Has gearbox fault displayed on the dashboard. I have swapped out both fuse boxes, the tcm and the general control module with another car with no luck
SOURCE: x-type jaguar automatic (gear box fault)
I have a 2002 X type (2 litre. done 44000 miles), dash showed gear box problem, (red circle light up). I pulled out and turned the engine off. 5 minutes later turned the engine on. The engine running but the car would not drive either in drive or reverse. Turned the engine off again and on the car driving but not much power. The care is taken to the Jag. dealer and told is misfiring + some gear box faults. Suggesting to change some coils and see (cost about £200+). also possible need to change the gear box costing about £2500+. Please advice. Shall I go ahead with the repair? Should I part exchange.
Whenever
this warning light or any other stays on in the dash it is indicating
that the systems control module (or the system sensor in the case of
lights like low oil pressure, door open indicators etc.) has detected
a fault, it then disables the system (this applies to ABS,TCS, TCM,
SRS and BCM faults and others) as long as the light is on. You must
now have the dealer hook up a special electronic diagnostic tool and
"scan" the system for the fault code that is stored for the
problem(s) Legend
of Abbreviations. ABS Antilock brake system.TCS Traction control
system, TCM Transmission control module, SRS Supplemental restraint
system, BCM Body control module
sounds like it is in get you home because of gearbox failure if its the early box with metal sump check selector cable adjustment it critical as the J gate micro switches and the linear switch on the side of the gearbox have to be in sync with each other. on the other hand if it is the later gearbox with plastic sump, which i suspect it will be, check it has not lost some of its oil due to leaking sump, common problem! other wise check fault codes in transmission control module, any codes relating to incorrect gear ratio means internal falure most times
Whenever
this warning light or any other stays on in the dash it is indicating
that the systems control module (or the system sensor in the case of
lights like low oil pressure, door open indicators etc.) has detected
a fault, it then disables the system (this applies to ABS,TCS, TCM,
SRS and BCM faults and others) as long as the light is on. You must
now have the dealer hook up a special electronic diagnostic tool and
"scan" the system for the fault code that is stored for the
problem(s)
Legend of Abbreviations. ABS Antilock brake system.TCS Traction control system, TCM Transmission control module, SRS Supplemental restraint system, BCM Body control module
174 views
Usually answered in minutes!
The gearbox fault is displayed on the dashboard
×