you put current direct to
motor make sure. It runs if ok change resister thank you and please reply
So the check engine light doesnt necessarily have anything to do with oil. The light comes on when the computer sees that something is going wrong, but it could be a hundred different things. Take the car to an autozone and have them pull the codes for the car, then report back what the code numbers are and we can go from there. Without knowing the codes, I can only guess that your engine is missing because your spark plugs are fouled ( just change them; not expensive) or you dont have enough air coming in, causing the engine to flood. It could also be a fuel hangup but this is less likely. When you visit autozone for the codes, go ahead and pick up some spark plugs and wires and change them ( you can definitely do this yourself if you have ae rachet set with an extension. If not, buy one because they really come in handy!)
Check your fuse panel under the dash on the driver side and in the engine compartment. One time I had a customer with a similar problem, I checked all the fuses, they were fine. I disconnected the battery positive cable and let stand for five minutes. I turned the key on but didn't start the vehicle, I left the key on for another five minutes for the computer to boot and run diagnostics. After the five minutes were up I started the engine, the windows worked fine. I've worked on lots of Toyota and have found their electrical systems are good, but finicky.
The problem is a gear internal failure the gear who drive the speed sensor is defect the is why you don't have speed sensor reading. There is a way you can verify that remove the speed sensor drive it with a drill check the dashboard you will see.
I would call that a good guess after five fuel pumps. Gosh, Jonah, paying for a little diagnostic testing would have saved you the cost of four fuel pumps.
You will need to replace the speedometer in the dash, there is another sensor inside which can not be replaced separately. this sensor actually sends the speed information to the computer.
most common problem is warped discs/rotors.change them as a pair with new pads....could also be....worn hub bearings,rubber bushing,track rod ends,car needs to be put on a ramp and inspected for these faults.
When you take your battery out and put a new one in all your computer controls have to be reset. You need to drive the car at 55 MPH for 2 min or so, stop, go through normal drive cycle, stop and go and then if it don't straighten out you need to clean the throttle body and the idle air control valve. Hope this helps. PHil
×